Campbell Scientific, Inc.
Campbell Scientific manufactures dataloggers, data acquisition systems, and measurement and control products used worldwide in research and industry.
- 435.227.9000
- 435.227.9001
- info@campbellsci.com
- 815 W 1800 N
Logan, UT 84321-1784
United States of America
-
Product
Distance Sensors
SR50A-L
-
The SR50A is a rugged acoustic sensor for measuring the distance from the sensor to a target. It is typically used to measure snow or water depth, but it is well-suited for other uses.
-
Product
Serial Communications
-
Data cables are used to physically connect two devices so that data can be transmitted between them. For example, a data cable may be used to connect a data logger to a communication peripheral, a data logger to a computer, a computer to a communication peripheral, or one communication peripheral to another.
-
Product
Narrow-band UHF/VHF Radios
-
UHF and VHF radio products are used in narrowband RF (radio-frequency) telemetry systems. These systems consist of a radio modem and low-powered transceiver at the remote station(s), and a transceiver connected to a modem or base station at the computer site. Up to 254 stations can be interrogated over a single UHF or VHF frequency.
-
Product
CPI Communications
-
Campbell Scientific offers controller area network (CAN) peripheral interfaces (otherwise known as CPI) in our data loggers and as add-on modules. These interfaces make it easy for you to build your distributed data-acquisition network.
-
Product
Redox (ORP) Sensors
-
ORP sensors measure the oxidation-reduction potential—the tendency to gain or lose electrons when a solution comes in contact with a chemical substance. ORP measurements are used to ensure that a solution has been completely reduced or oxidized. ORP sensors are often used in tandem with pH sensors, which measure the hydrogen ion activity in a solution.
-
Product
Output and Control Peripherals
-
Output and control peripherals enable you to add channels to control other devices, such as activating external devices and increasing the number of digital output or digital input channels of a data logger. Some of these peripherals have built-in relays to control external devices, and other peripherals may require connected relays depending on what you want to control.
-
Product
Measurement Devices
-
In addition to the critical role data loggers play in a data-acquisition system, there are other types of measurement devices. Some measurement devices are used to increase the number of terminals that data loggers can use, which enables them to measure more sensors or control more external devices.
-
Product
Current Shunt Module
CURS100
-
The CURS100 converts a current signal output by a sensor or output device (e.g., 4 to 20 mA) to a voltage that can be measured by a datalogger. The 100 ohm resistor used for the current shunt allows currents up to 25 mA to be read on a 2500 mV range (CR10, CR10X, CR510, CR500) and currents up to 50 mA to be read on a 5000 mV range (CR23X, 21X, CR7, CR5000, CR9000, CR9000X).
