Product

Optical VisionInspection System

-

Nidec-Read Corporation

Nidec-Read Corporation

NIDEC-READ's inspection systems serve to locate open/leak circuits on printed substrates forming different conductor patterns within inner/outer layers. These vision inspection systems are also used to measure the shape of via holes and solder bumps and to find scratches and stains on them.

Product

Electrical and Optical & Bit-Error-Rate Testers (BERTs)

OptoBERT™

-

Optellent, Inc.

OptoBERT™ - Optellent, Inc.

The OptoBERT family of BERTs offers the best value in the industry for bit-error-ratio testing of optical and electrical components, subsystems and systems. OptoBERT family of products covers data rates from 100 Mb/s to 28.05 Gb/s.

Product

Proving Unit & Voltage Tester Kit

DLPK1

-

Di-Log

DLPK1 - Di-Log

Touch electrode for Quick testing of fused leads Optical and acoustic continuity Indication Low battery indication A portable, battery powered Proving Unit for testing Two Pole Voltage Testers up to 690V Continuity Tester for testing: Fuses, Fused test leads etc

Product

C-Band ASE Light Source

ASE5000

-

Hangzhou Huatai Optic Tech. Co., Ltd.

ASE5000 - Hangzhou Huatai Optic Tech. Co., Ltd.

Huatai ASE5000 series is C-Band ASE light source with featured with high stability and high output. It is mainly applied for testing of C-Band optical components and optical communication equipments as well as Fiber Optical Sensor etc. Huatai ASE5000 has three types of exterior structure, suitable for different customer’ requirements.

Product

Fourier Transform Optical Spectrum Analyzer, 350 - 1100 nm

OSA201C

-

Thorlabs, Inc.

OSA201C - Thorlabs, Inc.

Thorlabs' Optical Spectrum Analyzers (OSAs) perform highly accurate spectral measurements. Compatible with fiber-coupled and free-space light sources, these compact benchtop instruments suit a wide variety of applications, such as analyzing the spectrum of a telecom signal, resolving the Fabry-Perot modes of a gain chip, and identifying gas absorption lines. Many commonly available OSAs use grating-based monochromators, which have slow acquisition times due to the need to mechanically scan the grating and average out noise at each wavelength. Thorlabs' OSAs acquire the spectrum via a Fourier transform using a scanning Michelson interferometer in a push/pull configuration. This approach dramatically improves the acquisition time, enables a high-precision wavelength meter mode with 7 significant figures and ±1 part-per-million accuracy, and allows the included software to provide robust statistical analysis of the acquired spectra, as explained in the Design tab.

Product

Hand Portable Test Instruments

-

GL Communications Inc.

GL Communications Inc.

GL’s PacketExpert™ 10G provides comprehensive testing of 10 Gbps wirespeed Ethernet/IP networks. It has two 10 Gbps Optical ports, and two 10/100/1000 Mbps Electrical/Optical ports capable of BERT, Smart Loopback, RFC 2544, ExpertSAM, Record and Playback, IPLinkSim™ and PacketBroker functionalities.

Product

Optical Fibers

-

Avantes Inc.

Avantes Inc.

Avantes offers a wide range of fiber-optic cables, which can be manufactured in a variety of lengths and configurations to meet your needs.

Product

Spectrophotometer Cuvettes

-

FireflySci, Inc.

FireflySci, Inc.

Cuvettes for absorbance spectroscopy made from UV Quartz (190-2,500nm), IR Quartz (220-2,500nm), Optical Glass (340-2,500nm) and Pyrex Glass (340-2,500nm).

Product

Handheld Optical Light Source

X5002

-

Shinho Optics Limited

X5002 - Shinho Optics Limited

Optical Light Source X-5002 is new-type light source. It provides single to quad-wavelength output including 650nm visible light source and 850/1300nm wavelength for multi-mode fiber or 1310/1550 nm dual-wavelength for single mode fiber. Together with new-type power meter, they combine the accurate test solution for the optical fiber networks.

Product

Single Mode Low Loss All Optical Switch From 8x8 To 192x192 Ports

SERIES 6000

-

Polatis, Inc.

SERIES 6000 - Polatis, Inc.

The Polatis Series 6000 Network Optical Switch is a high-performance, fully non-blocking all-optical matrix switch available in sizes from 8x8 up to 192x192. It is designed to meet the highest performance and reliability needs of the most demanding applications with exceptionally low optical loss, compact size, low power requirements and fast switching speeds. With support of Software-Defined Networks (SDNs) via an embedded NETCONF and RESTCONF control interfaces, the Series 6000 enables extremely low latency for time-critical traffic required for new virtual cloud services in hybrid packet-optical data centers. The Series 6000 is based on Polatis’ patented DirectLight® optical switching technology that has been proven in the most challenging data center, telecom and defense applications and is also used by major network equipment manufacturers to automate testing of optical components and subsystems.

Product

Optical Testers

-

Fitech Ltd.

Fitech Ltd.

Instruments used to analyze, certify, and troubleshoot fiber optic networks and components, ensuring they meet performance standards by measuring light power, detecting faults (breaks, bends, dirt), and verifying signal integrity, using tools like OTDRs, Power Meters, and Visual Fault Locators.

Product

PXIe-SMN Interface Card

-

Avionics Interface Technologies

Avionics Interface Technologies

2.125 Gbps Optical loop networkSingle-mode and Multi-mode optical interfaces supportedUp to 256 Shared Memory Network nodes supportedUp to 200 MByte/sec sustained data ratesMaximum 500 nS latency between nodesNetwork interrupts supportedSoftware Drivers available for Windows (7/8), Linux, LabVIEW Real-Time, and VxWorks

Product

Infrared Interferometers

-

Zygo Corporation

Zygo Corporation

Optical imaging applications are broad and varied. Testing at a system's design wavelength is critical for development, final alignment and qualification.

Product

PCI CONET Controller

A2818

-

CAEN S.p.A.

A2818 - CAEN S.p.A.

The Mod. A2818 is a 32-bit 33 MHz PCI card, which allows the control, through a standard PC, of up to 8 CAEN Optical Slave Cards (CAEN VME Bridge or Digitizers). The communication protocols used are the CONET1 or the new CONET2 (A dedicated firmware for the desired protocol must be installed on the board).

Product

Mini Fiber Optical Monitoring Alarm System

Mini FOMA

-

Radiantech, Inc.

Mini FOMA - Radiantech, Inc.

Mini FOMA (Fiber Optical Monitoring Alarm System) is integrated RTU (Remote Test Unit) 、Center Monitoring Server and its management software to achieve integrated operation、remote management、unattended monitor、periodic fiber scan、predictive analysis and support the instant fiber with status information and alarm warning, accurate of long-term fiber data record.

Product

Indoor Mini Optical Receiver

SR1020

-

Hangzhou Softel Optic Co., Ltd.

SR1020 - Hangzhou Softel Optic Co., Ltd.

Designed for FTTH(Fiber To The Home) networks ●Excellent linearity and flatness●Wide range of optical input power ●Single-mode fiber high return loss ●Using GaAs amplifier active devices ●Ultra low noise technology ●Smaller size and easier install ●Red-LED for power indication ●Color-LED for optical power indication●Double color LED for optical power indication (Non-lighted: optical power<-10dBm, Green:-10dBm+3dBm)

Product

Optical Time Domain Reflectometer

3000 Series

-

Shanghai Baudcom Communication Device Co.,Ltd.

3000 Series - Shanghai Baudcom Communication Device Co.,Ltd.

BAUDCOM 3000 series Optical Time Domain Reflectometer (OTDR) is anintelligent meter of a new generation for the detection of fiber communicationssystems. With the popularization of optical network construction in cities andcountrysides, the measurement of optical network becomes short and disperse; The3000 series is specially designed for that kind of application. It’s economic,having outstanding performance.The ODTR is manufactured with patience and carefulness, following thenational standards to combine the rich experience and modern technology, subjectto stringent mechanical, electronic and optical testing and quality assurance;in the other way, the new design makes ODTR more smart and compact andmulti-purpose.

Product

Polymer Optical Fiber (POF) Contacts

-

Virginia Panel Corporation

Virginia Panel Corporation

VPC offers Polymer Optical Fiber (POF) contacts in the form of patchcords. POF supports low-speed, short distance applications.

Product

Optical Laser Source

SAT-3E

-

Shaanxi Aitelong Technology Co., Ltd

SAT-3E - Shaanxi Aitelong Technology Co., Ltd

SAT-3E optical laser source fits to optical power meter to measure fiber loss and evaluate transmission performance. They are indispensable tool for optical network installation, trouble shooting, maintenance and widely used in LAN, WAN, CATV, remote optical network, etc.

Product

Optical Test Lab

-

Dayton T. Brown, Inc.

Dayton T. Brown, Inc.

Every object affects or interprets light differently, so appropriate and accurate measurements are needed in order to determine how much light is being produced by a source or cast upon an object. This can be measured with respect to power requirements, as well as how the human eye interprets that light.

Product

16/8 Channel 14 bit 500 MS/s Digitizer

V1730 / V1730S

-

CAEN S.p.A.

V1730 / V1730S - CAEN S.p.A.

The V1730S comes in a VME form factor, with 16/8 input channels. The communication to and from the board is provided through the VMEBus and Optical Link interfaces.

Product

Optical Communication Parts

-

Adamant Namiki Precision Jewel Co Ltd.

Adamant Namiki Precision Jewel Co Ltd.

Zirconia ferrule sleeve is an important part in optical fiber communication and is the basic product of our optical communication parts. We have developed an optical communication parts part of hasad developed based on grinding and bearings. Offer Optimum Performance And Quality For Each Type Of Optical Fiber, Optical Connector And Optical Device. We Also Offer Pin Gauges And Ring Gauges For Measuring Precise Dimensions Indispensable To Our Quality Assurance . These Gauges Have Little Wear, Good Compatibility With Ferrules And Sleeves, Zirconia , sapphire and cemented carbide are used as materials.Various Optical Connectors And Adapters Using Ferrules And Sleeves, Follow The Long History FC And SC Connectors, MU , LC Connectors Are Also Available. In Particular, LC Connectors Are Deployed In A Wide Lineup With Adapters. In The Field Of Optical Devices, We Provide Codes Master , Various Patch Cords , Conversion Adapters That Connect Different Types Of Connectors, Attenuators And Terminators That Provide Stable Characteristics, Which Are Manufactured Using The Ferrule Quality Of Our Own Manufactured Parts We Will. We Also Offer Parts For Optical Devices SuchAs Fiber Array Used For Connection Of PLC, AWG And Others. In The Field Of Optical Modules, SC And LC Receptacles , Fiber Stub, Pigtail Fiber And Other Optical Module Parts, And Now We Have Provided TOSA, ROSA And Other Optical Module Manufacturing Consignment Services. We Also Deal With Various Lensed Fibers Which Processed Fiber Tip With High Precision . In Addition, We Also Flexibly Deal With Precision Component Processing Used In Optical Communication Field, Special Specification Ferrule, Sleeve Etc. Please Contact Us.

Product

Optical Comparator

Golden Units

-

Dana Design

Golden Units - Dana Design

The use of the Golden Units is the easiest way to ensure that your production devices are inspected to the accuracy you expect. The use of an optical comparator brings into play the subjectivity of the operator and errors induced by bending leads on real parts during handling by the operator.