-
product
Car Oxygen Sensor
KS60044
Konstar Electric Industrial Co., Ltd
An oxygen sensor, also known as a lambda sensor, continually detects the oxygen content in the exhaust gases of an engine. The oxygen sensor output signal informs the vehicle's ECU (Electronic Control Unit) whether the AFR (Air-Fuel Ratio) is lean or rich. Based on this, the ECU adjusts the amount of fuel injected into the engine to achieve an optimal AFR.
-
-
product
Car Battery Checker
BT-300
Konstar Electric Industrial Co., Ltd
Battery tester can test the car battery whether is ok, if the battery is bad or need charge or bad, the tester will give you the right check result, then can do the right plan for the battery before work.
-
product
LED Car Audio Meters
OM-1
Some might consider the OM-1 to be over-built; we think it is just right. Some features of the design are:*Mil spec FR4 circuit board*Regulated power supply*Constant LED current and brightness regardless of battery voltage (won’t dim with your beat)*20 bright surface mount LEDs*Wide operating voltage range for vehicles with modified electrical systems
-
product
6-24V Car Circuit Tester
1951
Peaceful Thriving Enterprise Co Ltd
Check on 6-24V system. The alligator (earth) clip is suitable for earth and the tip of the contact probe is placed onto the part to be used. If current is present the test light will glow.
-
product
Car Accessories Material Burning Tester
ZRS-4H
• Test Gas Source: Gas or Liquefied Petroleum Gas (Suggestion: Use good quality gas if possible) • Burner inner diameter: ￠9.5±0.5mm, about 100mm long with air adjusting hole • Height of flame: Can be adjusted from 20 mm to 100 mm according to the standard requirement • Applying time of flame: Burning time can be adjusted from 0 to 99 minutes 99 seconds • Test process: Automatic control • Inner volume: 0.05m³ • Material: Stainless steel or iron plate spray • Power: AC 220V; 50Hz/5A
-
product
Car in Cold Temperature Shock Chamber
Dongguan City Simplewell Technology Co. Ltd.
Car in Cold Temperature Shock Chamber by Simplewell
-
product
6-24V Car Circuit Tester
1952
Peaceful Thriving Enterprise Co Ltd
Check on 6-24V system. The alligator (earth) clip is suitable for earth and the tip of the contact probe is placed onto the part to be used. If current is present the test light will glow.
-
product
LED Car Audio Meters
VM-1 (For 12V systems)
*White LED Backlight*Mil spec FR4 circuit board*Regulated power supply*Constant LED current and brightness regardless of battery voltage (won’t dim with your beat)*20 bright surface mount LEDs*Designed for 12 Volt Systems
-
product
Durometer for RC Car Tires
52-79980
Longacre Racing Products, Inc.
RC car tires are much softer than full size car tires. This special durometer is calibrated to read RC tires correctly. Easy to use, quick and accurate.
-
product
6-24V Car Circuit Tester
1954
Peaceful Thriving Enterprise Co Ltd
Check on 6-24V system. The alligator (earth) clip is suitable earth and the tip of the contact probe is placed onto the part to be used. If current is present the test light will glow.
-
product
Real Car Transient Test System
RealCar Simulation Bench
This system is suitable for transient test of actual vehicle in combination with the real-time model calculation by the measurement/control panel and low inertial motor. By replacing the wheel of the actual vehicle with the tire type bearing, the axle shaft is taken out to the outside of the vehicle and connected to the low inertia motor. It can be reproduced the sliding motion which the chassis dynamometer cannot be realized. Also, since the longitudinal force is not occurred in the vehicle, the vehicle restraint can be simplified and the behavior such as shift shock can be reproduced on the bench.
-
product
Retractable Cable With Magnet Adsorption
3701
Peaceful Thriving Enterprise Co Ltd
*2 x 6m retractable test leads.*Used as an extension cord for cars, trailers, boats and more.*Optional accessory included alligator clips, test probes and banana plugs.*The tester can be used with any multi meter or device equipped with banana jack connectors.*Embedd A Magnet on the back to fix on suitable metal sheet of cars easily.
-
product
RF One Power Meter
The RF One Power Meter is a very versatile instrument covering both analog and digital carriers in an extremely wide frequency range from 30MHz to 6GHz. The RF One is capable of measuring forward and reflected power in the range of a few milliwatts up to 500 Watts. The internal operating system controls measurement, display and the I/Os allowing serial communication to PC, USB to memory stick and USB Serial communication. The I/O options are used to write plots to either memory sticks or to a connected PC, the I/Os can also be used to operate the instrument, giving commands and receiving data. For documentation reference the instrument has a real time clock. Multilayer menus are used to setup and control the operation of parameters. The RF One instrument is small, handy and light weight battery operated with more than 3 hours of continuous operation on the internal NiMh cells. Feature with XML data handling and application viewer is included. Accessory kit with soft carrying bag, car charger and coax adapters for standard types.
-
product
Automotive
Automobiles are relying on a growing number of wireless technologies as the connected car becomes a reality. Many vehicles already support LTE data connections and operate as small Wi-Fi hotspots while vehicle-to-vehicle (V2V) and vehicle-to-infrastructure (V2X) communications are expected to become a reality over the next few years. With the advent of connected vehicles, the role played by RF communications within the vehicle and V2V and V2X communication has increased dramatically.
-
product
Color Tests
LED-Check
LEDs are the standard light source in car cockpits. It is not sufficient to find out if a LED shines, or not. The LED needs to have precisely the specified brightness and color to fulfil its function.The FiberVision LED-Check system tests up to 250 LEDs in less than one second.
-
product
Towing Dynamometer
RSL-10K
RSL-10K Towing Dynamometer is designed for testing today’s full-sized cars, SUVs and light trucks. The RSL-10K is built with an all-aluminum frame, sheet metal body and rides on an independent, coil spring suspension. The RSL 10K uses an eddy current absorber for power absorption. The power is provided by batteries and an alternator.
-
product
E Bend Waveguide
E-plane waveguide bends are sections of high-precision crafted waveguides and shaped to either 30º, 45º ,60º, or 90º angles for e-plane needs. It directs the radio frequency beam and “bends” the signal to go the direction you want. Think of it like Tokyo drifting around a corner in your car. Precision MMW will help you with the highest quality E bend waveguides. We are a millimeter wave spectrum manufacturer of various active and passive mmWave products and sub-system engineering.View more E Bend Waveguide
-
product
Test Bench for AC Compressors
MS111
The test bench is intended to test AC compressors of wide range of vehicles on R134a refrigerant. The equipment detects failures of a vehicle unit before its mounting in a car, whether it is a remanufactured, repaired unit or a used one. In the process of testing, data is shown on LCD display. It gives an opportunity to follow testing results realtime, save and/or print them due to software special features. Unit fixation mechanism is very flexible: a compressor can be easily fixed, no matter what kind of fittings it has. Units with electromagnetic clutch or electromagnetic valve can be tested both separately and simultaneously. Peculiar features of electric commutation are considered, connection polarity is identified automatically, indicator on the control panel indicates on presence of a diode in a circuit.
-
product
PLS Software Suite
Real-time point cloud via 4G or built-in long range wifi – now with patent pending real-time RGB colorizationVehicle agnostic (designed for multi-rotors, car, bicycle, backpack, and more)Analyze LiDAR penetration and measure positions, paths and cross sections – while scanningSDK available for real-time point cloud analytics
-
product
Full-Automatic Testing Machine for Hard Board Car
U690HDIR
1. CCD automatic alignment, the alignment accuracy reaches ± 15μm2. Support layout test, displacement function3. Automatic marking function
-
product
Brake Test Systems
GIANT Evo
The GIANT Evo is an extension of the well-proven GIANT product portfolio and has been developed to suit the growing demands and needs of the current and future brake markets. Covering the market segments from mini and compact cars to medium sized SUVs as well as large vehicles, this brake testing machine forms the base of HORIBA’s inertia brake dynamometers portfolio. All components are specifically tailored to the needs of the passenger car market segment.
-
product
Air Conditioning Valve Tester
ACT-2
Today, almost every car is equipped with an air conditioning system. AC systems have become an active factor in driving safety, and can be considered as safety technology. Air conditioning system, like others, requires periodic maintenance and skillful diagnosis in case of malfunction. While design and operation of older systems is generally known, new solutions require more knowledge.
-
product
SPL Calibrator -124 dBSPL @ 1 kHz
511ES124
The 511ES124 is designed to provide 124 dBSPL at 1 kHz to meet the needs of the low sensitivity microphones found in many high SPL measurement applications. The microphones used in Car Stereo competitions like dB Drag racing, IASCA, and USAC have had their sensitivities reduced to the point where 94 dBSPL may no longer be adequate for calibration.
-
product
Battery Testing Chambers
We supply a variety of test chambers for testing small battery cells to large lithium ion battery packs. Battery test chambers are supplied to a variety of industries including telecommunications, computer and automotive. With the goal of reducing automobile emissions and the development of electric vehicles, the need for lithium ion battery testing is even more critical. Our proven experience provides the most cost-effective solutions. Each test chamber is built according to specific test requirements and may be interfaced with battery cyclers, control & monitoring data acquisitions systems and other test equipment for a complete integrated test solution. All environmental chambers are designed with safety in mind. A variety of safety features are provided for reliability and abuse testing of batteries. These features may be incorporated into CSZ test chambers and tailored to the various hazard levels of EUCAR (European Council for Automotive R&D), a consortium of European car manufacturers. To better assess the hazard potential of tests, EUCAR has investigated hazardous situations and divided them into eight risk classes. The development of the safety equipment of our battery test systems is also based on this classification. For each hazard level, we recommend specific safety options that can be included with your chamber to meet your specifications to safety test your product. Together with our customers, we assess which safety devices are necessary for the respective test chambers.
-
product
Cellular Antennas
Our portfolio of cellular antennas includes solutions for emerging technologies such as 5G, as well as coverage of older networks such as 2G, 3G, 4G, and CBRS. A wide range of internal/embedded antennas and externally mounted antennas are available to suit a wide range of customer requirements. Our cellular antennas are available for regions, frequencies, and standards, with products ranging from 617 - 7125 MHz. Choose from a variety of antenna types, product length, width, and height, and wireless application. Custom antenna developments are regularly undertaken to meet specific customer requirements. Our cellular antenna portfolio includes products manufactured by TE Connectivity, Laird Connectivity External Antennas, and Hirschmann Car Communications.
-
product
Thermometer Clock
3331
Peaceful Thriving Enterprise Co Ltd
*Clock Display.*Easily Installed.*℃/℉ Selectable*Indoor/Outdoor Temperature Display and Backlight.*Easily fitted to car dash or wall by included 3M scotch magic tape.
-
product
OD And Light Transmittance Meter
Shenzhen Linshang Technology Co., Ltd.
A series of light transmittance testing instruments provided by Linshang Technology include a light transmittance meter LS116 with a parallel light path design, a optical densitometer LS117 with a diffuse transmission principle, and a split type light transmittance meter LS110 that measures the car front windshield. The light sources used in these light transmittance meters comply with the CIE photopic luminosity function.
-
product
CTEK Multi US 7002 Battery Charger
56-353
The MULTI US 7002 is the ideal battery charger for your caravan, car and boat. The battery charger is well suited for all-year use. Thanks to its SUPPLY mode the battery charger provides power even without a battery. The SUPPLY mode is indispensable when changing the battery as you avoid losing complicated program settings.Perfect for vintage car, boats with one battery, boats with start & service battery, boats with start & service bank, scooter, motorcycle, Quad/ATV, lawnmower, caravan, and tractor.Includes two interchangeable connection leads, one with clamps, and one with eyelet terminals.
-
product
Freeze Alert In/Out Thermometer With Backlight
3333
Peaceful Thriving Enterprise Co Ltd
*Backlight.*℃ / ℉ Selectable.*With CE Approval.*Indoor / Outdoor Temperature Display.*Easily fitted to car dash or wall by 3M scotch Magic tape.
