Network Monitoring
Observe and analyze network communications to detect abnormal activity.
See Also: Test Access Points, SNMP
-
Product
Managed Media Converters
-
Extend connections over fiber with additional network monitoring, fault detection and remote configuration.
-
Product
PSCapture Network Monitor and Recorder
-
PacketStorm Communications, Inc.
Captures network characteristicsEasy-to-use GUIData compatible with emulatorsReal time graphsReal time histogramsUp to sixteen simultaneous capturesData saved & recalled in three formatsHighlight & save capability
-
Product
Mobile Network Monitoring
NetMobility®
-
The next generation of mobile network monitoring is here. With NIKSUN NetMobility® you gain unparalleled insights into subscriber behavior, carrier services, network health, cyber threats, and application performance to meet a wide range of service provider needs - Performance, Security, Operations, Management, and Planning.
-
Product
IP / Ethernet Testers
-
Anritsu's powerful Ethernet/IP network data analyzers incorporate the dual functionality of wire speed performance analysis and network monitoring in the same instrument. Multiple protocols can be decoded and displayed for captured Ethernet, SONET, or SDH frames at full wire speed up to 100 Gbps, augmented by an optional Decode Module and Expert Analysis Module.
-
Product
Optical Channel Monitor
-
Optoplex Optical channel monitor (OCM) uses proprietary thin-film interference filter technology combined with a micro-actuator and high-speed electronics. Optical channel monitor is used to measure critical information data on optical transmission signals in DWDM networks for monitoring signal dynamics, determining system functionality, identifying performance change, and providing feedback for controling network elements so as to optimize operational performance. In particular, Optoplex Optical channel monitor can automatically scan the C-, L- or C+L-band wavelength range and precisely measure channel wavelength, power, and optical signal-to-noise ratio (OSNR). See the following schematic diagram for OCM working principle.
-
Product
Log Management And Network Traffic Monitor
-
Derive Security Intelligence out of Network with Event Log Analyzer and Network Bandwidth Monitoring
-
Product
GL Products Online & Interactive Demos
-
*NetSurveyorWeb™ is a centralized VoIP network monitoring system. A number of GL's PacketScan™ probes and/or,PacketProbes™ are deployed in remote locations across the network to passively monitor VoIP traffic. Whenever a monitored call completes, the scan/probe calculates a variety of quality metrics (MOS, loss, delay, jitter, etc) and sends the metrics to the central Oracle database for storage.**The PacketScan™ is a feature-robust Windows® based software tool that captures and monitors live IP traffic. In the VoIP world, it can monitor and measure SIP, H323, Megaco, MGCP, T.38 and video calls. In addition to quality metricsPacketScan™ also captures signaling information and sends that to the NetSurveyorWeb™ database as well.**GL's PacketProbe™ is an advanced CPE(Customer Premises Equipment) based VoIP monitoring reporting and diagnostic appliance, stemming from GL's suite of market leading voice analysis tools.
-
Product
Enterprise Class Network Analysis
Capsa
-
Capsa network analyzer makes it easy to rapidly detect, isolate and resolve network problems. It captures all data transmitted over the network and provides a wide range of analysis statistics in an intuitive and graphic way. With Capsa's network traffic monitor feature, we can quickly identify network bottleneck and detect network abnormities.
-
Product
Advanced High Speed Test Probe
SQprobe
-
SQprobe® is an advanced high speed probe designed for emerging software defined (SDN) and virtualized networks. It monitors IP based voice, video, audio and data streams at Gigabit rates, performing deep packet inspection (DPI) and providing accurate and detailed real time service quality metrics, usage and demographic data.
-
Product
Network Performance Monitor
-
*Multi-vendor network monitoring*Network Insights for deeper visibility*Intelligent maps*NetPath and PerfStack for easy troubleshooting*Smarter scalability for large environments*Advanced alerting
-
Product
Optical Fiber 32×1 Switch
OFSW - 32 × 1
-
Hangzhou Huatai Optic Tech. Co., Ltd.
OFSW- 32×1 is a 32×1 prism optical switch. It can support 32 optical fibers input and 1 fiber output, channel switch. Wide operating wavelength range, low insertion loss and speedy switching rate, can use network trends configuration, network monitor and lab application.
-
Product
Optical Fiber 1×32 Switch
OFSW - 1 × 32
-
Hangzhou Huatai Optic Tech. Co., Ltd.
OFSW- 1×32 is a 1×32 prism optical switch. It can support 1 optical fibers input and 32 fiber output, channel switch. Wide operating wavelength range, low insertion loss and speedy switching rate, can use network trends configuration, network monitor and lab application.
-
Product
Software
Delphin Data Center
-
The Delphin Data Center is a centralised measurement data management system that networks, centrally stores, monitors and analyses the measurement data of systems, machines and test stands. The measurement data is archived in a valid and traceable way and is able to access it within seconds, whether on a network, via PC or mobile via smartphone or tablet.
-
Product
Fax/ Modem Testing
-
To successfully deploy fax services requires extensive network design, test and traffic engineering. Test equipment can prove valuable in this process, if it can: Generate and receive fax signals in bulk over wired and wireless networks, monitor and distinguish fax signals in real time for traffic engineering and network design purposes, and analyze fax signals after capture for troubleshooting failed or poorly handled calls.
-
Product
Complete Network Monitoring
TiSCADA
-
After years of advanced Research, laboratory and on-field tests, Techimp has developed powerful and effective tools which can help asset managers to take critical decisions and manage power plants in a cost saving ways. Ti-SCADA implements a Real Time condition control of your asset, through a powerful Human Machine Interface (HMI) fully configurable, web based, displaying graphs, charts, trends, KPI, historical data, alarms and customizable reports. Ti-SCADA is a fundamental component of the new generation of Techimp on line condition monitoring systems. Ti-SCADA is designed as a Service Oriented Architecture (SOA) based on interoperability standard for industrial automation - OPC-UA - allowing high performance asset management solutions, tailored on customer needs, to be implemented.
-
Product
Software
-
Interact with multiple networks, perform diagnostics, node/ECU simulation, data acquisition, automated testing, memory edit or calibration, and vehicle network bus monitoring.
-
Product
Optical Fiber 1×4 Switch
OFSW - 1 × 4
-
Hangzhou Huatai Optic Tech. Co., Ltd.
OFSW- 1×4 is a 1×4 prism optical switch. It can support 1 optical fibers input and 4 fiber output, channel switch. Wide operating wavelength range, low insertion loss and speedy switching rate, can use network trends configuration, network monitor and lab application.
-
Product
QoS Monitor
Arptel Monit
-
The Arptel Monit is a cost-effective and flexible network monitor solution for telcos. The Arptel Monit is a powerful tool for monitor QoS on live international and domestic traffic.
-
Product
Optical Fiber 1×25 Switch
OFSW - 1 × 25
-
Hangzhou Huatai Optic Tech. Co., Ltd.
OFSW- 1×25 is a 1×25 prism optical switch. It can support 1 optical fibers input and 25 fiber output, channel switch. Wide operating wavelength range, low insertion loss and speedy switching rate, can use network trends configuration, network monitor and lab application.
-
Product
Hardware Enabled SaaS Solution Quantifying Methane Emissions
MethaneTrack™
-
NevadaNano’s MethaneTrack™ is a low cost network of rugged monitoring points to measure methane emissions and report leak location and size to the operator. Utilizing an Industrial IoT (IIoT) network to detect methane in the air, MethaneTrack™ detects fugitive and operational emissions from a site and immediately alerts the operator of the location and volume of the emissions, facilitating rapid response and repair. Autonomous, continuous monitoring enables up to 99% reduction in emissions while reducing operational costs and boosting profits.
-
Product
Network Performance Monitoring & Diagnostics
Observer
-
VIAVI Observer® is a comprehensive network performance monitoring and diagnostics (NPMD) solution developed to ensure peak IT service performance both on-premises and within a cloud or hybrid IT environment. Cloud-based service deployments, complex multi-tier applications, remote employees, and customer expectations of anytime, anywhere availability of IT services can challenge performance monitoring visibility.
-
Product
Very High Density Fiber Tap
Flex Tap VHD
-
Keysight Network Applications and Security
Flex Tap VHD is a modular, very high density fiber tap available, offering up to 36 taps in a 19 inch 1U space, to reduce IT costs while helping ensure availability of security and business critical applications. Network taps (test access points) are a key part of the access layer of a visibility architecture because they are an unobtrusive way to capture monitoring data. They offer comprehensive traffic visibility for network monitoring and security tools that do not introduce points of failure in the network. Ixia has a large variety of network taps on the market today, offering speeds from 1Gbps to 100Gbps, single and multi-mode, as well as different fiber types and support for Cisco bidirectional (BiDi) transceivers.
-
Product
Optical Channel Monitors
-
DiCon's Optical Channel Monitor is an advancedoptical subsystem, with integrated tunable optical filter, that automatically scans a DWDM network and reports the power of each channel. Network performance is monitored and reported in real time. Feedback from the Optical Channel Monitor can be used to optimize optical power levels, identify performance drift, and verify system functionality. An optional integrated optical switch allows up to 12 separate input ports to be monitored sequentially.
-
Product
Optical Fiber 16×1 Switch
OFSW - 16 × 1
-
Hangzhou Huatai Optic Tech. Co., Ltd.
OFSW- 16×1 is a 16×1 prism optical switch. It can support 16 optical fibers input and 1 fiber output, channel switch. Wide operating wavelength range, low insertion loss and speedy switching rate, can use network trends configuration, network monitor and lab application.
-
Product
Ethernet Tester
GAOTek Gigabit
-
GAOTek Gigabit Ethernet Tester is a handheld tester for installation, commissioning and maintenance of 10M/100M/1000M ethernet networks. By combining network performance test & monitoring, data packet sniffing, traffic generation, cable test and BER test in one unit. It is widely used in testing BER of layer 1, layer 2, layer 3, and full-featured RFC-2544 and Y.1564 testing. It can help the front-line field technicians analyze the network quality and locate the fault rapidly.
-
Product
Optical Switches
-
This latest technology platform presents the best value in terms of size, form factor, durability, and cost. The design of our MEMS optical switch centers on DiCon's proprietary dual-axes tilting MEMS mirror and is expandable up to a 1x36 switch configuration. Large fan-out 1xN optical switches and non-blocking fan-out/fan-in NxM matrix optical switches are built by cascading multiple of these 1xN switches. The MEMS 1xN fiber optic switch passes the stringent Telcordia GR-1221 qualification and is vastly deployed in today’s optical communication networks. With a lifetime of over a billion cycles, the durability of this MEMS device makes it a perfect choice for optical network monitoring applications that require frequent switching.
-
Product
Advanced Monitoring Probe
DVB-C QAM
-
Combined with a Network Monitoring System or not, the EdgeProbe Advanced provides a powerful broadcast network alert & diagnosis tool allowing DTV network operators to monitor global trends and anticipate potential failures.EdgeProbe Advanced is able to monitor DVB-C and DVB-C2 signals at transmitter outputs, through its RF inputs (up to 4 in 1RU), as well as at modulator input and at Head-End/distribution links, through its ASI and IP inputs.
-
Product
Network Infrastructure Monitoring
NetPoller™
-
Network infrastructure monitoring plays a vital role in improving business outcomes for today’s challenging and complex IT environments where day to day performance and availability are critical factors.
-
Product
End-to-End Network Monitoring
OSIX
-
Network monitoring with tracing and troubleshooting capabilities to achieve first-class customer experience and to proactively prevent network and service quality degradation. OSIX Monitoring enables Communication Service Providers (CSPs) to detect and resolve network issues or poor performance before end-customers are affected.
-
Product
SmartAnalytics
-
For accurate network engineering, benchmarking, monitoring and optimization, it is necessary to process complex data and produce clear and easy-to-understand intelligence on a network to make better decisions.
