Line Impedance Stabilization Network
Line Impedance Stabilization Network
See Also: Line Impedance, LISN
-
Product
MPLS-TP networks and TDM / SDH / PDH
-
CXR offers a full range of multi-service equipment for TDM / SDH / PDH and their evolution over Ethernet and IP networks via gateways TDM over IP.MPLS-TP Carrier Ethernet solutions and provide CE2.0 modes connected on packet transport rsaux guaranteeing quality of service similar to TDM technologies.
-
Product
Voltage Probes (Power Line Interference Probe)
Emissions
-
The Voltage Probe requirement is covered by our PLIP (Power Line Interference Probe). This fully meets the requirements of CISPR16, but has additional features: Fully galvanic isolation between input and output (>1kV), for the safety of operator and analyser. hrouded safety clips for attachment to the line to be measured. Filtered frequency response matched to Band A and B. Current limiting on the output. Visual indication of high voltage input
-
Product
Vector Network Analyzer Rack Mount Kit
C1220 Rack Mount Kit
-
This rack mount kit is for the Cobalt C1220. It includes track slides and handles for the full size USB VNA.
-
Product
2U Rackmount Network Appliance With Intel® Xeon® Processor Scalable Family, Up To 8 NMC Slots. Ideal For Data Center Deployments.
FWA-6170
Network Appliance
Dual 1st/2nd Gen Intel® Xeon® Scalable Processors, up to 28 Cores24 x DDR4 ECC RDIMM slots2x 2.5" disk bays, and system fan, redundant PSU, 2 x low profile Gen3 PCIe x8 slotIntel® QAT with up to 40G Crypto supportIPMI v2.0 compliant, with web interface8 x Advantech network module expansions w/ PCIe Gen3 bandwidth
-
Product
Linktropy Network Delay Simulator
-
Linktropy Emulators Provide Affordable Network Emulation for Accurate, Repeatable Performance Testing at Speeds up to 1 Gbps
-
Product
Comprehensive Simulation of Master, Slave and End Nodes in A 2 B ® Networks
Infotainment Test Device ITD 1024
-
The complexity, cost and weight of audio systems are significantly reduced with the Automotive Audio Bus (A 2 B ® ) from Analog Devices Inc. Regardless of their hierarchical structure or use as master or slave, all A 2 B ® products must be adequately tested before use. This applies, for example, to HiFi amplifiers/loudspeakers, head units, eCall systems, microphones, vibration/noise suppression units, actuators or sensors.Our small and very compact infotainment test system ITD 1024 takes on this task for you: It comprehensively and extremely reliably tests all A 2 B ® signals and communication in all phases of the product development process - during development, for validation and in production.
-
Product
CDN - Coupling / Decoupling Networks
-
The Coupling- / Decoupling Networks are used to inject common mode disturbances to Equipment under Test (EuT). Further the CDNs provide sufficient decoupling between Auxiliary Equipment (AE) and disturbance signal. The requirements for CDN and their application are described in the standard IEC 61000-4-6 (Immunity to conducted disturbances, induced by radio-frequency fields). CDNs have a common mode impedance of 150 Ohm and are available for a multitude of cable types and connectors.
-
Product
Mobile Wireless Network Emulator
WISER
-
WISER 50-node wireless network emulator. Includes mobility, path-loss, CDMA time-slot emulation and more. Designed to emulate US Military network designs and may be applicable for other mobile wireless networks. Supports up to 50 nodes (vehicles, radio towers, etc). WISER is a joint project between Telcordia and Candela Technologies. Please see Telcordia's WISER Web Page for implementation details and research papers.
-
Product
Network Test Solution
CyPerf
-
Realism: Create digital twin of users, applications, and attacks to replicate and test QoE in real-world network environments.Native authentication: Send application and security traffic over authenticated sessions at high scale.Highly scalable: Supports millions of concurrent users and millions of connections per second that elastically scale up and down, enabling both resiliency and chaos testing.Containerized agents: Deploy lightweight traffic agents as containerized pods on-prem, VMs, managed Kubernetes deployments, private or public cloud (AWS, GCP, Azure)Lab and live network testing: Test performance and security both pre-deployment in a lab or safely in live production networks.Flexible: Portable subscription-based software solution with a robust and intuitive cloud-native GUI management dashboard
-
Product
OLP - Optical Line Protection
-
Nanning Xionghua Photonics Technology
OLP - Optical Line Protection by Xionghua Photonics
-
Product
PXIe Vector Network Analyzer
M937xA Series
-
The Keysight M937xA vector network analyzer (VNA) performs fast, accurate, measurements and reduces your cost-of-test by giving you simultaneous characterizations for two-port or multiport devices with a single PXI chassis.
-
Product
Fiber Optic Network Test
-
Test and characterize fiber optic cables, assemblies and network with unmatched speed, precision and spatial resolution. Luna’s OBR reflectometers can analyze loss with a spatial resolution and sensitivity unmatched in the industry.
-
Product
Pluggable Optical Line System
POLS
-
Use our compact pluggable modules to provide up to 8 DWDM channels to enable high-capacity optical inter-datacenter links for internet service and cloud hosting providers.
-
Product
FC Impedance Meters
-
designed for testing of the fuel cell with the small current (5 A or less), and not only the current-voltage characteristic test, the KFM2005 can easily measure for the impedance of a fuel cell using the AC impedance method, and the Cole-Cole plot. Using the measurement data of the Cole-cole plot, it is possible to calculate the circuit constant of the approximate equivalent circuit of the fuel cell. The built-in DC load (60W) is capable to operate from 0 V, and it can perform the test for the fuel cell up to 20V and 5A.
-
Product
Fanless Network Appliance For Edge Deployment With 5G And Wi-Fi6. Ideal For Edge Computing And 5G Network Infrastructure.
FWA-1212VC
Network Appliance
Intel Atom® C3336/C3558 network SoC with Intel® QuickAssist Technology1 x DDR4 2133/2400MHz, SODIMM (ECC optional) up to 16GB2 x 1GbE SFP/RJ-45 combo ports (auto-negotiation) + 4 x 1GbE RJ-45 LAN portsReserve 1 x M.2 3052/3042 / 1 x M.2 2230 and 1 x Mini-PCIe for RF module selectionDefault 16GB eMMC onboard
-
Product
USB Line Scan Camera
Inexpensive
-
Compact USB line scan camera with high sensitivity and resolutions from 2048 to 4096 pixels. The programming interfaces, including drivers, libraries and programming examples, enable the USB line camera to be integrated into your own application. The line scan camera is supported under the following operating systems:*Windows*Linux*Linux ARM 32Bit (Raspberry PI)*Linux ARM 64Bit (NanoPi M4 & NVIDIA Jetson Nano)
-
Product
Cable + Network Tester
LinkIQ
-
The LinkIQ™ Network+Cable Tester is designed to provide trusted cable testing along with network testing professionals need to do their jobs. LinkIQ™ validates cable performance (up to 10 Gig) using frequency-based measurements and provides distance to fault information along with a wire map of the cable under test.
-
Product
Impedance Meter, Audio, 200Ω, 2KΩ and 20KΩ scales
72-6948
-
Active device is essential for reliable installation of background music and paging systems in residences, offices buildings and public areas. Avoid costly service calls and amplifier damage by verifying actual speaker system impedance prior to operation. Unlike conventional volt/ohm meters, which measure DC resistance, this unit utilizes an internal 1KHz oscillator to measure true impedance. Accurately measure speaker lines that utilize impedance matching volume controls, switchers, transformers and passive crossovers. Because this unit accurately measures up to 20Kohm, it may also be utilized with 25V, 50V, 70V, and 100V speaker line transformers in commercial installations.
-
Product
Fanless Network Appliance For SD-WAN& UCPE Edge Deployment With Coming 5G & Wi-Fi 6 Support. Ideal For SD-WAN Deployments.
FWA-1112VCL
Network Appliance
Intel® Atom® C3000, up to 8 CoresIP40, fanless design, 0 ~ 40°C temperature rangeUp to 4 x 1GbE RJ-45 + 2 x 10GbE SFP slots or 1 x 1GbE SFP and 6 x RJ-45 slots5G LTE and Wi-Fi 6 RF certifiedIntel® QAT integrated2 x PoE+ support (optional)
-
Product
Network Analyzer Instrument State Utility
VNAState
-
The VNA Instrument State Utility works with the most popular Vector Network Analyzers from Agilent / HP. It retrieves the instrument state information (frequencies, calibration, markers, etc) and stores it on disk in the PC as an "IST" file (meaning Instrument STate). The data can then be downloaded into the instrument at a later date.
-
Product
Vector Impedance Analyser
TE3000
-
The TE3000 Vector Impedance Analyser is a portable desktop instrument designed for high accuracy impedance measurement. The probe style construction and small output signal make it ideal for "in circuit" impedance characterisation of small signal devices without the risk of damage to the device under test. The TE3000 comes factory calibrated to the tip of the probe with optional custom calibration. Turn it on, set the frequency, take a measurement, and display the results in any format.
-
Product
1U Rackmount Network Appliance Platform With LGA1151 Socket Intel® Core™/Xeon® E-2100 Series Processor, Intel® C246/H310 And Up To 26 LANs
NA590
-
*LGA1151 socket 8th gen Intel® Core™/Xeon® E-2100 series processor (Coffee Lake)*Four DDR4-2666 U-DIMM for up to 64GB of memory*Max. up to twenty-six 10/100/1000 Mbps Ethernet ports*Two expandable LAN modules supporting 1GbE/10GbE/25GbE/40GbE/Fiber/Copper/Bypass*Supports 1U redundant power supply for optional*Supports IPMI/TPM for optional*Suitable for network security, cloud computing and data centers applications
-
Product
Model Vector Network Analyzer
DZV-1
-
Digital Signal Technology, Inc.
DZV-1 is the vector network analyzer which can be measured the impedance and VSWR of the antenna, S Parameter of RF component and devices. It is small and low-priced. So, it is suitable for the production line, laboratory use, various testing applications, and the educational use. The communication between the DZV-1 unit and PC is done via USB, which is also used for power supply. The LOG-MAG characteristic, the phase-characteristic, the group delay frequency characteristics, the Smith chart, the polar coordinates, the SWR characteristic can be displayed on PC.
-
Product
Dual-in-Line (DIL / DIP) Reed Relays
Reed Relay
Pickering Electronics Series 97 & 98 DIL / DIP Reed Relays feature the highest quality instrumentation grade reed switches making them suitable for the most demanding applications. They are available in two ranges featuring internal mu-metal magnetic screens.
-
Product
Aluminum Cabinet Stabilizers, Pair
ST-1
-
Cabinet stabilizers are cast aluminum construction. They extend 10” (254mm) from the base and are adjustable with leveling screw/pads.
-
Product
Line Tester
LT51
-
The LT51 Line Tester is a portable handheld battery powered instrument for Data, DSL, Telephone, Voice Copper Line testing. It combines the features of several pieces of test equipment such as a Level Meter / Spectrum Analyser, Distortion Analyser, Oscillator, Handheld DMM and TDR in the one small lightweight package.
-
Product
Network Delay Emulator
-
BGP Network Delay Emulator. The Border Gateway Protocol or BGP is at the core of the modern Internet. Large corporate and government enterprise networks are increasing their use of BGP to interconnect different administrative and country specific regions
-
Product
Satellite Network Simulator
-
The DataSoft Satellite Network Simulator is a real-time software tool capable of simulating satellite links by operating as a hardware-in-the-loop tool for layer-2 verification and validation, or, as an offline planning tool for capacity and availability analysis for planned deployments.
-
Product
1-slot Network Attached File Server
DTS1
-
Curtiss-Wright Defense Solutions
Modern unmanned vehicles, ISR aircraft, and mobile ground vehicles are built around a network-centric architecture. The backbone of such systems is Gigabit Ethernet (GbE), operating at 1.25 gigabits per second. With a network switch (or redundant switches) in the middle of the system, any network-enabled device can communicate with any other similar device. In addition, NAS devices like the DTS1 allow any client to retrieve stored files or save new captured files.
-
Product
Network Performance Monitoring & Diagnostics SaaS
ObserverLIVE
-
A subscription-based service which actively assesses end user experience in hybrid environments, to ensure users can effectively access and utilize core business applications. Monitor end user experience on-premises and SaaS based applications.
