Product

2000 Amp DC / 1500 Amp AC Current Probe

DC2000

-

Summit Technology, Inc.

DC2000 - Summit Technology, Inc.

Our DC2000 Current Probe measures up to 2000 amps DC (as well as 1500 amps AC).  Self-powered via our meter, so there are NO batteries that can run down during a measurement session.

Product

Mobile Decoders

-

Digitrax, Inc

Digitrax, Inc

.672” x 1.074” x .259” 17.08mm x 27.28mm x 6.6mmDigitrax Easy Connect 9 Pin Harness1.5 Amp/2 Amp Peak Current Rating6 FX3 Functions, 0.5 Amp Total Function Current Rating

Product

Digital Multimeters

-

Milwaukee Tool

Milwaukee Tool

A digital multimeter (DMM) is a test tool used to measure two or more electrical valuesprincipally voltage (volts), current (amps) and resistance (ohms). It is a standard diagnostic tool for technicians in the electrical/electronic industries.

Product

Test & Burn-In Socket for Devices up to 13mm Square

CSP/MicroBGA

-

Aries

CSP/MicroBGA - Aries

Test & Burn-In Socket. Socket is easily mounted and removed to & from the BIB due to solderless pressure mount compression spring probes which, are accurately located by two molded plastic alignment pins and mounted with four stainless steel screws. Standard molded socket format can accommodate any device package of 13mm or smaller, by using machined (for small quantities) or custom molded (for large quantities) pressure pads and interposers.

Product

Non-Contact H.V. Detector

300 HP

-

Standard Electric Works Co., Ltd

300 HP - Standard Electric Works Co., Ltd

Protection class : IP66. 3 LED indicators in a circle for easier viewing in any directions (360° LED indication). 8 voltage settings : 240V, 2kV, 6kV, 11kV, 22kV, 33kV, 132kV, 275kV. High bright LED visual indication. With the longer shelter to make the 3 LED indicators brighter under the sun. Sound indication. The maximum voltage setting can be 500kV . Self-test function. Power source : 1.5V "C" type battery × 3. High impact nylon casing. Non-contact work by proximity. Compatible with most hot sticks. Lightweight, robust & compact. Suitable for indoor and outdoor use. Easy access to batteries. Special ranges are available upon request. The maximum detection range can be 500kV. Meets EN 61326-1, CISPR 11, EN 61000-4-2, EN 61000-4-3, EN 61000-4-8.

Product

General Purpose Low-side MOSFET Drivers

-

Renesas Electronics Corp.

Renesas Electronics Corp.

Renesas' family of low-side FET drivers are very high-speed matched dual-drivers capable of delivering peak currents of 2.0 amps into highly capacitive loads and excellent at driving large capacitive loads with minimal delay and switching times. The high-speed performance is achieved by means of a proprietary "Turbo-Driver" circuit that speeds up input stages by tapping the wider voltage swing at the output. Improved speed and drive capability are enhanced by matched rise and fall delay times. These matched delays maintain the integrity of input-to-output pulse-widths to reduce timing errors and clock skew problems. This improved performance is accompanied by a 10 fold reduction in supply currents over bipolar drivers, yet without the delay time problems commonly associated with CMOS devices. Dynamic switching losses are minimized with non-overlapped drive techniques.

Product

High Voltage Op Amplifiers ≥12V

-

Analog Devices Inc.

Analog Devices Inc.

High supply voltage op amps are used in systems that demand the widest dynamic range with the best signal-to-noise ratio. Engineers turn to Analog Devices for high voltage amplifiers that deliver industry-leading performance. Increasingly, new high voltage amplifiers also offer features to improve system performance, cost, and robustness while easing the complexity of system design. New features include integrated input overvoltage protection (OVP), on-chip electromagnetic interference (EMI) filtering, higher electrostatic discharge (ESD) immunity, and greater resistance to latch-up in both powered and unpowered operations.