Product

Utility Power Source

SE-UDPS

-

Salland Engineering

SE-UDPS - Salland Engineering

Load boards for applications like mixed signal, analog and RF require active components. To drive these active components multiple utility power supplies are needed. The SE-UDPS from Salland Engineering is an economical way of adding more utility power supplies to your Advantest™ V93K to drive op-amps, buffers, relays and switches. The SE-UDPS extends the usefulness of your current fleet of V93Ks. You can also minimize the need to add external power supplies on your load boards.

Product

Noise Source Test Set, 10 MHz to 26.5 GHz

N2002A

-

Keysight Technologies

N2002A - Keysight Technologies

The N2002A noise source test set is a low cost, stand-alone instrument that, as part of a calibration system, enables fast, repeatable calibrations with minimal levels of uncertainty.

Product

High Voltage Cable/Harness Test System

CKT1175-50

-

CK Technologies, Inc.

CKT1175-50 - CK Technologies, Inc.

The CKT1175-50 is a high-voltage wiring analysis system that features a switching matrix that can be distributed around the workshop or in and around the assembly to be tested. This system is expandable in 100 or 150 test point increments to 96,000 test points, and is available with a variety of adapter cable interface connectors, with the standard being the CKT MAC interface system

Product

4 (High Voltage) D/A Outputs (+20 VDC to +80 VDC)

DA4

-

North Atlantic Industries

DA4 - North Atlantic Industries

The DA4 module features 4 high-voltage D/A output channels with a maximum full-scale range of ±80 VDC at ±10 mA (max).

Product

High Voltage 50 Ω Pulse Generator

TLP-3010C

-

High Power Pulse Instruments GmbH

TLP-3010C - High Power Pulse Instruments GmbH

*Wafer and package level TLP/VF-TLP/HMM testing*Ultra fast 50 Ω high voltage pulse output with typical 100 ps rise time*Built-in HMM (IEC 61000-4-2) pulse up to ±8 kV*High pulse output current up to ±30 A*High speed 50 Ω trigger output for oscilloscopes (synchronous to high voltage pulse output)*6 programmable pulse rise times: 100 ps to 50 ns*8 programmable pulse widths: 1 ns to 100 ns*Optional pulse width extender increases pulse width up to 1.6 µs in 68 programmable steps*Fast measurement time, typically 0.2 s per pulse including one-point DC measurement between pulses*Efficient software for system control and waveform data management*The software can control automatic probers for fast measurement of complete wafers*High performance and high quality components

Product

Standard Voltage 78 Pin D-Type Cables - Calibration Cables For Pickering Products

-

Pickering Interfaces Inc.

Pickering Interfaces Inc.

The cable assemblies below are suitable for use with Pickering precision resistor cards and modules that utilize 78-pin D-type calibration port connector.

Product

Voltage Tester

-

PeakTech Prüf- und Messtechnik GmbH

PeakTech Prüf- und Messtechnik GmbH

Uses voltage detection technology for the detection of voltage in cables, cords, circuit breakers, lighting fixtures, switches, outlets and wires.

Product

High Power Programmable AC Source

61610

-

Chroma Systems Solutions, Inc.

61610 - Chroma Systems Solutions, Inc.

Power Rating:61511/61611: 12KVA61512/61612: 18KVAVoltage Range: 0-150V/0-300V / AutoConfigurations with input voltage of 220V or 480VFrequency: DC, 15Hz-1500HzSingle-phase or three-phase output selectableProgrammable slew rate setting for changing voltage and frequencyProgrammable voltage and current limitHigh output current crest factor, ideal for inrush current testingTurn on, turn off phase angle controlTTL signal which indicates output transientComprehensive measurement capability, including current harmonicsAnalog programmable interfacesRemote interface: GPIB, RS-232, USB and EthernetCapable of delivering power output up to 90KVA by implementing Master-slave parallel operation

Product

Voltage Meter

МН32С

-

Holding Informtest

МН32С - Holding Informtest

The mezzanine module (mezzanine) МН32С is designed to measure instantaneous voltage values ​​over thirty-two differential channels.

Product

Pacific Power Source line

ACX Series

-

Pacific Power Source, Inc.

ACX Series - Pacific Power Source, Inc.

Power conversion is achieved by high frequency pulse width modulation, resulting in cool, quiet and efficient operation. The 118-ACX is ideal for AC test, frequency conversion, laboratory and bench-power applications. Equipped with the UPC-1 programmable controller, the 118-ACX becomes a powerful AC Power Source and Power Analyzer for today's testing needs.

Product

Fullband Coaxial Noise Sources

-

Mercury Systems, Inc.

Mercury Systems, Inc.

Our line of full-band noise sources are specially designed for easy integration into microwave systems. They feature rugged construction with excellent long-term stability. In addition to the RF output choices, there are also different packages available to meet a wide range of mechanical constraints. Typical applications include jamming, radar alignment, SNR testing and general lab use.

Product

AC Power Source

LSP-500VAR

-

Lisun Electronics Inc.

LSP-500VAR - Lisun Electronics Inc.

• AC-DC-AC frequency conversion technology, Controlled & tested by 16 bits MCU • Protection for over hot, thundering voltage and current • Total voltage distortion: ≤0.3%; Voltage stability: ≤0.05%/30min • Load adjust rate: ≤0.05%; Frequency stability: ≤0.01%/30min • Output voltage range: AC 0.0~300.0V, Output Frequency Range: 45~70Hz, 100Hz, 200Hz and 400Hz • It is pure sine wave AC power source with low harmonic and high accuracy • Input Power: 220V and 50/60Hz (110V can be option) • Communicate with PC via software, the Voltage & Current set by the software and Power Output can be remote controlled.

Product

Long Light Source

LM-A

-

Eddy Co.

LM-A - Eddy Co.

The long light source is compatible with the LM-101 or the LMC-20. The light is supplied with a 50 watt tungsten halogen convection cooled light source which provides suffcient energy for use with narrow band pass filters or monochronomators in the wave length range of .35 to 2.5 microns. The light beam is chopped at 200 hz by a quiet, vibration free, synchronous motor. The housing also contains a secondary LED light source and detector for synchronization of the amplifier, plus an electro-mechanical shutter to block the light output when the instrument is zeroed. An internal collimating lens produces a narrow beam (<1") so the LM-A can be used in bell-jar and large coating systems.

Product

Standard Voltage 9 Pin D-Type Connectors for Pickering Products

-

Pickering Interfaces Inc.

Pickering Interfaces Inc.

The connectors below are suitable to use with Pickering cards and modules that utilize a standard voltage 9-pin D-type connector.

Product

Low Level, DC Voltage Data Logger

Volt101A

-

MadgeTech, Inc

Volt101A - MadgeTech, Inc

The Volt101A is one of MadgeTech's newest data loggers. It is part of a new series of low cost, state-of-the-art data logging devices. MadgeTech has taken the lead in offering the most advanced, low cost, battery powered data loggers in the world today.

Product

(Automatic Redundant Battery Selector With Source Control And Monitoring)

ARBS 2600

-

La Marche Manufacturing Company

ARBS 2600 - La Marche Manufacturing Company

Our product is designed with high powered diodes to select the higher voltage of the two isolated DC power sources. The ARBS selects power from the best available battery while isolating the alternate battery bank. The special heat sink diode assembly is manufactured to handle high output requirements with safety margin to spare.

Product

Signal Sources

-

Rolls Corporation

Rolls Corporation

Designed to elevate your audio experience.

Product

Indoor Multi-Light source of Measurement System for PV Cell

-

King Design Industrial Co., Ltd.

King Design Industrial Co., Ltd.

The multi-light source measurement system is capable of execute I-V measurements by Real-Time One-Sweep Method (RTOSM), which not only removes the capacity effect but also meets the requirements of SEMI PV57-1214. The measurement process is controlled by designed program, thus the measured I-V curve, Pmax/Isc/Voc/… etc, could be exported automatically.This system is applicable to DSSC/OPV/Perovskite measurements.

Product

Sources Of Current And Voltage

-

Holding Informtest

Holding Informtest

Sources of current and voltage.

Product

C+L Band Broadband Light Source

S-103

-

Notice

S-103 - Notice

ASE broadband source slot module of FOTS system can offer special function that is able to change optical output spectral feature variously, which is change optical output spectral feature variously, which is followed by user’s driving embedded pump LD freely. The output power of each pump LD is controlled separately by the program that is set up by user. In the case optimum ASE source output features such as wide broadband (> 80 nm @ -10 dBm/nm) and stable output power (< 0.02 dB) is needed, it is made up so that the provided Default mode along with User mode can be chosen and set up. More stable application of ASE source is possible through the combination of monitoring of ASE output power, alarm status and pump LD status with real-time optimal feedback. The embedded FPGA processor makes high speed control possible and enables monitoring and feedback routine operated stably.

Product

AC High Voltage Tester

VHT

-

Veer Electronics

VHT - Veer Electronics

VEER make High Voltage Tester VHT is specially designed to test Dielectric Strength of Device under Test as per applicable standards. High Voltage test is required to determine whether test object has proper insulation or not. High Voltage test is carried out as Routine Test Each device is subjected to test at high voltage of 1 kV + 2 x (working Voltage)If Insulation is weak then device will consume more power because of leakage current which causes more heat. Heat will reduce the reliability and overall life of device under test It is also responsible for high risk of electric shock. So, High voltage test is necessary for all electrical equipments.

Product

Broad-Range High Voltage Non-Contact Tester

HVNCVT-2

-

Klein Tools, Inc.

HVNCVT-2 - Klein Tools, Inc.

Use to check for the presence of voltage in overhead conductors or to find faults in cables.7 sensitivity ranges up to 230kV AC (240V, 4.2kV, 15kV, 25kV, 35kV, 69kV, 115kV, 230kV).Audible and visual signals indicate the presence of voltage.Water resistant.Includes durable carrying case and universal/shotgun adapter.