Comb Generators
a reference signal source outputing multiple harmonics of the input signal.
See Also: Open Area Test Sites
-
Product
Alternate 2.64 (75.00) - 6.50 (184.00) General Purpose Probe
EPA-2B30-1
General Purpose Probe
Current Rating (Amps): 5Average Probe Resistance (mOhm): 35Test Center (mil): 100Test Center (mm): 2.54Full Travel (mil): 160Full Travel (mm): 4.06Recommended Travel (mil): 107Recommended Travel (mm): 2.72Mechanical Life (no of cyles): 2,000,000Overall Length (mil): 970Overall Length (mm): 24.64
-
Product
Synchronous Generator
ZET 7190
-
The Synchronous generator ZET 7190 is intended for generating sine, pulse, saw-shaped signals. It has 2 synchronous channels and can be used individually, or as a part of control and automation systems.
-
Product
Pattern Generator
PG314N
-
The MicroImage PG314 series of pattern generators are for applications to display custom designed patterns on screen. The PG314 units will overlay the pattern or patterns on top of the video signal provided to the input of the device. While the PG311 can be factory programmed with only one unique pattern, the PG314 can hold up to four patterns and switch between them.
-
Product
General Purpose Probe
BT-1
-
BT-1 General Purpose Probe - Probably our best general purpose probe designed for temperature measurement of solids, liquids, gases and semi-solids. Welded stainless-stell shaft, plastic handle. Tip is .028'' diameter bent at right angle to probe to facilitate accurate surface measurements. Immersible. Maximum temperature 240°C, Time constant 0.15 Seconds. 5 foot lead. Not isolated.
-
Product
Signal Generator
8007
-
Normal switching mode, SSB phase noise will be degraded in the fast mode. 5 digit BCD, 1 latch control line, 25 pin female, D type connector
-
Product
Arbitrary Waveform Generator
T3AWG3K
Arbitrary Waveform Generator
T3AWG3K Series consists of six high definition high performance Arbitrary Waveform Generators (HD AWG) consisting of 2, 4 and 8 channels, 16 bit vertical resolution, 12 Vpp max output voltage (50Ω into 50Ω), 128 Mpts/ch memory (optional 1 Gpts/ch), a maximum sampling rate of 1.2 GS/s and a max sinewave frequency of 250 MHz and 350 MHz respectively.
-
Product
Standard 2.20 (62.00) - 4.80 (136.00) General Purpose Probe
EPA-4D
General Purpose Probe
Current Rating (Amps): 7Average Probe Resistance (mOhm): 35Test Center (mil): 187Test Center (mm): 4.75Full Travel (mil): 250Full Travel (mm): 6.35Recommended Travel (mil): 167Recommended Travel (mm): 4.24Mechanical Life (no of cyles): 2,000,000Overall Length (mil): 1,320Overall Length (mm): 33.53
-
Product
Waveform Function Generators
-
Teledyne Test Tools generate fixed or arbitrarily defined waveforms and signals for use in the development, testing and repair of electronic systems.
-
Product
Arbitrary Waveform Generators
-
Tektronix arbitrary waveform generators enable complex signal generation with simple, easy to use tools. The arbitrary waveform generator family provides leading-edge performance with sample rates up to 50 GS/s, up to 4 channels and software packages that simplify the creation of these complex signals.
-
Product
Quad sync generator
TELETEST SYNC
-
A very compact, high quality professional composite video sync generator with four outputs.
-
Product
Arbitrary Waveform Generator
M8199A
Arbitrary Waveform Generator
Get the highest sample rate and the widest bandwidth arbitrary waveform generator in its class with up to four synchronized channels operating simultaneously in one module.
-
Product
Avionics Generator
MPG 4010 Series
-
The MPG 4010 Series is fully compatible to Aeroflex NAV 750C, 2030 and 2040 Series GPIB commands, enabling simplified and optimized replacement. Avionics parameters are presented in the same form as described in the ICAO standards. The 4010 Generator is the ideal solution for the testing of avionics on-board LRU and airfield alarm monitors in STTE systems. The use of a Vector Modulator and Digital Modulation Techniques ensures very high accuracy and stable performance over all operating conditions.
-
Product
Arbitrary Waveform Generator
-
An arbitrary waveform generator (ArbGen) is an extended function generator (FGen/FuncGen) that can generate freely programmable signals in addition to standard waveforms such as sine, square, triangle or trapezoid. In general, the voltage/current as well as the frequency/duration of the output signal can be freely adjusted.
-
Product
Telecom Generators
-
Telecommunication networks are exposed to particularly natural disasters such as lightning and its effects. Therefore all connected telecommunications systems require reliable protection. Our subsequent Surge Simulators are specifically designed for EMC testing of telecommunications systems in accordance with ITU-T.
-
Product
Signal Generator
8006
-
Normal switching mode, SSB phase noise will be degraded in the fast mode. 5 digit BCD, 1 latch control line, 25 pin female, D type connector
-
Product
Signal Generators
-
Analog Devices signal generators provide an ideal solution for applications such as wireless HDMI®, microwave and millimeterwave radio, and sensor equipment. These products offer a clean signal, broad frequency coverage, and high output power for multiple applications, with competitive functionality and performance against other signal generators in their class. Our technology operates up to the 70 GHz range, and includes bench top and portable options for greater flexibility in design and development.
-
Product
Function Generator
-
G5100A 50MHz Function / Arbitrary Waveform Generator can create stable, precise, clean and low distortion sine waves by using DDS (Direct Digital Synthesis) Technology. With fast rise and fall times up to 25 MHz for square waves and 200KHz for linear ramp waves , the G5100A also can reach users』 demand on waveforms。
-
Product
P2262A General Purpose Probes
General Purpose Probe
Current Rating (Amps): 3Average DC Resistance lower than (mOhm): 30Test Center (mil): 50Test Center (mm): 1.27Full Travel (mil): 90Full Travel (mm): 2.29Recommended Travel (mil): 67Recommended Travel (mm): 1.70Overall Length (mil): 710Overall Length (mm): 18.03
-
Product
Pulse & Delay Generators
-
The benchtop pulse generators feature a fast risetime and low jitter. Our most popular digital delay pulse series 575 and 577 generators are now available with selectable time references. With up to eight channels of delay and width control, each individual channel's reference can be set either to the trigger or to any other channel. So look below if you require a picosecond pulse generator or nanosecond pulse generator for your application.
-
Product
Time Code Generators
-
Masterclock's time code generators provide a source of very stable time code and accurate time and date information. The GPS500 extracts timing reference from GPS satellite signals and generate time code synchronized to within less than 10 microseconds of UTC (Universal Coordinated Time). It can output IRIG-B with and without IEEE 1344 date encoding, SMPTE/EBU, NMEA 0183, Kinemetrics/Truetime, and 1PPS.
-
Product
DDS Function Generator
FG-2000
-
Based on the latest advances in DDS (Direct Digital Synthesis) technology, the FG-2000 series is a portable high precision sine, square, and triangle waveform function generator. The FG-2000 series utilize microprocessor control that delivers clean and accurate waveforms up to 20MHz with 5V peak-to-peak amplitude in a portable hand-held unit.
-
Product
PXIe-5672, 2.7 GHz, 20 MHz Bandwidth Digital Upconverter Included, PXI Vector Signal Generator
779900-03
Vector Signal Generator
2.7 GHz, 20 MHz Bandwidth Digital Upconverter Included, PXI Vector Signal Generator —The PXIe‑5672 features quadrature digital upconversion, which reduces waveform download and signal generation time. It is a general-purpose vector signal generator that can generate standard modulation formats such as AM, FM, PM, ASK, FSK, MSK, GMSK, PSK, QPSK, PAM, and QAM. The PXIe‑5672 delivers a highly flexible and powerful solution for scientific research, consumer electronics, communications, aerospace/defense, and semiconductor test applications as well as emerging areas including software defined radio, radio frequency identification (RFID), and wireless sensor networks. For specific communications standards, you can use various software add-ons to generate modulated signals according to standards such as WCDMA, DVB‑H, and ZigBee.
-
Product
T2-MI Generator
T2-MIGen
-
T2-MIGen is designed to encapsulate into a T2-MI stream one or two TS stemming from a multiplexer or directly from encoders. It outputs theresulting T2-base or T2-lite compliant multiplex through ASI and IP.
-
Product
Doppler Generator
Series 5000
-
Eastern OptX introduces moving target generators covering radar frequencies from 1 – 18 GHz. These compact systems provide target generation with speeds from 0 to 3000 MPH, and allows the user to set target and radar source speeds and directions. Systems may be operated remotely using wireless control with scenario generator features including flight path replication, moving source and targets, and multiple target options.
-
Product
RF Signal Generators
-
Compact and reliable microwave and RF Signal Generators for use in automated testing environments, production verification, EMC testing, educational institutions, aerospace, defense projects, LTE engineering, satellite communications, CATV, 5G design…
-
Product
General Purpose Probe
HT-1
-
HT-1 ''Workhorse'' General Purpose Probe - designed for temperature measurement of liquids, gases and semi-solids. Plastic handle with straight 3'' stainless shaft. Not good for surface temperatures. Maximum temperature 400°C, Time constant 0.5 Seconds. 5 foot lead. Not isolated.
-
Product
Radius, Alternate 0.78 (22.00) - 3.70 (105.00) General Purpose Probe
HPA-0D-1
General Purpose Probe
Current Rating (Amps): 3Average Probe Resistance (mOhm): 35Test Center (mil): 50Test Center (mm): 1.27Full Travel (mil): 100Full Travel (mm): 2.54Recommended Travel (mil): 67Recommended Travel (mm): 1.70Mechanical Life (no of cyles): 1,000,000Overall Length (mil): 635Overall Length (mm): 16.13
-
Product
Call Generation
Emutel SIP Harmony
-
SIP Harmony has strong Call Generation capabilities. Using the SIP | Harmony ''Composer'' application, scripts can be quickly created to generate high volumes of calls. Once calls are established they can be cleared down straight away or held active for any period of time to simulate different call lengths. The SIP | Harmony is also capable of terminating calls, so complete wraparound testing of any piece of equipment can be carried out.
-
Product
DC Voltage/Current Generators
-
Pulse generation/measurement with basic accuracy of ±0.02% and the minimum pulse width of 50μs, maximum output of 6V/5A
-
Product
Tone Generators
-
Traditional Tone Generators were designed for one primary mission; to identify the termination point of a cable. Unfortunately, these were designed for telephony, not network maintenance.
