-
Product
Optical Power Measurement Products
-
The Keysight optical power measurement module family provides a range of power sensor modules (8163xA/B), external optical heads (8162xB) controlled by the interface modules (81618A or 81619A) and return loss modules (8161xA).
-
Product
AC Power Sources, Frequency Converter
MAC-01, -02, -03
-
For reliability, all models of the Titan AC Power Sources/Frequency Converters are fully current limit protected against either continuous or transient short circuit or overload conditions. When an overcurrent condition exists, the internal current control loop overrides the voltage control loop and scales back the sinewave drive until it sees a safe output current level.
-
Product
USB Power Sensor, 50 MHz to 24 GHz
U2002H
Power Sensor
Measure average power over the frequency range 50 MHz to 24 GHz and power range -50 dBm to +30 dBm.
-
Product
8-Pin Power D-Type Cable, Male to Male, 1m
40-970-408-1m-MM
Cable Assembly
The 8-Pin Power D-Type cable assembly is constructed from 56/0.3 (12AWG) Copper Wire with PVC insulation. Screwlocks are provided to secure the connectors to their associated products.
-
Product
Programmable Linear DC Power Supply, 4 Output, 0-32V/0-3A, 0-5V/0-1A, 0-15V/0-1A
DC Power Supply
Programmable Linear DC Power Supply, 4 Output, 0-32V/0-3A, 0-5V/0-1A, 0-15V/0-1A.
-
Product
PXI 3A Power MUX BRIC, 24-Channel, 6-Pole
40-571-403
Multiplexer Module
The 40-571 is a Power Multiplexer designed to simplify the connection of a common set of test equipment to one of a number of different devices for testing (simultaneous multiple channel selection is possible for most configurations, see switching specifications for restrictions). It is ideal for applications where the equipment needs to conduct the same test process on a series of similar devices one at a time. It is available in a variety of configurations that allow testing with differing number of devices to be tested and different connection widths to suit differing test equipment pin counts.
-
Product
High-Power Multi-Ports Output CATV EDFA (1540~1563nm)
HA5400B (2RU)
-
Hangzhou Huatai Optic Tech. Co., Ltd.
HA5400B (2RU) series is a high power multi-ports optical amplifier with gain spectrum band within 1540~1563nm. It is mainly designed for the application of CATV or 1~8 continuous banding channel (ITU wavelength). It offers a flexible and low-cost solution for CATV large area coverage of metropolises and medium-sized cities.
-
Product
Frequency Selective Power Sensor
NRQ6
Power Sensor
The R&S®NRQ6 is based on receiver technology and can perform band-limited power measurements down to -130 dBm. The R&S®NRQ6 combines high-precision with high-speed measurements beyond the limits of currently available power meters. In addition to conventional continuous average measurements, the R&S®NRQ6 has a trace display function and also performs ACLR measurements.
-
Product
AC/DC Power Supply 50 W
HBU50-108
-
AC/DC power supply with 50 W from Sinpro | input ranges 80 - 275 VAC | output 24 V | operates in temperatures from -10 to +70 °C | provides 2 MOPP protection
-
Product
POWER ATTENUATORS
TYPE ATF
-
National RF’s Type ATF Power Attenuators were designed to allow interfacing of linear power amplifiers to RF exciters, where a specific amount of drive to the amplifier is prescribed. Often, however, drive from the RF exciter exceeds this minimum prescribed level and some form of power attenuation must be used in order to not damage the input of the power amplifier. National RF’s type ATF-3 offers 3 dB of power attenuation (1/2 of the power) when used between the exciter and the amplifier and will handle an input power of 132 Watts, RMS (continuous power) while providing about 66 Watts RMS output power, when it is terminated into 50 ohms. In practice, the ATF-3 attenuator will handle exciters achieving Peak Envelope Power levels (PEP) in the area of 200 to 250 Watts while providing half of that power to the load. For less attenuation requirements, the ATF-1 and ATF-2 offer 1 and 2 dB of attenuation, respectively.
-
Product
Power Quality Analysers
EPPE
-
Power quality measuring systems with integrated fault recorder functionality for continuously and automatically monitoring electrical installations at all voltage levels. The measuring systems of the EPPE series continuously and precisely record all the electrical parameters of the power supply. They deliver detailed quality evaluations which reveal even the smallest of deviations and contribute to identifying the cause of disturbances.
-
Product
Acroname MTM Power Development Board
-
HIGH POWER. HIGH CURRENT. The MTM Power Development Board allows high power and high current connections to quickly deploy MTM testers.
-
Product
Power Analyzer
-
E-Mobility - eDrive, and Electric Vehicle TestingAdvanced and easy to use solutions for complete electric and hybrid vehicle testing in the development, validation and production phase. One-stop solutions for electric motor and inverter testing, battery and battery charge testing, combustion analysis, hydrogen engine testing and more.
-
Product
Wide Range Medium Power DC Electronic Load
N6200 Series
-
Next Generation Instrumental (Shanghai) T&C Tech. Co., Ltd.
N6200 series is developed based on NGI's years of experience in testing for power supply and battery. It is with high accuracy, high reliability and high cost-effective. N6200 series is with high power density and elegant appearance, which is available for benchtop use or installation in 19 inch cabinet.
-
Product
Bench Power Supply, Single, Adjustable, Fixed, 3 Output, 0 V, 30 V, 0 A, 3 A
72-6628
-
The 72-6628 is a Triple Bench Power Supply with adjustable current control and galvanized steel case. The DC regulated power supply is a completely solid state, compact, well regulated, constant voltage power supply suitable for service field, hobby, laboratory and testing use. It provides three different voltages output for different. Overload and short-circuit protection, prevent the unit from overload and short circuit. When the unit is under the condition of overload or short circuit, the output current will be limited. Independent 5V, 12V easy snap-on output terminals to make it easy to use for TTL and CMOS circuit testing. The grounding of the output terminals is independent that the output can be connected in series to make a higher output voltage.
-
Product
9U 8-Slot CompactPCI® Chassis with Redundant Power Supplies
cPCIS-3330 Series
Chassis
The cPCIS-3330 Series is a 19" 8-slot 6U CompactPCI Subsystem ideally suited to Network Equipment Providers, Computing Telephony Integrators and Voice over IP applications. This flexible and reliable development platform with optimized I/O and storage provides the best solution for equipment manufacturers and system integrators and shortens time-to-market for fast growing business revenues.
-
Product
Low Power Programmable AC Source
-
Chroma Systems Solutions, Inc.
Delivers pure, instrument grade AC power at very low cost with output voltage from 0 to 300VAC, and frequencies from 15 to 1000Hz
-
Product
PXI 48 x SPDT Power Relay Module
45-157-001
Relay
The 45-157 SPDT Power Relay Module consists of 48 single pole changeover relays controlled by a PXI/CompactPCI interface. It is suitable for applications were conventional reed-relay based switching modules do not have sufficient voltage rating or current carrying capacity. All 48 contacts are electrically isolated from each other and are capable of switching resistive and inductive loads up to 2000VA at 240V AC.
-
Product
Power Sensor and SNS Noise Source Cables (3 m/10 feet)
11730B
Power Sensor
The Keysight 11730 series power sensor cables are used with the 8480 and E-series power sensors (except the E9320 family of peak and average sensors). These cables are designed to reduce RFI effects on low power readings with an improved shielding design in the cable itself. Cables may be ordered individually or in pairs in any combination desired for single and dual-channel measurements.
-
Product
Signal Patchcord, ITA, Mini Power, 50u Gold, 36", 14 AWG White Teflon, Single Ended, (40 Amps)
7-239912000-036
Signal Patchcord
Signal Patchcord, ITA, Mini Power, 50u Gold, 36", 14 AWG White Teflon, Single Ended, (40 Amps)
-
Product
PXI 8-slot BRIC Power Multiplexer, 4-Channel, 24-Pole (4 Sub-cards)
40-571A-102
Multiplexer Module
The 40-571A-102 is a 4-channel, 24-pole 3 Amp Power Multiplexer and is part of our BRIC family. The 40-571A range is designed to simplify the connection of a common set of test equipment to one of a number of different devices for testing.
-
Product
Power Quality Products
-
Schaffner offers a unique mix of harmonic filters, output filters, and LCL filters to rebuild and maintain the quality of power that meets local and international standards as well as meeting customer requirements.
-
Product
Uninterruptible Power System
GT Series
-
The Global Uninterruptible Power System or GT Series, features Clary's On-Line Double Conversion technology, and is Power Factor Corrected for a wide range of voltage inputs, (120Vac through 240Vac and 50/60Hz).
-
Product
4-IN-1 Fiber Optic Power Multimeter
FPM-100
-
Shanghai Fibretool Technology Co.,Ltd.
A power meter is the essential tool for measuring optical power within a fiber optic link. FPM-100 optical power meter is a precise, durable, convenient, portable test instrument. Smart appearance with the backlight, auto-shutdown features, the wide range of optical power testing, test the accuracy of precision as well as a common interface design with 0.01dB resolution.
-
-
Product
DC Power Supply, 30V, 5A
U8002A
DC Power Supply
The Keysight U8002A 30V/5A single-output, non-programmable DC power supplies is suitable for a variety of electronics manufacturing applications. With our affordable pricing, it is also well suited for usage in education labs.
-
Product
Micro Power, Contact, Receiver
610142106
Power Contact (Receiver)
(Available preloaded x2 in 510180102 Micro Power, Receiver, Insert)
-
Product
PXI 16 Amp Power Multiplexer, Single 12-Channel 1-Pole
40-662A-014
Multiplexer Module
The 40-662A-014 is a single 12-channel, 1-pole MUX and is part of our range of 16 Amp PXI power multiplexer modules is available in seven configurations ranging from 4-off 2:1 multiplexers to 1-off 16:1 multiplexer.
-
Product
DC to AC Power Inverter
TE-1206B
-
Help to operate all kinds of devices need the AC power, such as electric lights, kitchen appliances, power tools, TVs, radios, computers and more. The extra USB can provide power for using/charging mobile phones and digital devices conveniently.
-
Product
DC Blocking Power Splitter Combiner
PD5160
-
INSTOCK Wireless Components, Inc
Wideband Frequency (698 - 2700 MHz)Low Insertion Loss (0.5 dB avg)High Port to Port Isolation (30 dB avg)Excellent VSWR (1.15 : 1 avg)50 VDC maximum on DC block portsTri Alloy Type SMA Female (Jack) 50 Ohm
