Positioning Tables
align test targets with test set using a moving table.
See Also: Positioners, Hexapods, Micropositioners
-
Product
Global Positioning System Sensors
GPS
-
GPS sensors are receivers with antennas that use a satellite-based navigation system with a network of 24 satellites in orbit around the earth to provide position, velocity, and timing information.
-
Product
Micro Power / Micro Coax, Module, ITA, 90 Series, 50 Position
510108262
ITA Module
Primary mating module 510104267.
-
Product
3-DOF Simulation Table
KRD60 series
-
KRD60 Series 3 DOF simulation table simulates various mechanical, electrical, and electronic products installed on ships, seaplanes, and other equipment to perform sway and tilt tests to determine the ability and structural integrity of the product to withstand severe sway and tilt requirements. The tilt test is mainly applicable to large-angle tilt caused by ship damage, manipulation, imbalance in loading and unloading, and wind. The sway test is mainly applicable to long-term swaying of the ship due to external forces such as wind and waves, which must be maintained normally or products that work reliably, and products that have a significant impact on their performance in a rocking environment.
-
Product
Signal/Micro Power/ Micro Coax, Module, Receiver, QuadraPaddle, iCon Series, 100/15 Position, loaded w/ twin female contacts & round posts
510160113
Receiver Module
This module comes fully loaded with twin female contacts & round posts (p/n's 610138200 & 610138117).iCon modules mount from the rear of the iCon/i1 receiver and ITA and allow installation and removal of pre-wired cable blocks. Primary mating module 510161107. (May mate with other ITA modules, as well.)
-
Product
Potentiometer, Level Transmitter, Position Transmitter
Model TWP / TWP2
-
Kusam Electrical Industries Limited
• Aux. Power AC 85 ~ 265V or DC 85 ~ 300V• High Accuracy 0.1% RO at 23 ° C - 5 °C• Input / Output User Selectable• PC Plastic Case, DIN Rail or Wall Mounting• High Dielectric Strength (AC 1.5KV/Min, between Input / Output / Power)
-
Product
VTAC Patchcord, Receiver, SIM VTAC, 72", DACAR 636 Cable, Rosenberger Jack, 1 Position
7-142703731-072
VTAC Patchcord
VTAC Patchcord, Receiver, SIM VTAC, 72", DACAR 636 Cable, Rosenberger Jack, 1 Position.
-
Product
Cable Assembly, Receiver, TriPaddle, 20", 10 Position Combicon and 4 Position Omnimate
540295010101
Cable Assembly
Cable Assembly, Receiver, TriPaddle, 20", 10 Position Combicon and 4 Position Omnimate
-
Product
PCB Adapter, Receiver, QuadraPaddle, 192 Position, to NI PXI-2529 with six 20" cables
510150153
PCB Adapter
PCB Adapter, Receiver, QuadraPaddle, 192 Position, to NI PXI-2529 with six 20" cables
-
Product
Signal, Module, Receiver, CASS, 210 Position, J4, Right Angle PCB Mount
510113133
Receiver Module
Signal, Module, Receiver, CASS, 210 Position, J4, Right Angle PCB Mount.
-
Product
Coax Module, ITA, 20/26 GHz, 17 Position. For use with 20/26 GHz ITA contacts with SMA adapter
510108240
ITA Module
For use with 20/26 GHz ITA contacts with SMA adapter.Primary mating module 510104287.
-
Product
Signal / Micro Power/ Micro Coax, Module, Receiver, QuadraPaddle, iCon Series, 100/15 Position, loaded w/twin female contacts
510160112
Receiver Module
This module comes fully loaded with twin female contacts (p/n 610138200), iCon modules mount from the rear of the iCon/i1 receiver allowing installation and removal of pre-wired cable blocks. Primary mating module 510161107. (May mate with other ITA modules, as well.)
-
Product
Signal / 20-26 GHz / 75 Ohm HD, Module, Receiver, TriPaddle, iCon Series, 64/8 Position
510160115
Receiver Module
iCon modules mount from the rear of the iCon receiver and ITA and allow installation and removal of pre-wired cable blocks. Primary mating module 510161115. (May mate with other ITA modules, as well.)
-
Product
Vacuum, Module, ITA, 90 Series, 2 Port Positions, w/ M22.5x1.5 Tap
510108251
ITA Module
Primary mating module 510104260. (May mate with other Receiver modules, as well.)
-
Product
Antenna Position Tester
FTA
-
Fuzhou Fuguang Electronics Co., Ltd.
FTA series Antenna Position Tester is a convenient test instrument for planning, construction, maintenance and optimization of antenna system.
-
Product
4-Channel High Speed Position Comparison and Trigger Module
ECAT-TRG4
Trigger Module
The ECAT-TRG4 is EtherCAT slave module with high-speed position comparison trigger and encoder single redriver function, helping machine and equipment builders to use multiple triggers simultaneously for AOI, glue dispensing, display tests, and storage assembly applications.
-
Product
Signal, Module, Receiver, QuadraPaddle, iCon Series, 160 Position, loaded w/ twin female contacts
510160105
Receiver Module
Comes fully loaded with twin female contacts ( p/n 610138200).QuadraPaddle modules are molded on .100” (2.54 mm) centers to meet the need for high-density I/O.Primary mating module 510161101. (May mate with other ITA modules, as well.)
-
Product
Signal / High Power, Module, Receiver, TriPaddle, iCon Series, 4/4 Position
510160124
Receiver Module
Signal / High Power, Module, Receiver, TriPaddle, iCon Series, 4/4 Position.
-
Product
Vertical Hinged Mounting Frame, G2, 5U, 3 Position, (2 Blank Plates Included)
310113391
Mounting Frame
This G2 3-position Vertical Hinged Mounting Frames is for use with standard rack or PXI chassis. It attaches to flanges supplied by the chassis manufacturer and allows the receiver to bolt directly on the mounting plate. Special alignment hardware is not required.
-
Product
ITA, I2 Micro ICon, 120/12 Position Hybrid, With Oversized Backshell
410130115
ITA
The 30 degree U-shaped cable clamp allows ITA modules to be pre-wired before assembly and can hold cable bundles with an oblong bushing effective diameter of 1.80".
-
Product
Fixed Mounting Panel, G2, 5U, 3 Position, (2 Blank Plates Included)
310113395
Mounting Panel
The 19" rack mounting panel offers three mounting positions for the G2 receiver without the hinging feature and is beneficial in cases where you may want to restrict wiring or instrument access.
-
Product
Signal, Module, Receiver, QuadraPaddle, 90 Series, 192 Position, Fully Loaded w/ Twin Female Contacts
510150130
Receiver Module
Primary mating module 510151105. (May mate with other ITA modules, as well.)
-
Product
PCB Adapter, ITA, QuadraPaddle, 192 Position, to PCB-Mounted 2x68 Pin Female SCSI Connector
510109339
PCB Adapter
PCB Adapter, ITA, QuadraPaddle, 192 Position, to PCB-Mounted 2x68 Pin Female SCSI Connector.
-
Product
20/26 GHz/ 75 Ohm HD/ Coax, Module, ITA, iCon Series, 18 Position
510161114
ITA Module
Primary mating module 510160114. (May mate with other Receiver modules, as well.)
-
Product
AGPU Positive Connectors
-
Teledyne Marine AG Geophysical Products
Waterproof electrical connectors for high shock extreme applications.
-
Product
Isocratic Pumps - Single Headed, Positive Displacement Piston Pumps
ReaXus MX Class
-
The economical MX Class consists of single-headed, positive displacement piston pumps incorporating additional features for challenging applications. With pressure capability up to 5,000 psi, the MX Class can be used in both analytical and smallscale preparative HPLC separations. Further applications include demanding metering and dispensing, as well as Sample Injection, Infusion, or Cone Wash for Mass Spectrometers. Standard fluid path material is Stainless Steel.Features include available pressure monitoring with automatic pressure compensation, Pulse Dampener, integrated Prime-Purge Valve, interactive keypad control, and complete PC control and status through RS-232 and Micro USB 2.0 ports. Requiring minimal bench space for the performance, the MX Class will easily integrate into most workspaces.
-
Product
Positioning Products
-
NSI-MI offers a full spectrum of positioning products extending from ready-to-fit, single-axis units to completely integrated multi-axis positioning systems. Our products are used in various test and measurement, pointing/tracking, and other general purpose single/multiple payload positioning applications.
-
Product
Mounting Panel, I1, 6U, 4 Positions, With Slide Mounting (slide Kit Required)
310113547
Mounting Panel
The 6U Slide-Mounted Plate mounts to standard 19" racks and slides open to allow access to wiring between the instruments and VPC i1 Receivers. The 4 cutouts are spaced evenly across the panel. iCon cover plate sold separately (310 113 546). This mounting plate is designed to work with a slide kit and includes flanges and an instrument bracket. A slide kit is required for use.
-
Product
Signal/ Micro Power/Micro Coax, Module, Receiver, QuadraPaddle, iCon Series, 100/15 Positions, for crimp contacts
510160107
Receiver Module
Primary mating module 510161107. (May mate with other ITA modules, as well.)
-
Product
PCB Adapter, ITA, QuadraPaddle, 192 Position, To PCB-Mounted 2x96 Male SCSI Connector
510109591
PCB Adapter
PCB Adapter, ITA, QuadraPaddle, 192 Position, to PCB-Mounted 2x96 Male SCSI Connector
-
Product
ITA, I2 Micro ICon, 168 Position
410130101
ITA
The i2 Micro iCon ITA is capable of holding up to 168 QuadraPaddle contacts. Its sleek, 0.8” footprint increases the horizontal stackability. The 30 degree U-shaped cable clamp allows ITA modules to be pre-wired before assembly and can hold cable bundles with an oblong bushing effective diameter of 0.77 in. The removable cover allows easy access to wiring for maintenance and probing. Integrated spring locking tabs ensure even and secure engagement.
