Product

Near Field Probes 30 MHz up to 3 GHz

RF1 set

-

Langer EMV-Technik GmbH

RF1 set - Langer EMV-Technik GmbH

The RF1 near field probe set consists of 4 passive near field probes for making measurements in the development phase of E-field and magnetic field in the ranges of 30 MHz to 3 GHz on electronic assemblies. The probe heads of the RF1 set allow for measurements close to the electronic assemblies, e.g. on single IC pins, conducting paths, components and their connectors in order to localize interference sources. Field orientation and field distribution on an electronic assembly can be detected through a trained special use of the near field probe. The near field probes are small and handy. They have a sheath current attenuation and are electrically shielded. They can be connected to a spectrum analyzer or an oscilloscope with a 50 Ω input. They do not have an internal terminating resistance.

Product

Super 3.90 (111.00) - 16.00 (454.00) High Performance Lead Free Probe

LFRE-25I15-16

-

ECT

LFRE-25I15-16 - ECT

Current Rating (Amps): 8Average Probe Resistance (mOhm): 8Test Center (mil): 100Test Center (mm): 2.54Full Travel (mil): 250Full Travel (mm): 6.35Recommended Travel (mil): 167Recommended Travel (mm): 4.24Mechanical Life (no of cycles): 1,000,000Overall Length (mil): 1,300Overall Length (mm): 33.02

Product

Pipe & Duct Inspection Cameras

-

General Tools & Instruments

General Tools & Instruments

Pipe & Duct Inspection Camera are video inspection cameras with a probe long enough (roughly 70 ft.) to locate and identify an obstruction in a water or sewer line or HVAC duct by taking close-up video clips and photos of it. The P16PIP probe (also available separately) that comes with the DPS16 Pipe & Duct Inspection Camera has better camera lighting and optics and slightly better resistance to water than the P610-20PR probe that attaches to a recording or non-recording wet/dry inspection camera console.

Product

Battery Resistance Tester

BT-3915

-

Kongter Test & Measurement Co., Limited

BT-3915 - Kongter Test & Measurement Co., Limited

Regular test of battery internal resistance or battery conductance is essential for stationary batteries. It is also recommended by latest regulation of IEEE 450, IEEE 1188 and IEEE 1106. The excellent performance of BT-3915 for testing battery internal resistance and voltage will help you pick out the weak batteries and ensure their performance in short time measurement.

Product

Akron Abrasion Tester

UI-FT45

-

Unuo Instruments

UI-FT45 - Unuo Instruments

Akron Abrasion Tester is used to test rubber abrasion resistance and it is suitable for rubbers with a hardsness in the range of 55-85IRHDx.

Product

CP TEST STATION

T-1

-

Tinker & Rasor

T-1 - Tinker & Rasor

3 hole terminal board3 binding postsClear terminal boardSeven colors from stockFits 1.6" OD riser pipeUV stabilized color protectionHigh impact resistanceFire resistant"Easy Grip" top for easy opening with gloves"Anti-Spin" gasket prevents twisting

Product

Master Oscillator Multiplexer

MOX Series

-

EM Research, Inc.

MOX Series - EM Research, Inc.

*Low phase noise OXCO *Interface between VSAT Modems and Frequency Converters *Robust housing is gasket sealed for weather resistance *OCXO iwth low G-sensitivity available *Single or dual multiplexer *Single or dual bias tee *Available in various OCXO frequencies: 10, 50, 100, 120 MHz

Product

Circuit Testing

-

Greenlee Tools

Greenlee Tools

Circuit testing is generally the first diagnostics performed on an electronic device that has stopped working. Circuit testing determines whether electrical current can travel through a circuit. Resistance, measured in ohms, is the measure of the resistance in a circuit.

Product

Beam Lead PIN Diodes

-

Naprotek, LLC.

Naprotek, LLC.

The SemiGen SBL 2000 series Beam Lead PIN Diodes feature fast switching speeds at both low capacitance and resistance. Beam Lead PIN Diodes have high levels of mechanical strength and stability during assembly. These diodes are suitable for microstrip or stripline circuits as well as circuits requiring high isolation from a series of mounted diodes such as multi-throw switches, phase shifters, attenuators and modulators.

Product

96-Pin 1.27mm Pitch Male Breakout DIN Rail

40-967-096-M

-

Pickering Interfaces Inc.

40-967-096-M - Pickering Interfaces Inc.

Connector blocks provide a convenient method of termination without the use of custom cabling. However, a higher resistance path, lower capacity ratings and lower voltage ratings are typical. This termination option is capable of accepting heavy duty connection wires and uses rising clamp screw terminals to minimize the danger of copper strand damage. Users should care take to protect the termination and provide a suitable method of restraining the cables.

Product

Pokit PRO

-

Pokit Innovations

Pokit Innovations

Pokit Pro is an all-in-one multimeter, oscilloscope and logger with unprecedented portability, accuracy and versatility.Pokit Pro connects seamlessly to the smartphone app to measure a wide range of parameters. These include voltage, current, resistance, capacitance and temperature. It also provides continuity and diode checking.

Product

Safety Analyzer

SA-2000

-

BC Group International Inc.

SA-2000 - BC Group International Inc.

The BC Biomedical SA2000 Features: AAMI Load Earth / Ground Lead Resistance Earth/Ground Leakage Current Chassis Leakage True RMS Measurements 85 to 265 VAC Operation.

Product

Clamp Meters

-

Morris Products Inc.

Morris Products Inc.

oltage DC 600V with basic accuracy ±(0.5%+5d)Voltage AC 600V with basic accuracy ±(0.8%+5d)Current AC 400V with basic accuracy ±(2.50%+6d)Slimline Electric Clamp Meter Resistance 20M ohms with basic accuracy ±(1.0%+4d)Continuity buzzer sound at 300 ohmsDiode test current 0.3mA; Open circuit voltage 1.5VAccessories: test leads, carrying case, 2(AAA) 1.5V batteriesSize:8-1/16"L x 2-3/4"W x 1-1/2"HSlimline Electric Clamp Meter Weight: 7oz.2000 LCD display countsDecimal Point ReadingsDisplay with backlightData holdMax holdAuto power offLow battery indication

Product

Electrical Measurements Test

-

Aero Nav Laboratories, Inc.

Aero Nav Laboratories, Inc.

The tests are performed to measure and collect data from electrical and electronic parts using various measurement methods including, but not limited, to the following: capacitance, resistance, winding resistance, insulation resistance, magnetic permeability, power input, and quality factor Q.

Product

Micro-Ohmmeter and Loop Resistance Tester

LRT 6000

-

ATEQ Aviation

LRT 6000 - ATEQ Aviation

LRT 6000: The right solution for impedance resistance measurement in compliance with all aircraft specifications on plane, helicopter, rocket, army vehicles for both production andmaintenance. It is a very easy-to-use and versatile instrument. Its ergonomics allow the user to use it either placed on the ground or across one's shoulder or chest. Awide back-lit LCDdisplay combinedwith an intuitive keyboard ensures simple and easy operation.

Product

LED Tester For Chip And Wafer

-

WeiMin Industrial Co., Ltd.

WeiMin Industrial Co., Ltd.

Electrical Testing: Forward：VF,DVF,VFDReverse：VZ,IROptical Testing: can test LOP in cd/mcd/W/mW/lm... from different optical componentsWavelength λp,λd,λc,hw,purity,(x,y),CCT,CRIFour-wire measurement and contact resistance in case of deviation.Auto polarity identification and preheat function.Compatible mechanical interface.Optional ESD static test system or polycrystalline test system

Product

positilt® Inclination Sensors

-

ASM GmbH

ASM GmbH

Inclination sensors measure inclination between 0 and +/-180 in a non-contact, wear-free and absolute way. Utilizing the MEMS technology, these sensors are extremely resistant to shock, vibration and dirt, and are therefore well suited for outdoor applications. Various sensor enclosure designs open possibilities for many different types of applications.