Illuminators
See Also: Illumination, Illuminance Meters, Illuminance
-
Product
Pen-Style Meter
MT-1630
-
Compact in size, light in weight and simple in usePenlight illuminates brightly the point to be measured, even in dark placeUnique protection mechanism for the test prod for safetyAuto power off function saves the battery life
-
Product
Light Measurement Technology
-
High-precision photometric instruments and systems used to measure quantities like illuminance, luminance, and irradiance.
-
Product
Versatile Test Stand
VTS-2100
-
Applied Scientific Instrumentation
*Base is a Breadboard on 25 mm centers tapped for M6 screws with threaded holes for risers for TE/TI-2000, TE-300, IX-71/81, DMI, and MS-2000 stages.*Base feet provide vibration isolation.*Z riser is adjustable on pillar blocks.*Z motion from LS-50, LS-100, or LS-150 linear stage.*Z illumination can use LED, LED and a Condenser (from below), or fiber illumination (from above).*Observation is with a Modular Infinity Microscope.
-
Product
Operation
-
ifm Operation products - touch sensors, illuminated pushbutton with touch surface in M22 design, AS-interface illuminated pushbutton modules, AS-interface E-stops
-
Product
Spectral Irradiance / Illuminance Calibration Standards
-
Standard lamps calibrated in illuminance and spectral irradiance. Traceable calibrations in the wavelength range from 200 nm to 2500 nm.
-
Product
Biconic Logarithmic Periodic Antennas
Stacked LPDA
-
The stacked Logarithmic Periodic Dipole Antenna consists of two ordinary Log.-Per. structures. The excellent characteristics (flat gain over a large bandwidth, low SWR) of the ordinary Log.-Per. designs could be maintained using the stacked LP design. The stacked design helps to focus the directional pattern of the H-plane somewhat, resulting in a typical gain improvement of ca. 2-3 dB compared to an ordinary LPDA. This is especially important for immunity testing, where a maximum fieldstrength and a good field uniformity is required. The beamwidth in the E-plane and the H-plane are nearly identical, providing an optimised illumination of the EuT with minimised ground reflection influence. Further the STLP 9128 C has an excellent cross-polar rejection.
-
Product
Spectral Color Illuminance Meter
HPCS-320
-
Hangzhou Hopoo Optoelectronics Technology Co., Ltd
spectral color illuminance meter
-
Product
Compact Linear Pulsed Non-Lensing LED Backlight
Vitek L36
-
Compact module of linear pulsed illumination, consisting of 12 high-speed non-lensing LEDs and a control circuit that limits the maximum duration and minimum duty cycle.
-
Product
Light Sources
-
For applications such as transmission, absorption, and reflection, illumination sources are needed. Avantes offers a wide range of different types of light sources, to suit your specific application needs. An overview of the different types of light sources can be found below.
-
Product
Lux Meters
-
Shenzhen Everbest Machinery Industry Co.,Ltd.
Unit of illuminance and luminous emittance, measuring luminous flux per unit area. It is equal to one lumen per square metre. In photometry, this is used as a measure of the intensity, as perceived by the human eye, of light that hits or passes through a surface.
-
Product
Fuse Tools
-
*Three functions in one tool, voltage detector, fuse puller and spotlights*Single range 4kV to 12kV line-to-line voltage detector*Provides an audible and visual alarm when voltage is detected*Bright white LED spotlights provide illumination in dark situations*Compact and lightweight solution for added safety and flexibility
-
Product
Economical LED Display for Remote Annunciator Applications
AN-3100D-LC
-
LED Illumination for long life, low power Laser Printed window Legends Compact Size Barrier, screw terminal connection Panel or 19" Rack Mounting 4 Windows Sizes: 3x3, 1.5x3, 1x3, 1.5x1.5 Selectable Window Colors: White, Red, Blue, Green Amber Built-in Test Pushbutton option
-
Product
Calibration Light Source
CAL1
-
Image Engineering GmbH & Co. KG
The one light source solution in the field of camera characterization and calibration. CAL1The CAL1 calibration light source is designed to characterize and calibrate cameras in the lab or on the production line. Its compact design consists of one iQ-LED element in a 0.3 m integrating sphere that illuminates a 70 mm opening. Because of the non-reflective special diffusor filter on the sphere opening, a uniformity of more than 98% could be reached
-
Product
Post Dicing
-
Camtek offers dedicated inspection and metrology solutions for dicing-related processes, ensuring the reliability of the end product. Camtek developed new capabilities to address new dicing technologies such as Stealth and Plasma dicing using new algorithmic and technologies such as Back Light illumination, as well as various handling solutions.
-
Product
Pulse Air-Gun Ionizers
EC-G Series
-
Panasonic Industrial Devices Sales Company of America
With the new Pulse Air-Gun Ionizer from Panasonic, operators can comfortably neutralize static electricity while manually cleaning. The Pulse Air-Gun’s light-weight, ergonomic design combined with an oil and heat-resistant 2m cable makes it ideal for use at the production line.The Air-Gun Ionizer is equipped with a white LED on the front of the Gun to illuminate target objects. It has three air emission modes: long pulse, short pulse and continuous emission. Ionized air can be emitted at high pressure (range 0.05 to 0.50 MPa), neutralizing static charges and removing dust simultaneously and swiftly.
-
Product
Photodiodes
-
Photodiodes are a type of detector, devices that generate an electrical signal when illuminated by light. ACP offers a variety of different types of photodiodes, including InGaAs PIN photodiodes.
-
Product
Front Side Illuminated Sensor with Pixel Size of 5.3µm with NIR Spectrum Sensitivity
Ruby Family
-
The EV76C660 and EV76C661 are members of Teledyne e2v’s Ruby family of CMOS imaging sensors. These breakthrough devices provide sensitivity and performance beyond that considered possible on a front side illuminated sensor with a pixel size of 5.3µm, Quantum Efficiency (QE) of over 80% and excellent sensitivity and performance in the near-infrared (NIR) spectrum (>50% at 850nm). This significantly reduces system illumination costs, or enables very low-light imaging in outdoor camera applications.
-
Product
Photometric Probes for Illuminance
LPPHOT03… Series
-
The probe LPPHOT03 measures illuminance (lux), defined as the ratio between the luminous flux (lumen) passing through a surface and the surface area (m²). The spectral response curve of a photometric probe is similar to the human eye curve, known as standard photopic curve V(λ). The difference in spectral response between LPPHOT03 and the standard photopic curve V(λ) is calculated by means of the error f’1.
-
Product
PHOTO-2000μ Μ-LUX Meter
-
Hangzhou Everfine Photo-E-Info Co., LTD
The PHOTO-2000μ is designed for low illuminance testing above 10-6lx. Using the international leading low-lux detection technology, the measurement accuracy is high, good stability, often used in metering laboratory, physics laboratory, metrology laboratory and other related scientific research, engineering, product inspection and other occasions.
-
Product
Fiber Microscope
WL-C400S
-
The WL-C series fiber microscopes use coaxial illumination to provide users with maximum detail. It easily can detect the finest scratches and contamination, making it ideal for critically inspecting polish quality.
-
Product
9VT Neon Tube Tester
-
West Coast Custom Designs, LLC
When the antenna and/or the Disc are touched to the tubing wall or electrode wires, the tester will cause the viable tubing to illuminate.
-
Product
Light Meters
LXP-2
-
The digital light meter is a precision instrument used to measure illuminance (Lux, footcandle) in the field. It is meet CIE photopic spectral response. It is fully cosine corrected for the angular incidence of light. The illuminance meter is compact, tough and easy to handle owing to its construction. The light sensitive component used in the meter is a very stable, long-life silicon photo diode and spectral response filter.
-
Product
Sensors
2D Fiber Probe
-
Smallest and most accurate probe for 2D evaluations world-wideMechanical fiber sensor with optical evaluation from image processorTransmitted light and self illumination modeLowest contact force of 1 µNSphere diameters down to 25 µmControl and evaluation software for fully automatic measurements
-
Product
Photometric Radiometric Transmitters
HD2021T Series
-
The serie HD2021T allows to convert photometric and radiometric quantities, such as illuminance (Lux) and irradiance (W/m²) in the UVA, UVB, UVC spectral regions and in the 400 … 1050nm band, into a 0 …10Vdc voltage signal. The series is suitable to be installed either indoor and outdoor.
-
Product
DMX Tester
DMXter 2U
-
Here's the DMXter 2U, a Lil'DMXter2 for bolted down applications. All the hardware and software features of the standard Lil'DMXter2 in a 2U 19" rack box, plus many new features.The user controls, the XLR connectors, and the LED illuminated LCD display are on the front panel. The 2U is equally at home as the back up controller in a theatre or TV studio, running a trade show booth, the background lighting for themed entertainment or as the built in test controller in a touring show DMX distribution rack. Its increased I/O capabilities will make it a useful addition to your test bench.
-
Product
Fiber Identifier
-
Fiber identifier is an essential installation and maintenance instrument which can identify the optical fiber by detecting the optical signals transmitted through them,during this process the fiber optic identifier generate no harm or damage to the fiber cable and it do not need opening the fiber at the splice point for identification or interrupting the service.This fiber identifier detects frequency tones at 270Hz, 1KHZ, 2KHZ, when traffic is present on the fiber under test, an audible tone can be heard. In the meantime, it can identify the traffic direction that indicated by LED with illumination.
-
Product
Dual Illumination Inspection Scope
0700-7950
-
KITCO Fiber Optics introduces our new 200X dual illumination inspection scope.
-
Product
Illuminance Probe
LP471PHOT
-
Photometric probe for measuring the ILLUMINANCE, spectral response according to the photopic curve, class B according to CIE N° 69, cosine correction diffuser.
-
Product
AS-Interface I/O Modules
-
*ClassicLine: I/O modules for field applications with quick mounting technology*CompactLine: I/O modules for field applications for harsh environments*SmartLine: I/O modules for control cabinet installations*ProcessLine: IP69K stainless steel modules for use in high pressure cleaning applications*Compact high-visibility illuminated pushbutton modules
-
Product
AA Neon Tube Tester
-
West Coast Custom Designs, LLC
When the antenna is touched to the tubing wall or electrode wires, the tester will cause the viable tubing to illuminate in a pulsating manor. This pulsing feature is fantastic for testing neon in bright sunlight as it is easier to see the light when flashing.
