-
Product
Opacimeter on CONNECT Trolley for Measurement of Diesel Vehicles
MO CT | VP 135045
-
Maschinenbau Haldenwang GmbH & Co. KG.
The MAHA Opacimeter on CONNECT trolley is used for the measurement of diesel vehicles. The smoke opacity is tested and diagnosed in a time-saving and trouble-free manner in a partial flow procedure during free acceleration or under load of the engine. Rapid readiness for measurement and precise measurement results are the distinguishing features of the MAHA Opacimeter. Type-tested according to PTB requirements 18.09.
-
Product
LCR Meter
Hantek1832C/Hantek1833C
-
Qingdao Hantek Electronic Co., Ltd.
Hantek1832C/Hantek1833C handheld LCR Meter is a portable handheld measuring instrument to measure the parameters of the component such as inductance, capacitance, resistance and so on.small volume, powered by 5V lithium battery, it can meet the requirements of desktop LCR application, and can also be applied to flow measurement and handheld measurement.
-
Product
Flow Control Set Up Using PID Controller
ULP-25O & ULP-25T
-
Unitech Scales And Measurements Pvt. Ltd
Flow Control Setup Comprises of a Orifice with DPT to measure flow Rate. The flow of water is controlled by Control Valve with pneumatic actuator. I to P converter is provided to control the actuator. Rotameter is provided to measure actual flow rate. The system is mounted on a table top model with all necessary piping.
-
Product
Signal Conditioners
-
SPECTEC Innovative Sensor Solutions
SPECTEC's frequency to current and frequency to voltage converters for passive and active magnetic speed sensors and all digital speed sensors fit in a variety of explosion-proof elbow enclosures or can be DIN rail mounted via special adapters. These signal conditioners change the sinusoidal input to a linear current or voltage output respectively. The 4-20 mA and 10-50 mA signal converter has many applications in the flow industry. The frequency to voltage converters provides either a 0 to 5 V (TTL) or 0 to 10 V output.
-
Product
Fuel Hose Assembly Tester - Basic, USAF
9901-10FHT
-
The basic fuel hose assembly tester is utilized by those users who do not require the complete 9201A test system which includes all test adapters and components required by U.S. Air Force PD 89MMI638. The 9901-10FHT however includes the identical test pump, manifold and controls and with larger valves, ports and fittings for increased fluid flow, is designed for the identical mission of testing fuel hose assemblies. Maximum pressure is 1000 psi allowing better control resolution at lower test pressures.
-
Product
Water Specialties Propeller Meter
-
The Water Specialties Propeller Meter is the best choice for measuring clean water flows in municipal and industrial applications. The meter is engineered to deliver superior performance, low maintenance and unsurpassed durability. Meter materials and performance meet or exceed AWWA standard C704/92.
-
Product
Stimulation/Fracturing
-
Atmospheric Rotational, Pressurized Rotational, In-Line Viscometers, Friction Flow Loop, and Formation Response.
-
Product
Building Physics
-
* For determining the heat flow density up to max. 150°C.* Application-oriented designs, consisting of a meander ofopposing thermocouples that are embedded in a substrate.* In case of thick substrates no lateral circulation of the heat flowbecause of sufficient meander shell zone.* Software for k value measurement, see chapter Software
-
Product
CEMS
FMD 09
-
IMR Environmental Equipment, Inc.
The continuous measurement of velocity and temperature of gas flows is much important at operation of a system with flowing gases (e.g. hall outlet air, exhaust etc.).
-
Product
Industrial Communication
-
Reliable data flow and transparent communication across all production processes have become indispensable in automation. The main goal of industrial communication is to integrate all plant areas from the control to the field level in a networked system. Because consistent and powerful data networks increase the availability and efficiency of machines and systems.
-
Product
Air Speed Micromanomenter-Thermometer Data Logger
HD2134P.2
-
Micromanometer-Thermometer Data Logger for air speed and flow rate measurement by means of Pitot tubes
-
Product
Turbine Flowmeters with Analog Output
CT600R, CT800R Analogue Series
-
High accuracy turbine flow meters with built-in loading valve and analogue output, for use with hydraulic fluids. Flows up to 800 lpm (210 US gpm).
-
Product
Digital In-Duct Mini Vane Anemometer
DAFM4
-
UEi Test & Measurement Instruments
The DAFM4 is the tool for all your air flow measurement needs. With the DAFM4 you can directly capture air temperature, relative humidity and air velocity. It also calculates wet bulb temperature, dew point temperature and air volume. Enter duct dimensions for live or timed average of air flow in CFM (or CMM), or use the effective area of a grill for outlet volume measurements. Air volume is displayed in real-time, or choose a timed average with start/ stop capabilities to traverse ductwork.
-
Product
*Laser Thermal Power Sensors
-
Thermal sensors have a series of bimetallic junctions called a thermopile. Radial or axial heat flow through the sensor creates a voltage proportional to the power absorbed as it flows through the thermopile. The reading is not dependent on the ambient temperature since only the temperature difference is measured and not the absolute temperature. The thermopile elements are so arranged that the reading is almost independent of beam size and position. Generally, Ophir specifies ±2% or better uniformity of reading over the surface.
-
Product
High Speed & Precision Pressure Insensitive Mass Flow Module
D700MG
-
Critical semiconductor manufacturing processes continuously desire precision gas flow control devices that enable both future innovation, and lab to fab transition of leading edge memory and logic device. HORIBA's propose the new pressure based MFC D700MG, the upper compatible model of the D500MG to support customer’s challenges.
-
Product
Thermal Mass Flowmeters
-
ABB’s thermal mass flowmeters are suitable for all industrial and test rig applications that demand quick and precise gas measurement. The flowmeters directly indicate the mass flow or normalized volume flow of gases without any additional pressure and temperature compensation. They have an impressively high accuracy, short response time and a very wide flow range with virtually no loss of accuracy even at the lowest flow rates.
-
Product
Hand-held meter for humidity / temperature
OMNIPORT 30OMNIPORT 30
-
The state of the art hand-held for precise measurement of various physical quantities, such as, humidity, temperature, dew point, air velocity, volumetric flow, air pressure. The numerous probes all incorporate high quality sensors developed by E+E and offer a total of 22 measurands.
-
Product
Motor Starting & Control Resistors
-
Motor Starting Resistors are used to reduce the voltage at the motor terminals and also decrease the starting current. Motor Starting Resistors are necessary because the self resistance of a motor armature is very low. When the voltage is first applied, excessive current will flow. For limiting this current, since there will be no resisting back electromotive force (emf),some series resistance can be added to the armature windings.
-
Product
5CH Gas Mixer
G-MIX 5CH
-
G-MIX is an integrated versatile system that can be easily employed to set up countless gaseous mixtures, the gaseous flows are accurately controlled by five MFC (Mass Flow Controller), every MFC has stored inside its memory the calibration tables for 10 different gases.
-
Product
Hydraulic Power Units
3520 Series
-
The 3520 Series HPUs are used to provide varying flow rates of hydraulic oil at high pressure, to operate Instron® Dynamic and Fatigue and Multi-Axial Testing Systems. In the lower flow region, the 3520 Series includes the following model variants:
-
Product
4AO/4DI Modbus RTU Remote I/O
ND-6124
-
The NuDAM modules provide direct communications with a wide variety of sensors; perform signal conditioning, scaling, linearization and conversion; can acquire measurements of temperature, pressure, flow, voltage, current; and handle multiple digital signal types broadly used in IoT and other industrial applications, such as facility monitoring, environment monitoring, and industrial process control. The new ND-6117, ND-6124, ND-6150, and ND-6160 modules feature Modbus/RTU as the best remote data transmission protocol, which provides customers a comprehensive product offering.
-
Product
HPLC Pumps
MX Class
-
Further applications include demanding metering and dispensing, as well as Sample Injection, Infusion, or Cone Wash for Mass Spectrometers. Standard fluid path material is Stainless Steel. With flow rates up to 10 mL/min, these pumps can tackle the majority of demanding laboratory applications.Features include pressure monitoring with automatic pressure compensation, Pulse Dampener, integrated Prime-Purge Valve, interactive keypad control, and complete PC control and status through RS-232, micro-USB 2.0, and Ethernet serial communications. Requiring minimal bench space for the performance, the MX Class will easily integrate into most workspaces.
-
Product
Low Pressure Variable Reluctance Sensor
DP45
-
The Validyne DP45 Very Low Differential Pressure Transducer is designed for extremely low pressure measurement in the order of 1 inch water column. This instrument is used extensively in connection with flow measurements where dynamic response at low flow rates is required. Dynamic line pressure effects are minimized due to the combination of low internal volume, symmetrical construction, and small volumetric displacement inherent in the DP45 design.
-
Product
M-Class System
ACQUITY UPLC
-
The ACQUITY UPLC M-Class System delivers the performance you expect from nano- to microscale separations with the usability of an analytical-scale UPLC system. Each part of the system was designed and tested to deliver the right flow for the right column. The ACQUITY UPLC M-Class System provides excellent performance with overflow rates from 200 nL/min to 100 µL/min and a range of column inner diameter (I.D.) from 75 µm to 1.0 mm.
-
Product
Opacimeter for the Measurement of Diesel Vehicles
MO / MAHA OPAZIMETER | VP 135043
-
Maschinenbau Haldenwang GmbH & Co. KG.
The MAHA Opacimeter is used for the measurement of diesel vehicles. The smoke opacity is tested and diagnosed in a time-saving and trouble-free manner in a partial flow procedure during free acceleration or under load of the engine. Rapid readiness for measurement and precise measurement results are the distinguishing features of the MAHA Opacimeter. Type-tested according to PTB requirements 18.09.
-
Product
Electromagnetic Water Meter
WATERFLUX 3070
-
WATERFLUX 3070 is the first battery powered water meter for the drinking water industry that is capable of measuring flow, pressure and temperature with one sensor. Communication via Modbus RTU or pulse.
-
Product
EDA Solutions
-
Today, Dolphin Integration's EDA Solutions can be used as:*The front-end design solution of choice, for any custom design flow, coupled with third-party back-end solutions. Such a setup is ideal for small to medium size companies who target using affordable state-of-the-art design solutions with no compromises on performances or innovation.*Point-products to complement existing design flows as Missing EDA Links for specific needs. Such an approach is ideal for companies with corporate agreements for full CAD flows from major vendors who wish to benefit from the innovations of our EDA solutions.
-
Product
Traversing Probe
TP 1000-20
-
Advanced Thermal Solutions, Inc.
The TP 1000-20 is a stainless steel traversing probe designed for measuring air velocity and temperature. The probe is used to obtain velocity and temperature profiles at different locations in the same plane. The small sensor has a high rate of response, making it ideal for high-speed flow measurement. The sensor requires support for traversing.
-
Product
Field-installation Type Color Meter (Four-wire Transmission)
HU-200CL
-
HU-200CL connects flow through color detector Cl-20 and measures color and turbidity in the sample water. Suitable for monitoring purified water.
-
Product
Paddlewheel Flow Meters
-
Sensing, monitoring and control in one simple system, view the different options to get the right system for your application. Read our guide If you want to learn more about Paddlewheel Flow Meters
