Broadcast Monitors
-
Product
TDR Structural Health Monitoring
-
Material Sensing & Instrumentation
MSI Time-Domain-Reflectometry (TDR) Structural-Health Monitoring probes the structural health of a composite part by propagating a fast electrical pulse along a distributed linear sensor which has been fabricated directly in the laminate. The sensor is formed from the native graphite fibers already used in composite manufacture, and constitutes zero defect. Fibers are patterned into a microwave waveguide geometry, or transmission line, and interrogated by a rapid pulse as shown below. Structural faults along the line cause distortions in waveguide geometry, producing reflected pulses similar to radar. Cracking, delamination, disbonds, moisture penetration, marcelling, and strain are all detected by propagation delay, for sensor lengths up to several meters.
-
Product
Single channel Motor Insulation Monitor
-
The SURETECH Motor Insulation Monitor measures insulation resistance to earth of electric motors when themotor stops. Motors running from mains (380 / 220V) and higher voltages up to 6.6kV can have their insulationcontinuously monitored.
-
Product
Advanced IR Gas Analyzer For Process Monitoring
T-Series
-
T-Series Inline Gas Analyzer improves gas measurement accuracy over the traditional non-dispersive infrared (NDIR) analyzers using Tunable Filter Spectroscopy (TFS™), a spectroscopic scanning technique capable of generating slices of spectra in the infrared region. Each scan produces an absorption spectrum which is used to identify compounds and provide concentration values. TFS technology improves gas identification accuracy and selectivity by subtracting out spectra from interferent gases within the same infrared regions. This spectral processing capability also provides multi-component measurement.
-
Product
Granville-Phillips® 835 Vacuum Quality Monitor System
-
The Granville-Phillips® Series 835 Vacuum Quality Monitor (VQM™) combines the highest performance gas analysis technology with intelligent functional design that transforms complex measurement into actionable information. The 835 VQM is the world's fastest, lowest power mass spectrometer with full data collection, spectral deconvolution, and data logging at 85 ms capture rates for the full 1-145 amu measurement range or 125 ms for 1-300 amu.
-
Product
Diode Temperature Monitor
SIM922
-
Stanford Research Systems, Inc.
The SIM922 Diode Temperature Monitor and the SIM923 Platinum RTD Monitor are designed to measure four sensors simultaneously. Based on the modular SIM platform, they provide high-performance and multiple-channel capability in a small footprint.
-
Product
Touchscreen Monitor
TREK-306P
-
TREK-306P is designed for in-vehicle and harsh environments with ONE click connector design, providing operational reliabilty and efficiency.
-
Product
VoIP Monitoring and Testing Tool
SIP Tester™
-
StarTrinity SIP tester™ is a VoIP load testing tool which enables you to test and monitor VoIP network, SIP software or hardware. It is able to simulate and passively monitor thousands of simultaneous incoming and outgoing SIP calls with RTP media, analyze call quality and build real time reports.
-
Product
Test Cell Vibration Monitoring System
-
The Test Cell Vibration Monitoring System is a complete package for monitoring dyno vibration levels generated during engine testing. This system was design to prevent catastrophic dyno failures.
-
Product
Condition Monitoring
-
Condition Monitoring by TP - generator, turbine, and transformer condition monitoring
-
Product
Noise Monitoring Kit
NMS044 SoundAdvisor
-
Larson Davis has created a new standard for portable noise monitoring systems by making the SoundAdvisor Kit Model NMS044 completely wireless with solar charging and 4G wireless while keeping it truly portable. The SoundAdvisor noise monitor includes everything needed for a noise monitor (powered by SoundAdvisor Model 831C Class 1 sound level meter) that can run indefinitely while remaining connected to the Internet making your meter and your data always readily available.
-
Product
Low-PIM, Low-Power Filter Solutions for Monitoring Broadband Emissions
-
Bandpass/Bandstop, Notch, and HighpassCompact Design for Rack Mounting of Several BandsSuitable for Monitoring Emissions from Semiconductors,TX/RX Chipsets, SAW/BAW Filters, Cell Phones,Printers, PDA’s, etc.
-
Product
True Flat Gaming Monitors
-
ADLINK offers a comprehensive range of 27-inch and 32-inch true flat monitors. The GM Series is available as open frame and LED-framed monitors for embedded use or gaming cabinet mounting, and with touch and non-touch options to meet your interactivity needs. ADLINK's gaming solutions offer high-performance platforms, powerful GPU, I/O, and security accessories, while enabling seamless integration of customizable monitors.
-
Product
Charged Plate Monitor
Model 280A
-
Simco-Ion’s Model 280A incorporates enhanced circuitry that enables it to more accurately measure the performance of high frequency AC ionizers, as well as pulsed DC ionizers and steady-state DC ionizers. The Model 280A can be used as a portable CPM and is capable for of up to 6 hours of operation on the internal battery before recharge.
-
Product
IP Video Stream Monitoring Probe
TSM Probe
-
The Mividi TSM Probe is a compact system that runs Mividi TSM100 video streaming monitoring software and TSM Web remote management software on an Intel NUC PC. It receives data via IP interface and supports most common streaming protocols including TS over UDP, RTP, HTTP, HLS, RTMP, RTSP and MMS. The size of the device is only 4.5 x 1.9 x 4.4 inches, and it can be used for remote monitoring of IPTV and OTT video services in the proximity of customers.
-
Product
Clamp type AC Current Sensor／for Power Monitor
ZCT-40P
-
MULTI MEASURING INSTRUMENTS Co., Ltd.
*AC 0.1A～500A*Current measurements of feeder
-
Product
Standard Emission Monitoring System
CEMS-2000
-
CEMS-2000 is a multi-gas monitoring system aimed to continuously and reliably measure emissions from various industrial combustions. The adoption of the hot-wet extractive method avoids the loss of content during sampling. The system is extendable with additional parameters upon request. All output signals proceed through the data acquisition system and then upload to the DCS or environmental authority server.
-
Product
Ammonia Monitor
Chillgard® 5000 Ammonia Monitor
-
The Chillgard 5000 Ammonia Monitor accurately detects ammonia gas leaks as low as 10 ppm for early notification, keeping your plant safe according to ANSI/IIAR and EN 378.
-
Product
Waveform Monitors
LV5600
-
The LV5600 is a hybrid-type waveform monitor compatible with 4K/HD/SD SDI signal and IP signal.
-
Product
High Speed Dielectric Cure Monitor
LTF-631
-
The LTF-631 High Speed Dielectric Cure Monitor is designed for the study of rapidly reacting materials in research and development, quality assurance/quality control, and manufacturing applications involving thermoset materials such as resins, composites, paints, and coatings.
-
Product
Optical Channel Monitors
-
DiCon's Optical Channel Monitor is an advancedoptical subsystem, with integrated tunable optical filter, that automatically scans a DWDM network and reports the power of each channel. Network performance is monitored and reported in real time. Feedback from the Optical Channel Monitor can be used to optimize optical power levels, identify performance drift, and verify system functionality. An optional integrated optical switch allows up to 12 separate input ports to be monitored sequentially.
-
Product
Tempurature Monitoring System
IQT-Meter
-
A flexible and economical temperature monitoring system, the IQT features extensive memory and graphic display of temperature history. Similar to the IQM, the IQT System offers software for uploading the temperature data to a P.C. through its serial port. The temperature history can then be displayed with respect to time
-
Product
System Monitor 3 Gen (SysMon) Fix Mounted
041-039
-
The SysMon 3 Gen is a platform-independent system monitoring unit which monitors- and, if necessary, controls - the internal parameters of a System Platform such as voltages, temperatures, digital inputs and fan speeds.
-
Product
PMAC 3000 Process Monitor and Control instrument
90424
-
The PMAC 3000 is a multi-functional Process Monitor and Control instrument, designed to operate with Sensor Developments Inc. Auto-ID sensors. Model 90424 has been enhanced to support quadrature encoders. This functionality is supported via Auto-ID and third party sensor programming. For easy verification, the encoder version will show the extension “E” when the software version number is displayed at power up.
-
Product
Military Monitoring Systems
-
Antenna Technology Communications, Inc.
ATCi provides several products and services designed specifically for Military/ Government applications. Package offerings include our all inclusive Warrior Package, encrypted data, video and voice transmission solutions as well as mobile trucks and trailers that allow ubiquitous satellite and cellular field services.Call ATCi today for a Capabilities Presentation.
-
Product
Toxic Multi-Gas Meters, Monitors
-
For handheld & long-term toxic gas measurement and logging
-
Product
Ecosystem Monitoring
-
LI-COR provides solutions to monitor the core processes of an ecosystem—light, plants, soil, water, and atmosphere—and research their interdependencies.
-
Product
SparkFun Single Lead Heart Rate Monitor
AD8232
-
The AD8232 SparkFun Single Lead Heart Rate Monitor is a cost-effective board used to measure the electrical activity of the heart. This electrical activity can be charted as an ECG or Electrocardiogram and output as an analog reading. ECGs can be extremely noisy, the AD8232 Single Lead Heart Rate Monitor acts as an op amp to help obtain a clear signal from the PR and QT Intervals easily.
-
Product
Power Quality Monitoring Terminal Detection Platform
PQC1650
-
PQC1650 power quality terminal detection platform is a test system specially designed for power quality terminals. It can fully complete the power quality test method and accuracy test of power quality terminals.
-
Product
Surface Contamination Monitors
-
Small-sized devices for measuring the ambient dose equivalent rate and the ambient dose equivalent of X-ray and gamma radiation, as well as measuring the flux density of beta particles (AT6130).
-
Product
Dust Monitoring System
CDMS-1000
-
CDMS-1000 is designed with light scattering technology for continuous real-time measurement of particulate concentration along with noise and meteorological parameters. This combination consists of a particle analyzer, camera, sound level meter, and GPRS module.
