Amateur Radio
communication on 26 bands spaced from 1.8MHz to 275 GHz.by liscensed amateur operators (Hams).
-
product
Ultra Low Power Radios
IoT
IEEE 802.11b/g/n-compliant Wi-Fi Radio (2.4 GHz)Ultra-low-power hostless Wi-Fi IoT Module features QCA4010 RadioSingle Stream System (1x1), 20 MHzIntegrated RF front end and PCB trace antennaHostless IoT application development platform with large internal memoryUART AT command set for optional external MCU hostAllJoyn supportWi-Fi Protected Setup SupportIPv4 / iPv6, TCP and UDP Protocol Supported on Chip, Offloading the Host ControllerIdeal for cost effective Internet of Things (IoT) Applications
-
-
product
Radio Module (2x2)
SX-PCEAN2
This SX-PCEAN2 is a dual band PCI Express wireless module, featuring two stream MIMO technology and industrial temperature support with throughput up to 300 Mbps. It is an ideal solution for high performance applications based on the NXP i.MX6 platform.
-
product
Microwave Radio
The transmission of signals via radio waves using a series of radio wavelengths measured in small numbers of centimeters.
-
product
Radio / Conformity Tests
The safe and effective use of radio frequencies (HF), referred to in English as radio frequencies (RF), must be checked for every device with integrated radio technology. The legal requirements for radio frequency (HF) tests vary depending on the use of the device (medical devices, automotive and telematics devices, cellular devices, etc.).
-
product
Radios
Honeywell Aerospace Technologies
Honeywell communications and navigation radios are used in nearly every type of aircraft. As the aviation industry grows and our customer’ needs evolve to areas like Urban Air Mobility, you can count on Honeywell’s wide-ranging navigation and communications radios to meet your requirements.
-
product
Plus Radio Ethernet Receiver
ACSRF-4040
The Plus Radio Ethernet receiver is required as part of the Tinytag Radio Data Logging System. It controls the transmission of data to and from the radio loggers: data received from the loggers is then sent to the computer for viewing with Tinytag Explorer radio software. If power to the computer running the system is lost, the receiver has a battery back-up which will maintain the mesh network until power is restored. This receiver plugs directly into a LAN removing the need for a computer in the area where monitoring is to take place. The receiver is powered using a plug-in Power over Ethernet adaptor (ACS-0041) which is supplied with the unit.
-
product
RF Radio - Frequency Probes
*3 to 6 Ghz *PCB MCX SMB SMC *SMA U. FL MS / MM Fakra *Exchangeable inner plunger
-
product
MIPI Radio Front-End
RFFE
Mobile phone radios have developed into highly complex, multi-band and multi-standard designs that often have multiple radio frequency (RF) signal chains. The MIPI Alliance Specification for RF Front-End Control Interface (RFFE) was developed to offer a common and widespread method for controlling RF front-end devices. The RFFE Master IP core typically resides in the RFIC in a mobile platform, and utilizes the RFFE bus to identify, program and monitor the registers in RF front end Slave devices through programmed IO. It is designed to support existing standards such as LTE, UMTS, HSPA and EGPRS, and is usable in configurations ranging from single Master/single Slave to multi-Master/multi-Slave.
-
product
Land Mobile Radio
Land Mobile Radio systems are commonly used for critical communications by public safety organizations such as police, firefighters, and other emergency response organizations. In addition to the public safety sector, LMR systems are also commonly used in the commercial world in various industries including industrial, transportation, utilities, security, and logistics. LMR systems typically consist of handheld portable radios, vehicle mounted mobile radios, fixed base stations and repeaters, and network infrastructure.
-
product
ALL-OUTDOOR RADIO SYSTEM
FreeMile 17/24
SAF FreeMile FODU - a new generation license-free 17/24GHz ISM band radio for Ethernet packet data and E1 voice transmission. The new radio system combines excellent features traditionally associated with ISM radios – interference-free operation, high availability, Carrier grade full duplex capacity with no cost of licensing and quick installation. SAF FreeMile radio also offers a user-friendly Web browser based management interface and straightforward installation process to ensure trouble-free experience for any user.
-
product
Universal Panel, IR & Radio Receivers
Add more connections to your LocoNet system. UP5 Simplifies hook-up, maintenance & troubleshooting of LocoNet, add a few to make traditional tethered walk-around operation a snap.
-
product
Radio Module (2x2)
SX-PCEAC2
The SX-PCEAC2 is powered by Qualcomm Atheros radio chip, the QCA6174-5, which features 2x2 wave 2 MU-MIMO technology. It is a dual-band 802.11 a/b/g/n/ac module with Bluetooth support which is designed for devices that require wireless connectivity in a small form factor combined with high performance with throughputs reaching up to 867Mbps.
-
product
Radio Testing RED
dB Technology has been providing radio testing services for more than 30 years. With so many electronic devices now containing radio devices, it is critical that manufacturers are aware of their regulatory obligations, and our knowledgeable and experienced team is on hand to provide advice and guidance accordingly.
-
product
GNSS Radios For Construction
Trimble radios offer flexible configuration options and rugged reliability for efficient use of GNSS on the construction site.
-
product
Vector Signal Transceiver-based Radio Solution (VRS)
ATS-3100 VRS
The ATS-3100 VRS, the newest member of the ATS-3100 PXI Integration Platform product family and fifth-generation radio test solution, is a single, consolidated platform for testing legacy, modern, and next-gen, software-defined radios for military, civil, and commercial users. Integrating the PXI Vector Signal Transceiver (VST) from National Instruments (NI), the platform enables faster test time with wider bandwidth (up to 1GHz) than any other radio test solution available today.
-
product
Full Indoor Radio System
CFIP Marathon II
CFIP Marathon 300 MHz / 1.4 GHz point-to-point long-haul microwave system is the perfect solution for industrial applications where fiber is not available. Primarily designed for remote and rural areas Marathon Full Indoor Unit can establish a link in adverse weather conditions and over long distances, frequently exceeding 100 km. SAF Tehnika Marathon solution is particularly recommended for utility (electricity, water), oil & gas, public safety, and transport companies who are looking for reliable data & voice transmission.
-
product
Radio Access Network
RAN
Break free from traditional restrictions of proprietary networks with Radisys Connect Open RAN protocol software and accelerate 5G deployments.
-
product
Radio Frequency Cable Tester
RFCT
Textron Systems’ Radio Frequency Cable Tester (RFCT) allows for on-site testing and maintenance for radio frequency (RF) transmission paths within a platform. Using preconfigured databases of sweep parameters and pass/fail criteria, the RFCT quickly determines the status of installed RF cables. The RFCT checks each cable’s performance characteristics to include voltage standing wave ratio (VSWR), insertion loss (IL), phase and phase matching. If a cable fails a test, the RFCT automatically determines the distance-to-fault (DTF). With its intuitive touchscreen-based user interface and lightweight, ruggedized packaging, the RFCT is the gold standard for operational-level RF cable testing.
-
product
2-way Radio Signaling Test Software
Tone Generator
The new PC-based test software for RF communications engineers and technicians. Flexible, accurate code synthesizer for simulation and testing of 2-way radio systems, repeaters, remote control, ANI, Paging and more.No external hardware required.
-
product
Over-the-Air Radio Waveform Analyzer Service
DiagnostX
Service enables LMR managers to have all of their active radios evaluated for performance and alignment Over-the-Air, without user intervention. A detailed monthly report will be sent identifying those radios as “Failed”, “Passed” and “Never Received”. This service supports P25 Trunked, P25 Conventional and Legacy systems. Available January 2018
-
product
HANDHELD “RADIO LOCATOR” PROBE
TS-8
Easy to operateUnaffected by surface coverLight WeightTelescoping handleRugged ConstructionWater resistantDepth locator "Bubble"
-
product
Radio & Wireless Compliance Testing
EMC Technologies can provide the mandatory radio and wireless testing, approvals and certification services for major international and local markets such as European CE Marking, USA and Canada FCC and ISED certification, Japan MIC, Australian RCM and New Zealand GURL. Common standards we can test against include:
-
product
Radio Frequency (RF) Generators
Find and fix design problems during developmental testing. Viasat’s RF signal environment generation surpasses ordinary simulation and computer modeling techniques to deliver a true-to-life, dense avionics environment for the most accurate analysis of RF communication system performance.
-
product
Centralized Management of Distributed Voice & Radio Systems
CERTIUM MANAGEMENT
Easy-to-use centralized management of VCS and radios provides a real-time view of the system and enables central system configuration and software management.Using multiple configurations, the system can be easily switched over to new parameters but also rolled back if needed. Central monitoring and reporting make the work of the system administrators much more efficient.In the CERTIUM® portfolio there are two management systems available, R&S®RCMS II and R&S®VCMS. The R&S®RCMS II allows monitoring of the entire ecosystem and provides the entire radio management and configuration. the R&S®VCMS provides the monitoring of the entire ecosystem and integrated the management of the CERTIUM® VCS and GATEWAYS components.
-
product
Radio Frequency (RF) Testing
Comprehensive testing and certification services helping you ensure that your wireless or radio devices achieve compliance to international regulatory RF or immunity requirements.
-
product
Radio Communication Tester
CMP200
The R&S®CMP200 is an IF tester that combines vector signal analyzer and ARB based generator functionality. The compact integrated solution can be customized with up to three R&S®CMPHEAD30 remote radio heads (RRH), for up/downconverting signals to 5G FR2 frequencies.
-
product
CB Radios
Offers professional drivers a legal way to communicate safely and easily on their smartphone with the Patented CB Radio with Bluetooth®Wireless Technology and enhanced Smartphone Features .
-
product
Radio Test Set
CTS-6000 Series
Bring your radio test function into the modern age with the new CTS-6000 Series radio test set. Combining nineinstruments into one, this tester offers fault detection and operational verification of your radio communicationssystem whether in the factory, at the depot, or deployed in the field.
-
product
Radio Frequency Scoring Tool
RFST
The Radio Frequency (RF) Scoring Tool (RFST) takes the guess work out of RF environment simulation. During RF environment simulation, the RFST provides clear persistent scoring and recording of the RF simulator’s performance. The RFST digitizes all RF signals in the form of digital Pulse Descriptor Words (PDWs) and associated In-phase/Quadrature (I-Q) data. This massive data stream is recorded for later (Post-Scenario) Analysis. Additionally, the RFST provides a real-time visual display of the accuracy of the RF output, easily visible through straight forward real-time indicators. The post analysis tool set allows an unlimited number of users to simultaneously assess previous RF simulator performance with compelling visual representations. The RFST is a perfect complement to our A2PATS product line offering everything you need for comprehensive environment simulation and analysis.
