Media Access Control
-
Product
Multi-Axis Stage Controller
MS-2000-WK
-
Applied Scientific Instrumentation
*100 MHz Microcontroller for faster command processing and servo control.*Closed-loop DC servo control of up to four motorized axes.*Firmware upgradeable via serial connection.*0-10V DAC for single piezo axis control.*Remembers last position on power down/up.*LCD display shows axes coordinates and status.*"Zero" and "Home" buttons for simple stand-alone operations.*USB or RS232 serial control with baud rates to 115200 Baud.*Compact ergonomic tabletop control unit 6"D x 9"W x 3"H (16 x 23 x 9 cm).
-
Product
Power Control
-
Educated Design & Development, Inc.
As a general purpose dual-voltage isolation transformer for step-up (120 to 240 VAC), step-down (240 to 120 VAC), or straight 1:1 isolation (120 to 120 VAC or 240 to 240 VAC). Models with a suffix "UC" are provided with a safety jack for access to the transformer secondary center tap (connected to the transformer center tap only in the 240 VAC output setting). This connection may be used in conjunction with a Dielectric Voltage Withstand test.
-
Product
IDE Controller PMC with 40-pin Interface Connector
5251
-
The IDE Controller PMC, when mated to a host or carrier card, provides an interface between the PCI bus and as many as four IDE/ ATA devices, via two independent channels.
-
Product
Voltage Controlled Linearized Attenuators To 16 GHz
-
Pulsar's voltage controlled, PIN diode linearized attenuators are available from 0.25-16 GHz with attenuation ranges of 32 and 64 dB. Each model includes an integrated linearizer, and a driver that controls the attenuation level. This design results in transient free switching between attenuation levels as opposed to the spurious outputs that result when an attenuation value is switched either on or off by a direct digitally controlled attenuator. Transfer function is 8 dB / Volt.
-
Product
Mobii Media Encoder
-
The Smart Encoder is designed for semi and permanent based on-site installation. Deployed into sport stadiums/arena’s, Broadcast production sites, Data Centers and Outside Broadcast vehicles, the Smart Encoder will ingest a variety of input video sources such as SDI, NDI, SRT, MPEG-TS. The encoder will ingest, synchronize, encode and upload Microblock streams to the nearest cloud regional edge cluster for global distribution via the Co-Ordinator, or output a variety of streaming formats to local network for on-site usage.
-
Product
USB Controlled High Precision Audio Test Interface
AudioConnect 4×4
-
AudioConnect 4×4 is a high accuracy 4-in, 4-out audio interface specifically audio test and measurement. It offers digital and analog audio in and out at any user-specified sampling rate up to 200kHz, and a high signal to noise ratio and wide frequency response, making it suitable for the most demanding measurement applications. Controls are simple – a single USB connection and a power indicator – all other typical soundcard controls that are not used for audio test applications have been eliminated to make operation and calibration simple with no room for error. AudioConnect 4×4 is supplied fully calibrated.
-
Product
Charge/Discharge System Controller
PFX2500 Series
-
PFX2500 Series is a high performance Charge/Discharge system controller that takes measurements in combination with our DC power supply and electronic load in order to evaluate test sample (electric storage elements such as secondary batteries) characteristics. It is also capable to perform evaluation test with high-performance, large capacity and wide range of rating with the combination of DC power supply and electronic load.Execution of the test is conducted by the exclusive application software. The test corresponds to long time continuous test and synchronization test with temperature chambers with the multiplexed protection performance. In addition, easy data editing is also capable with fulfilling graphic performance.
-
Product
Miniature Pressure Controller
VSO-GC
-
Parker VSO-GC is an electronic pressure control unit specifically designed for gas chromatography manufacturers that require low volumetric flow control
-
Product
Controlled Fastening Tools
-
When it comes to Controlled Fastening Tools AIMCO has a wide selection of high-quality DC nutrunners, electric and pneumatic pulse tools, tool controllers and monitors and more. We'll help you find the perfect tools to get the job done right.
-
Product
Fluid Control Valves - Maxway Valves
Code 7
-
Parker Conflow’s Code 7 is a user-friendly inline stop valve that regulates and isolates fluid in pipelines and systems for mining and quarrying applications, with handwheel and key fitting options.
-
Product
Cryogenic Temperature Controllers
-
Monitor & amp; control temperatures from 300 K to over 1,500K. Choose from a variety of sensor inputs, sensor excitation ranges, display features, and interfaces.
-
Product
SPS Digital Controls
-
With 35 years of proven experience in design and manufacture of precision positioning systems, CAES provides SPS Digital Controls for commercial and military applications with the best combination of reliability, precision and value.
-
Product
Seismic Impact Control System
ZET 048
-
Seismic impact control system is used to control ground surface shifts caused by earthquakes, explosions and other natural or technology-related factors. Seismic control system is used to obtain actual information of the seismic environment as well as for process facilities state monitoring (in particular, for petroleum industry pipelines systems control).
-
Product
Control System
HICOS
-
HIGHVOLT Prüftechnik Dresden GmbH
The HiCOS controller is a collection of modules for monitoring test systems and recording, creating, evaluating and evaluating measurement data. It is suitable for mobile and stationary test systems as well as measuring devices. The modular design of the HiCOS controller allows the expansion of functions. Existing test systems from other manufacturers can be upgraded with HiCOS.
-
Product
Software Programming and Dosimetry Control
PDC-Ecomonitor
-
The "PDC ECOMONITOR" program is designed for automated noncontact programming of the operating modes of DKG-21 "EcotestCARD" dosimeters and automated noncontact reading of dosimeter measurement results of DKG-21 "EcotestCARD", MKS-U and MKS-07 "POSHUK" dosimeters.
-
Product
Synchronous GPS Based I/O Controller & Interrupter
interX
-
interX was originally developed as a measurement instrument for industrial and trunk pipeline anodic or cathodic protection systems. interX allows facilitate measurement of galvanic parameters (instant-off polarized potentials, pipe-to-soil potential) across a wide range of timing cycles. It is used to make synchronous disconnect and reconnect of protection electrodes (anode or cathode) or rectifier's from/to buried underground pipeline to perform measurements.
-
Product
Motion Controllers
-
Curtiss-Wright Defense Solutions
Motion control systems for defense applications must be two things - accurate and reliable. As the brains of these systems, motion controllers are responsible for ensuring all other system components are just that, no matter the conditions.
-
Product
Chassis - Controls up to 16 Switch Modules in 16x8, 32x4, or Dual 16x4 Configurations
CXB/128-MF
Chassis
These Chassis controls up to 16 switch modules in 16x8, 32x4 or dual 16x4 configurations. Available as single pole systems with the outer conductor of the BNC taken to ground, or isolated 2 pole systems switching both center conductor and ground. LEDs on the front panel show switch and power status. Add Switch Modules, Driver Modules and a Control Module to complete the system.
-
Product
High Flexibility Test Controller Card
TCC 1800-UE
-
The TCC1800-UE Test Controller Card is a generic control board for production testing of printed circuit boards (PCBs). The board is controlled by a command language on a PC to which it is connected via Ethernet.The TCC1800-UE is designed to work with positive voltages up to 24V. The card provides extensive IO: Analog and digital interfacing, counters, PWM outputs, bidirectional I/O, ethernet-, CAN, USB, SPI and I2C interfacing.
-
Product
Omnisens Optical Fiber And Cable Measurement And Quality Control
https://www.omnisens.com/uploads/1/2/0/5/120592129/telecom-1_orig.png
-
To provide quality control or help with the design and testing of fibers, Omnisens Vision offers fast, accurate strain and temperature measurements.Omnisens Vision is based on Brillouin scattering. In single mode fibers it produces precision readings with high spatial resolution over long distances and/or large loss test conditions. It is capable of high speed testing in dynamic situations such as flex fatigue.Its configuration flexibility makes the Omnisens Vision well adapted to a wide variety of test & measurement needs.
-
Product
VXI Mainframes & Controllers
-
The Keysight VXI mainframes provide rugged enclosures with innovative air distribution systems for extremely quiet and efficient cooling. With power supply capacities up to 1000 watts, you can easily configure the system that truly meets your needs.
-
Product
Motor Control
-
A product portfolio that offers motor drivers (brushed, brushless, stepper, load & relay) and integrated motor control systems for all your motor control solutions.
-
Product
Corrosion & Temperature Control
-
Corrosion & Temperature Control accessories including corrosion resistant materials, high temperature packages, temperature control jacket, cylinder insulating cover, and more
-
Product
Engine Control
StepGenerator4
-
*4-axis stepper motor control *Clock and direction signals *Speed up to 100,000 steps / s Positioning range +/- 2,147,483,647 steps *Simple ASCII commands via the serial interface *I2C adapter (master) for controlling external actuators / sensors *40-pin DIP package PCB (600mil / 19mm x 52mm).
-
Product
MIC-75G20 GPU I-Module, 1 PCIe X16 + 1 PCIe X4, Dual Front Accessible Storage Bay
MIC-75G20
-
Offering powerful GPU solution with NVIDIA 350W, 2.75-slot width, 334.6mm length GPU cards for new AI applicationDual 24VDC power inputs with reliable power and OCP solution for up to 700W maximum peak power currencyIntelligent power status indicating LED for system and GPU card independentlyFlexible GPU card holders (R.O.C. Patent Pending), ensuring GPU cardSupport up to 1Grms Op. vibrationSupport up to 60C Op. temp. with 350W GPU and 4-port PoE card installed with PWM fan control for intelligent thermal managementDual front removable 2.5" storage bay for easy swapIP30 rating with fan filter, suitable for outdoor or industrial environment
-
Product
Thermal Control Devices
-
Sumitomo Electric Industries, Ltd.
Sumitomo Electric offers heat control devices with excellent heat characteristics by combining its proprietary high-functional material technologies with process technologies (e.g. metallization, joining, sealing) and heat design technologies. These technologies are applied in the heaters for semiconductor fabrication equipment that achieves superior temperature uniformity and rapid heating and cooling characteristics.
-
Product
SPM Controller
-
the ability to provide independent torque (current) control or speed (voltage) control to the motor at any throttle position.
-
Product
Controllers
-
Sensors gather measured values in a vessel and forward them to the controller. Through an adjustment in the controller, the measured values can be adapted to the specific conditions at the measuring point.
-
Product
Fast Response Flow Controller for Medium Flow
HFM-305 / HFC-307
-
The HFM-305/HFC-307 is Teledyne Hastings' fast response series of mass flow meters and controllers. Featuring reliability and stability, the 300 Series is chosen for its fast response under a wide range of conditions.The HFM-305 / HFC-307 meters and controllers have flow ranges from 0-1000 slm to flows of 0-2500 slm; provide analog outputs, are constructed of stainless steel and can be configured to have either normally open or normally closed valves. The full scale range is specified by the end user. A NIST traceable calibration certificate is standard. With a choice of elastomers and high pressure options, the HFM-305 / HFC-307 services a wide variety of applications. Cleaning for oxygen service is available.
-
Product
RF Power Controller (ALC)
310-010030-004
-
The serial controlled ALC module is used to set and monitor the output level of your fixed gain RF amplifier. The module is available for many bands between 800 MHz and 3 GHz, and is configured and calibrated to meet your requirements.
