RF-LAMBDA Inc.
A manufacturer of radio frequency (RF) and microwave components, systems, and amplifiers.
- (888) 976-8880
(972) 767-5998 - sales@rflambda.com
- 4300 Marsh Ridge Rd
STE 110
Carrollton, TX 75010
United States of America
-
Product
Manual Attenuator (Coaxial)
-
RF Lambda’s manual coaxial attenuators are used to control signal levels using a manual control knob or buttons. These are highly reliable and commonly used in test setups where the operator needs access to tune RF signals without the need for any digital or voltage control.
-
Product
RF Synthesizer
-
Low phase noise broadband RF synthesizer module with extremely low step size and USB control.
-
Product
Manual Attenuator (Waveguide)
-
RF Lambda’s manual waveguide attenuators are used to control signal levels using a manual control knob. These are commonly used in test setups or systems where an operator is present and there is a need to change signal levels manually.
-
Product
Limiter
-
A device or software that prevents a signal from exceeding a set maximum level, acting like a "brick wall" to catch peaks.
-
Product
Overdrive Protected Amplifier
-
RF Lambda’s line of overdrive protected amplifiers incorporate a technology which eliminates the need for a limiter to protect the amplifier from damage. High input powers up to 10W can be injected in the amp without damage. Hermetically sealed options are available upon request.
-
-
Product
RF Waveguide Load
-
RF Lambda’s waveguide loads are used at end of an RF signal chain to provide a good 50ohm match and dissipate any RF energy into heat. They are available in a variety of power levels and offer low VSWR.
-
Product
Waveguide Adapter
-
Waveguide adapters in a variety of waveguide standards / flange types and coaxial connectors
-
Product
Fixed Attenuator (Waveguide)
-
Fixed waveguide attenuator in a variety of freuqencies, power levels and attenation values.
-
Product
Duplexer
-
RF Lambda’s duplexers are used to combine two frequencies or signals from different systems on to a common antenna. They offer high isolation and low insertion loss and come in a variety of different frequencies. Hermetically sealed options are available upon request.
-
Product
Circulator (Coaxial / Drop-In)
-
RF Lambda’s coaxial and drop in circulators are typically used to prevent unwanted reflections. They offer low insertion loss and high isolation and are available in a variety of frequencies and power levels.
-
Product
Waveguide Power Detector
-
RF Lambda’s waveguide power detectors are used to convert the RF power level to a DC voltage for signal power measurement. They offer wide band operation, fast response time and compact size.
-
Product
USB/Ethernet Control Step Attenuator
-
RF Lambda’s USB / ethernet control step attenuators utilize the same RF core as our standard digital attenuators only they incorporate a USB / ethernet controller to allow users to easily setup the control from any PC or network.
-
Product
USB/Ethernet Control Step Attenuator
-
Digital control attenuators with Ethernet or USB control
-
Product
DC Block
-
DC block offering broadband performance used to protect equipement and components from DC voltages
