Evaluation Boards
-
product
SparkFun MicroMod Ethernet Function Board
W5500
Integrate your MicroMod project into an Ethernet network including Power-over-Ethernet with the SparkFun MicroMod Ethernet Function Board. This specialized Function Board uses the W5500 Ethernet control module from WIZnet and a DC/DC converter to configure a MicroMod assembly as a connected and powered device into an Ethernet network with a Power-over-Ethernet (PoE) system.
-
product
Single Board Computer
VPX3-131
Curtiss-Wright Defense Solutions
The VPX3-131 3U OpenVPX Power Architecture Single Board Computer (SBC) combines the performance and I/O capabilities of NXP's P4080 QorIQ Octal processor with an extensive I/O complement to provide a highly capable processing platform for a wide range of rugged, embedded military and aerospace applications.
-
product
Squid Carrier Board™ Family PCI Express Gen 3 Carrier Board for One M.2 PCIe SSD Module
SKU-086-31
The Squid PCI Express Carrier board for M.2 SSD module is the smallest carrier board on the market. PCI Express Carrier board was designed to expand modern motherboards that have PCI Express interface. It allows vertical installation in any 1U servers or appliances.
-
product
Electronical Load Board 3U CompactPCI (air cooled)
045-097
The 3U load boards are designed to simulate the power consumption of a single board computer and other boards on the backplane.
-
product
GPGPU Board
NVP2009
As part of our NVIDIA Pascal™ based chip-down series of GPU XMC products the NVP2009 is ideal for GPGPU applications such as C5ISR, situational awareness, signal intelligence (SIGINT), as well as machine learning and autonomy.
-
product
RTM Discrete Signal Conditioning Board
MS 3632I
CPCI Rear IO Discrete Signal Conditioning Board is a signal conditioning and interface board for CPCI based Advance Compute & IO Module (MS3639i). This board primarily focusing on signal conditioning of TTL/CMOS DIO levels to required type of discrete input and output interface. Digital IO from ACIO board to discrete IO at Rear IO interface. Board takes 144 DIO from ACIO and does Open/Ground, 28V/Open, 28V/Ground configuration. In addition it shall generate additional 32 discrete input / output signals with signal conditioning and all IO interfaces are brought to two 96 Pin Euro Connector.
-
product
8 Channel Sample & Hold and Signal Conditioning Board for Group3
All channels provide for voltage division ahead of transient suppression before going into the S&H ICs. Channels that are sampled and held use a common sample and hold pulse that samples while high and holds while low. Jumpers on each S&H chip allow buffering of analog signals where sample and holds are not required. An advantage to the buffers is that it provides a high input impedance for high impedance voltage dividers.
-
product
PCI Express A/D Board
AD16-250 - Dual/Quad 16 bit, 250 MS/s
The AD16-250 series has two or four 250 MS/sec 16-bit ADCs, 8GB of on-board memory and the ability to transfer data directly into the host computer's memory at over 1 GB/sec. Streaming to the host computer can be performed simultaneously with acquisition to on-board memory, increasing the effective acquisition length by using the host computer's memory. Dual and quad channel boards sample concurrently at the input clock frequency, and can also be software selected to run in single channel mode, providing up to four (4) times the effective memory depth.
-
product
Squid Carrier Board™ Family PCI Express Gen 2 Carrier Board for 4 PCIe M.2 SSD Modules
SKU-086-01
The Squid PCI Express Carrier board for M.2 SSD modules is the second product in the Squid PCI Express Carrier Board™ family. PCI Express Carrier board was designed to expand modern motherboards that have PCI Express interface. It allows connection of up to 4 M.2 PCI Express SSD modules. This product is recommended for use in Mac Pro Desktop computers.
-
product
Ultrascale FPGA PCIe Board
SE100 – Solar Express
Sundance Multiprocessor Technology Ltd.
SE100 is based on Xilinx’s Virtex Ultrascale FPGA XCVU190-2FLGC2104E, and is a powerful processing card with plenty of IO capabilities to meet the needs of modern compute-intensive applications such as Supercomputing, Data Centers and defense. The board can optionally be populated with 095, 125, and 160 devices in C2104 package for reduced cost. Host interface is via 8 lanes of PCIe Gen3 but the card can also be used as an embedded, standalone, hardware too. Multiple cards can be cascaded to provide a multi-FPGA system with cards connected together via the board’s fast IO channels to meet the needs of even more demanding applications like ASIC design and Stock Market fast trading systems.
-
product
Embedded Single Board Computers
Advantech Embedded Single Board Computer (SBC) series include: 2.5" Pico-ITX, 3.5" PC/104, 5.25" EBX, and MI/O Extension form factors. They offer scalable x86 performance from low power to high-end, and from fanless and slim, to extended temperature platforms with longevity. They are ideal for system integration with high flexibility and expansion possibilities, and compact sizes with rich I/O. Reliability was built in for highly reliable 24/7 operation and industrial grade rugged operation.
-
product
RTM Analog Signal Conditioning Board
MS 3633I
CPCI Rear IO Analog Signal Conditioning Board is a signal conditioning and interface board for CPCI based Advanced Compute & IO Module (MS3639i). This board primarily focusing on all type of Analog input and output interface including signal conditioning from ACIO board to Rear IO interface. Board takes 16 Analog outputs and 64 Analog inputs from ACIO and does signal conditioning. In addition it shall generate additional 40 Analog input and 32 Analog output signals with signal conditioning and all IO interfaces are brought to two 96 Pin Euro Connector.
-
product
Board to Board Interconnect
Highly Configurable – Custom Pad/ Array Configurations Available•Mixed Digital, Power, RF on Same Array•Double the Compliance of a Single Pin•Air Dielectric Option for Hi-Speed/ RF•Unparalleled Performance!•< 1 dB loss @ 65GHz•Up to 4 Amps continuous•Ultra-Low Loop Inductance•Environmental -40°C to +150°C
-
product
Terminal Board for Mitsubishi MR-J3-A Servo Amplifiers
DIN-814M-J3A0
This well-designed motion control terminal board is for the users who use Mitsubishi J3A servo. With this terminal board, users can ealisy complete wiring with PCI-8174, PCI-8164, PCI-8154, PCI-8158 and PCI-8134.
-
-
product
Electronical Load Board 3U CompactPCI (conduction cooled)
046-712
The 3U load boards are designed to simulate the power consumption of a single board computer and other boards on the backplane.
-
product
Interface Board, Low Cost, 8:1 Ethernet RJ45
40-965-901
Low cost converter card for 40-736 Data Communications Multiplexer. Adapts the 78-Pin D-type connector on the front of the module to 9 RJ45 sockets. Allows the multiplexing of up to 8 Ethernet signals with speeds up to 1G bit.
-
product
Digital I/O Board
3512
The 3512 is an eight channel non-isolated digital I/O board with +5V tolerant 74LCX14 inputs with hysteresis and +3.3V CMOS 74LVTH125 driven outputs. Each I/O line features a series 10 ohm damping and protection resistor and a 4.7K pull up resistor to +3.3V. On power up the outputs are tri-stated, and can then be enabled on a bit by bit basis. Output high drive is 32mA @ 2.0V minimum. Output low drive is 32mA @ 0.8V maximum.
-
product
Single Board Computers
SBC35-C398Q-2-0
WINSYSTEMS’ SBC35-C398Q quad-core single board computer combines high-performance multimedia graphics with a rich mix of industrial I/O. The Freescale i.MX 6Q processor’s integrated power management provides excellent efficiency and allows operation from -40° to +85°C without active cooling. It is designed for demanding graphical applications in security, transportation, medical, and digital signage.
-
product
6U CompactPCI® Rear Transition Board for MIC-3395
RIO-3315
The RIO-3315 is the first Rear Transition Module (RTM) supporting PCIe connectivity to the main CPCI board enabling significant value-added features and extensions to next generation CPCI blades such as MIC-3395. The RIO-3315 supports: one PS/2 port, six USB ports, two RS-232 ports, two SATA ports, two Gigabit Ethernet ports, one digital and one integrated (digital/analog) DVI port. Three versions of RIO-3315 provide a choice of storage and LAN options. The RIO-3315-A1E with LSI1064E SAS controller supports a 4-port SAS controller with RAID, which allows switching between four internal SAS/SATA or four external MiniSAS ports. The RIO-3315-B1E supports SATA disk drives and SATA RAID via the QM67 PCH.
-
product
PCI Data Acquisition Boards
AD8-650X2DMA Series - 8 bit, 800MS/s
Model AD8-650X2DMA is similar to the AD8-1250DMA, but contains two simultaneous-sampling A/D channels, each capable of sampling at up to 800 MS/s.
-
product
VME / VME64x Load Board 6U
1940000140-0000
The Elma Electronic VME / VME64x load board provides a means to test the power generated by and cooling capability of VME systems. This makes it easier to locate hot spots in the chassis, so the airflow can be properly directed.
-
product
3.5" Single Board Computer
RSB-4220
The RSB-4220 series comprises RISC SBCs with integrated TI Sitara AM3352 Cortex-A8 processors. Units offer 2x gigabit Ethernet, 5x serial ports, 4x GPI and 4x GPO. For industrial applications, the serial port & GPIO feature rugged ESD and isolation that protect the system from unstable power damage. Also, RSB-4220 has multiple power inputs and operating temperature support, and even supports a single channel 18-bit LVDS with up to 1366 x 768 resolution. It is an ideal solution for automation control such as smart grid, and machinery automation applications.
-
product
Signal Integrity Evaluation up to 26.5 GHz
N5222BT
The N5222BT provides the N5222B 26.5 GHz PNA, application software including PLTS and enhanced TDR, and accessories for signal integrity evaluation of cables, backplanes and BGA packages.
-
product
PCI Express A/D Board
AD8-1800 Series - Dual 8 bit, 1.8 GS/s
The AD8-1800 series has one or two 1800 MS/sec 8-bit ADCs, 8GB of on-board memory and the ability to transfer data directly into the host computer's memory at over 1 GB/sec. Streaming to the host computer can be performed simultaneously with acquisition to on-board memory, increasing the effective acquisition length by using the host computer's memory. Dual channel boards sample concurrently at twice the input clock frequency, and can also be software selected to run in single channel mode, providing twice the effective memory depth.
-
product
VPX Boards
VPX boards (VITA 46) are ideal for high-performance industrial, defense, scientific research, and telephony systems requiring high-speed I/O with serial fabric interconnect technologies. Carrier cards with PCI Express provide a simple and cost-effective solution for interfacing a PMC or XMC I/O modules to a VPX computer system. VPX FPGA modules offer great flexibility and performance for custom computing applications. Depending on your system’s operating environment, you can select air-cooled, conduction-cooled or Ruggedized Enhanced Design Implementation (REDI VITA 48) versions.
-
product
PCIe/104 OneBank FPGA I/O Board
EMC²-7A200
Sundance Multiprocessor Technology Ltd.
The EMC2-7A200 can use commercial, industrial or automotive graded Artix-7 FPGAs and is complimented with 1Gbyte of DDR3 local storage, 32Mbytes of Flash memory for storage/configurations and has 68x free differential I/O pins which are routed to a VITA57.1 FMC-LPC high-speed connector for bespoke interfaces.
-
product
Modular 6U Processor Board
VP62109
LinkedHope Intelligent Technologies Co.,Ltd.
VP62109 is a 6U VPX board based on Intel® 4th Gen i3/i5/i7 2-core or 4-core embedded CPU, with modular design. Supporting up to 4-core Intel® i7 4860EQ processor, VP62109 is able to perform vector operation and floating-point arithmetic that require high throughput. Besides, VP62109 supports Intel® Turbo Boost, with the processing speed of CPU up to3.4GHz. The high-performance CPU and the Turbo Boost technology leave no worries for extra cost and complexity of system settings.VP62109 provides 4x PCIe 3.0 x4 for VPX Data Plane communication, 4x GbE for VPX Control Plane communication. Rich data exchange interfaces on VP62109 make it easy to build box-level or system-level solutions.
-
product
PCI Express Optical Link Board
SIS1100-E2
The SIS1100-e2 is the follow up card to our SIS1100-eCMC board (without CMC carrier functionality). It was developed to extend the lify cycle of our PCIe to VME interface. For software/driver compatibility reasons we still employ the PEX8311 PCI Express to local bus bridge chip.
-
product
3U VPX Board
VP32004
LinkedHope Intelligent Technologies Co.,Ltd.
VP32004 is a high-performance PC-based 3U VPX processor board developed by Linkedhope®. It supports 3rd Gen Intel Core series processor and Intel QM77 chipset. It supports up to 16GB of on-board DDR3 ECC memory and supports mSATA SSD. In order to ensure that VP32004 works stably in a strong shock and vibration environment. VP32004 provides rich I/O interface, including 2x SATA III channels, 2x 1000 Base-BX/T, 1x RS232 front debug serial port, 3x RS232/422/485 interfaces (BIOS configurable), 4x USB2.0 interface, 1x USB3.0 interface, 1x Mini-DisplayPort display interface, 1x rear VGA display interface, 1x PS/2 interface.The board provides a flexible PCIe bus interface to the backplane that supports multiple configurations and can be configured as 1 x8, 2 x4, 4 x2 PCIe. This feature makes it suitable for both distributed and centralized switching systems.
