Product

Precision Impedance Analyzer (10Hz to 130MHz)

ST2851

-

Saluki Technology Inc.

ST2851 - Saluki Technology Inc.

ST2851 series precision impedance analyzer is a new generation impedance test instrument by adopting the current international advanced automatic balance bridge principle. It is based on Windows10 operating system, which realizes a fully computerized operation interface, making the measurement more intelligent and easier.ST2851 series impedance analyzer surpasses the 120MHz frequency bottleneck of similar foreign instruments, and solves the defect that it can only be analyzed but cannot be tested independently. At the same time, it adopts two interfaces of single test and analysis to make the test easier.

Product

High Impedance Transformers

-

Osborne Transformer Corp.

Osborne Transformer Corp.

Osborne high impedance transformers are used to step-up, step-down and isolate voltages in single phase and three phase circuits. A properly designed high impedance transformer can be used an an equivalent to an isolation transformer connected in series with an inductor. The high impedance characteristic may be employed as a current limiting feature in both the primary and secondary circuity.

Product

Mini Appliance Checker

880 AT

-

Standard Electric Works Co., Ltd

880 AT - Standard Electric Works Co., Ltd

● The 880 AT is a simplified Version of an appliance tester which use low voltage and low current to perform it's checks.● Application Example The appliance is plugged into the mini appliance checker, then the probe make contact with the protective conductor.● Other appliance checking Washing Machine Toaster Iron Dish Washer Stove

Product

Advanced Power System – Power Dissipater Unit, 1000 W

N7909A

-

Keysight Technologies

N7909A - Keysight Technologies

The N7909A power dissipater unit adds current sinking or two-quadrant operation to any Advanced Power System (APS) N6900A or N7900A power supply. Each N7909A provides up to 1 kW of current sinking capability to an APS power supply, so you will need two N7909As to achieve full two-quadrant operation of a 2-kW APS supply. You can use a single N7909A unit with a 2-kW APS power supply to achieve 50% current sinking capability. The N7909A form factor is 1U and full rack width. N7909A connects to an APS power supply via a two-wire power connection and a communication connection to provide continuous two-quadrant operation. The connections are located on the rear panel of both the N7909A and the supply.

Product

Power Analyzer

-

Shenzhen Graigar Technology Co.,Ltd.

Shenzhen Graigar Technology Co.,Ltd.

This power analyzer is used for single-phase or three-phase measurements of the active, reactive and apparent power, power factor, phase angle, energy, voltage, current as well as peaks and harmonics up to 50º of the harmonic waveform. The power analyser clamp is equipped with data logger.

Product

TriaxM-TriaxM, Low Noise Triaxial to Triaxial Cable for SMUs, 1 m

785659-01

-

NI

785659-01 - NI

The TriaxM-TriaxM Triaxial Cable connects your system to PXI Source Measure Units and other devices that have a triaxial connector. It uses guarding to remove the effects of leakage current and parasitic capacitance when … measuring very low current signals. The cable offers 300 V DC maximum voltage, 3 A maximum continuous current, 10 A maximum pulsed current, and different lengths.

Product

Finite Element Method Magnetics Simulation Software

FEMM

-

Finite Element Method Magnetics

FEMM - Finite Element Method Magnetics

FEMM is a suite of programs for solving low frequency electro magnetic problems on two-dimensional planar and axisymmetric domains. The program currently addresses linear/nonlinear magneto-static problems, linear/nonlinear time harmonic magnetic problems, linear electrostatic problems, and steady-state heat flow problems.

Product

Photometric Radiometric Transmitters

HD2021T6 / HD2021T7

-

Senseca

HD2021T6 / HD2021T7 - Senseca

The transmitters allow converting the photometric quantity “equivalent veiling luminance” – HD2021T7 – or a photometric quantity Luminance (cd/m2) – HD2021T6 – into a current (4…20 mA) or a voltage (0…10 V) signal according to the version chosen. If the acquisition station is far from the probe (>50m), it is necessary to use the current output version.The probe is used for the control of street lighting, in particular, the measurement of equivalent veiling luminance is essential to determine the threshold luminance at the entrance of the tunnels (UNI 11095:2011).

Product

1000 Amp High Accuracy Current Probe

HA1000

-

Summit Technology, Inc.

HA1000 - Summit Technology, Inc.

The HA1000 is our most accurate current probe.  The HA1000 clamp-on current probe measures from 1 to 1000 amps AC.

Product

Portable, Remotely-Operated Boat for ADCP Measurements

Q-Boat1250

-

Teledyne Marine Oceanscience

Q-Boat1250 - Teledyne Marine Oceanscience

​Teledyne Oceanscience Q-Boats® are the number one choice for reliable remotely-controlled acoustic Doppler current profiling in streams, rivers, lakes and coastal waters all over the world. Whether you need to reduce your survey time, keep people safe during difficult conditions, or access hard to reach locations, there is a Q-Boat to suit your survey and your budget.

Product

GPIB PCI Mezzanine Card (PMC) Interface & Cable

GPIB-PMC-XL

-

TEAM SOLUTIONS, INC.

GPIB-PMC-XL - TEAM SOLUTIONS, INC.

The GPIB-PMC-XL is a PCI Mezzanine Card (PMC) GPIB controller card that converts any CPU card with PMC slots into a GPIB controller.It performs all the basic IEEE-488.1 functions such as talker, listener and system controller. The IEEE-488.2 compatible functions make it fully compliant with the IEEE-488.2 specification. In controller applications, you can control typically up to 15 devices (instruments). If operated as a talker/listener (device) interface it does exchange data and state information with the current controller-in-charge of the GPIB bus. The GPIB-PMC-XL lets Windows and Linux programs control GPIB devices.The flat ribbon cable has a standard GPIB jack on one end and a receptacle to be plugged into the GPIB card on the other end. The 30cm (12in) flat ribbon cable is included by Team Solutions, Inc.

Product

12-bit, 4 Analog Current Outputs With Separate Grounds, Optically Isolated 500 V

APCI-3504-C

-

TEAM SOLUTIONS, INC.

APCI-3504-C - TEAM SOLUTIONS, INC.

4 analog current output channels with 500V optical isolation, 12-bit resolution, each output has its own ground line.

Product

Low-leakage Switch Matrix Family

-

Keysight Technologies

Keysight Technologies

Conducting all the parametric measurements necessary for the numerous test structures on a semiconductor wafer can be a time-consuming and expensive process. With the cost of end-user devices continuing to drop, even laboratory characterization environments must reduce the cost of test.  Until now engineers and scientists working on current and future semiconductor process technologies were faced with a difficult choice: either use a semiconductor parameter analyzer with positioners on a wafer prober, which limits the ability to perform automated test, or use a switching matrix and probe card, which reduced the analyzer's measurement resolution.  Utilizing a switching matrix with a semi-automatic or fully-automatic wafer prober enables characterization tests to be automated, eliminating the need to have an operator manually reposition the probes each time a new module needs to be tested.  This reduces both test time and cost.  Due to the many price/performance points available, Keysight's switching matrix solutions provide the flexibility to choose exactly what your testing needs require, without overspending.

Product

Floating 6-Ch Integrated Power Source

PM0650

-

Applied Test Resources

PM0650 - Applied Test Resources

The pulse channels provide voltage pulses with duration control 10us to 100ms, and measures current. The combination of capabilities provides a versatile solution on fulfilling the wide range of requirements on testing a device. The PM0650 may be floated up to ±1500V to facilitate HV isolation test of devices where outputs may be connected directly to line voltages.

Product

Current Transformer

CT

-

E-Max Instruments

CT - E-Max Instruments

The split-core current transformers are easily installed with the snap on design.

Product

Self-Discharge Analysis Software

BT2155A

-

Keysight Technologies

BT2155A - Keysight Technologies

The Keysight BT2155A self-discharge analysis software, controlling the BT2152A or BT2152B self-discharge analyzer, measures and records Li-Ion cell self-discharge current and cell voltage. The software configures the analyzer’s channel settings, such as initial voltage and current matching, channel limits (OVP, OCP, UVP), measurement intervals, and test duration.

Product

Electronic Loads

-

Aim-TTi

Aim-TTi

Flexible electronic DC loads for general purpose applications. Voltage up to 80V, current up to 80A and power up to 600 watts. CI, CR, CG, CV and CP modes, built-in transient generators. Models with USB, RS232, GPIB and LXI compliant LAN interfaces.

Product

Power Meter

PM-10,PM-15

-

Standard Electric Works Co., Ltd

PM-10,PM-15 - Standard Electric Works Co., Ltd

● Determine the running cost your appliances.● Make informed decisions when purchasing appliances and equipment.● Reduce your electricity bill.● Measure Voltage, Current, Power, Volts, Amps, Power Factor, and Greenhouse Gas Emissions.● Calculate electrical expenses by day, week, month, and even an entire year.