Filter Results By:
Products
Applications
Manufacturers
Vehicle
a means of conveyance.
See Also: Conveyance, Transport, V2X, Truck, Electric Vehicle, Car, Automotive, Autonomous Vehicle, Autonomous Underwater Vehicle, J1939, Motor, Fuel, Payload, Cargo, NVH, Spacecraft
-
product
EV/HEV Battery Pack Environmental Exerciser/Monitor System
DMC designed, built, and programmed a set of automated test stands for charging and discharging electric vehicle battery packs. The test stands also monitor the performance of these battery packs while exposed to harsh environmental...
-
product
Precise Measurement of Airborne Noise Insulation
Isokell
Isokell offers a flexible method geared specifically to the needs of the automotive industry for measuring airborne noise insulation and the transmission loss of vehicle components. The system is easier to use and less costly than traditional acoustic measurement systems.
-
product
Vehicle Battery Tester
6420
Peaceful Thriving Enterprise Co Ltd
This is a device to test the 12 volt lead-acid battery of any vehicle. The tester will focus on health condition analysis of vehicle battery; it will estimate the cold cranking ampere (CCA) of the vehicle, and predict the lifetime of the battery. This will be helpful for the technician to inspect and maintain the electrical system of the vehicle. Base on the inspection, user can predict the time to replace the battery.
-
product
Vehicle Actuator Tester
7651
Peaceful Thriving Enterprise Co Ltd
This device is design to test electronic components actuate by magnetic field or electronic magnetic field. Devices like actuator, ignition coil, AC generator, indoor air blower, valve controller EGR (exhaust gas control), injector, spark plug, relay and hall effect sensor can be tested.
-
product
Vehicle Electromagnetic Field Exposure Test System
SEM-400
Beijing KeHuan Century EMC Technology Co,.LTD
Vehicles are our daily public transportation. Electromagnetic pollution in vehicles has attracted more and more public attention. The newly revised compulsory standard GB27630-201X "Passenger Car Air Quality Evaluation Standard" intends to require the electromagnetic field in the car as one of the indicators, according to GB/T37130-2018 "Measurement method of vehicle electromagnetic field relative to human exposure" The measurement method is to measure the intensity of the magnetic field in the car. In the frequency range of 10Hz-400kHz, the electromagnetic field measurement result should meet the public limit requirements of GB8702-2014 for electromagnetic exposure.
-
product
Oscilloscope Tester
ScopeTester 5
ScopeTester 5 is 5-channel oscilloscope tester for PCs. Unlike traditional oscilloscopes it is capable of continuous acquisition of signals without dead times. This feature gives exceptional diagnostic value. Available voltage ranges matches typical signals found in modern cars. The user may connect to vehicle sensors, actuators and other diagnostic equipment, such as current clamps, inductive and capacitive probes and other diagnostic probes.
-
product
Universal Pass-Thru Device for Heavy Duty Trucks and Commercial Vehicles
DrewLinQ®
*Reliably fix most heavy-duty vehicles, without having to send them away to manufacturer dealerships*Keep control of the timing and costs of repairs*Save time and money, and increase your profitability
-
product
Fuel Injection Pressure Tester with 2 Gages
33950
Test gasoline fuel pump pressure on most domestic and imported fuel injection equipped vehicles.Kit contains adapters to test all GM vehicles with Multi-port and some Throttle Body Injection (TBI). Test all Chrysler cars with Multi-port turbos and some TBI.Use on most Ford TBI systems equipped with or without small Schrader test valve.Test all Ford vehicles with multi-port fuel injection systems.Includes two gages: Large Gage with hang-up hook calibrated from 1-100 PSI (0-7.0 BAR) and Small Gage for lower pressure requirement 0-50 PSI (0-3.5 BAR).
-
product
Vehicle Mount Cable Fault Location System
Weshine Electric Manufacturing Co., Ltd
VS2088Plus Built in Booster And Capacitor In Vehicle Underground Cable Fault Test Device
-
product
Total Energy System
5000
The electric vehicle (EV) charging market is rapidly expanding, with more and more people switching to electric cars. As the demand for EV charging stations increases, so does the amount of energy that is being exchanged. This energy exchange market is already massive, with charging peaks reaching into the megawatts of energy. With this amount of energy comes a significant amount of revenue, which requires the most accurate billing possible. That’s where TESCO’s Catalog No. 5000 – Total Energy System comes in. The Catalog No. 5000 is a double duo system that enables the testing and accuracy verification of Electric Vehicle Service Equipment (EVSE) and Field Test Equipment for testing EVSE’s in the field. This system is a dual-purpose DC and AC System and includes both a 100A AC (ACT-100) Test System and a 200A DC Test System (DCT-200).
-
product
Bison MIL Vehicle PC
The BISON MIL vehicle PC is built to be used in harsh Industrial and MIL applications which call for this kind of robust and reliable system. The compact and very solid aluminum housing meets industrial and MIL-810 environmental requirements.The system complies to high EMC/EMI standards like MIL-461/704/1275. The BISON MIL vehicle PC is now available with the i3/i5/i7 7th Generation Intel CPU technology.
-
product
2WD Dynamometers
MD-800 Series
For instances where a performance shop is interested in performing basic dynamometer runs for peak power measurement and overlapping multiple runs to quantify performance gains or losses resulting from changes to the vehicle, the MD-800 offers the perfect combination of competitive pricing and performance capabilities as an inertia-only dyno, while allowing an easy upgrade path to add power absorption when you are ready to offer professional steady-state tuning services. Once added, the eddy current upgrade allows for steady state tuning of high performance EFI vehicles via a 900-hp power absorber module.
-
product
ATMS Software
Since 2009, Centracs® has led the industry in providing advanced transportation management solutions for over 340 customers across North America, controlling over 57,000 signalized intersections. Centracs has evolved along with the industry, keeping pace with both day-to-day operational demands and the emerging connected vehicle environment to ensure the highest levels of safety, system reliability, and optimized mobility.
-
product
Scienlab Regenerative DC Emulator
SL1800A Series
Keysight's SL1800A Scienlab Regenerative DC Emulator - High-Power Series enables users to emulate the large batteries in electric vehicles. The bidirectional power flow allows emulation of both power sourcing applications, such as traction inverter test, as well as power-absorbing (sinking) applications, such as EV charging. Being regenerative, the power absorbed is delivered back to the grid, saving on energy and cooling costs. The SL1800A Series is fully integrated with the SL1040A Scienlab Charging Discovery System. The SL1093A Scienlab Charging Discover Software fully automates DC charging applications to many different test standards. With bi-directionality, integrated DC voltage and current controllers, high dynamics, and its regenerative energy feedback capacity, the Scienlab Dynamic DC Emulator provides an all-in-one system for efficient and effective testing of the power electronic components in electric vehicles (EV) and electric vehicle supply equipment (EVSE).
-
product
18 Pc. Micro 64 Test Connector Kit
147
Test connector kit featuring a variety of terminal adapter sets which enable connection to Micro64 terminals - primarily found on GM vehicles and some EU/Asian/Domestic vehicles. Adapters connect via the included 48 inch stacking banana plug test leads. Connection to most DMM’s and scopes is no problem. Kit is designed to provide a quality & secure test connection while quickening the test process.
-
product
Radiation Portal Monitors
Baltic Scientific Instruments, Ltd
Radiation Portal Monitors (RPM) are fix-installed radiation detection systems designed for automated screening of pedestrians, vehicles and trains passing through the detection zone of RPM for presence of gamma and neutron radiation. The RPM alerts the security office and front line officer about the presence of radioactive and nuclear material and provides additional alarm associated information: type of alarm (gamma, neutron or both), relative amplitude of the alarm, etc.
-
product
30A, 100MHz High Sensitivity Current Probe
CP031A
Teledyne LeCroy current probes are available in a variety of models for a wide range of applications. The full range of Teledyne LeCroy current probes includes models with bandwidths up to 100 MHz, peak currents up to 700 A and sensitivities to 1 mA/div. Teledyne LeCroy current probes are often used in applications such as the design and test of switching power supplies, motor drives, electric vehicles, and uninterruptible power supplies.
-
product
48V LOADpro Dynamic Test Leads
185
This new version of LOADpro is capable of loading circuits as high as 48 volts. 185 can be deployed on electrical systems ranging from 12 volts up to 48 volts. Applications include automotive, heavy-duty, marine, off-road, agriculture and electric vehicles. 48V applications include electric equipment, lift trucks, scissor lifts, golf carts and other battery powered vehicles.
-
product
Mobile DataCollection & Tracking
A Mobile Data Collector (MDC) is placed on the vehicle or asset that you want to monitor. The MDC is configured to collect a specific set of raw data.
-
product
Big Data Web Platform to Measure Vehicle, Transit, Bike, and Foot Traffic Virtually
StreetLight InSight
StreetLight InSight® is big data web platform that harnesses connected device and IoT data to measure vehicle, transit, bike, and foot traffic virtually anywhere. Use our self-serve software 24/7 to analyze traffic volumes, Origin-Destination, turning movement counts, and other transportation metrics — for any road, area or time period.
-
product
Fiber Optic Sensing Instrument
RTS125+
The fully ruggedized RTS125+ fiber optic sensing instrument was created in partnership with NASA to support the test and validation of their new vehicles. It delivers the most reliable measurements for structural testing, design optimization, structural health monitoring, thermal mapping and 2D shape sensing.
-
product
6-24V Multi-functional Auto Tester With LED Display
6510A
Peaceful Thriving Enterprise Co Ltd
Test the automotive electrical system within 6-24V. In order to save the testing hours for the automotive electrical system, the tester is designed to test the system without re-connection between the vehicle battery and the testing components. For the testing and safety purpose, the tester contains short-circuit protection, which can also check the ground connection without voltage drop test. The short-circuit protection system contains the recoverable fuse, so the technician will not waste the fuses during the testing. The extension cable is long enough for a technician to test the whole system for the vehicle. Therefore, the technicians do not have to search for ground connection constantly.
-
product
Power Management Infrastructure
Universal functional test system for control assemblies for railway vehicles. Testing takes place in a high mix / medium volume environment. Several systems are in production throughout Europe and Asia. The systems are equipped with a Virginia Panel G12 adapter interface.
-
product
Walk-In & Drive-In Environmental Test Chambers
Weiss Technik Walk-In Drive-In environmental test chambers are available in many sizes and configurations for both pre-engineered and custom solutions. Ideal for testing large products, batches of products or for full vehicle testing with Panelized or Welded walk-in environmental chamber solutions.
-
product
Dynamometers
When accuracy, reliability and performance matter look to the name that means dependability: A&D Technology. The comprehensive PerformanceLine includes a solution for all of the tasks of a modern and efficient test field, from durability, vehicle simulation, and high dynamic transient to high-speed e-motors. Choose from a variety of field-proven models from the PerformanceLine family with proven performance to meet your testing needs.
-
product
Cellular Network Analysis Software
NESTOR
R&S®NESTOR is a Windows 10 based platform for analyzing cellular networks via the air interface. It is deployed by law enforcement agencies, intelligence services, armed forces and regulatory authorities. R&S®NESTOR is used together with R&S®TSMX mobile network scanners and QualiPoc smartphones, which offer the most advanced technology worldwide. The software supports all relevant applications that public authorities and security organizations need to gather information about cellular networks. R&S®NESTOR is used in vehicles, trains, aircraft, drones, on ships and on foot.
-
product
Car Camera Bus (C2B)
Analog Devices Car Camera Bus (C2B™) is an innovative new camera link technology enabling HD video over Unshielded Twisted Pair (UTP) cables and unshielded connectors. C2B provides an easy upgrade path from SD to HD cameras without the need to change the existing cable and connector infrastructure. C2B enables a camera link with reduced system cost, significant weight savings and increased robustness. The C2B portfolio of transmitter and receiver devices enable seamless camera connectivity in the vehicle. The C2B technology was defined and designed for automotive applications and provides a robust camera link solution for these applications:
-
product
Vehicle Data Acquisition System
VDAS
The Validyne VDAS integrates all your data acquisition requirements for vehicle testing into one compact, rugged system. Up to 300 vehicle sensor channels can be accepted by the VDAS so that time consuming change-outs of instrumentation packages can be minimized. The same VDAS is easily shared by several test groups; system configurations can be saved and re-loaded as needed.
-
product
Dynamic Data Simulator
LS-70-S
The Lumistar LS-70-S PCI Dynamic Data Simulator allows complex data streams to be generated for evaluation of bit synchronizers and PCM decommutator performance. It can also be used for uplink command generation to vehicles in flight, checkout of complete telemetry links, and playback of archived hard drive data in any format with the appropriate dll. The PCI board is only 7 inches long and contains the dynamic simulator and IRIG Time Code Generator.
-
product
Axle Damping Test Bench
C_MSD S 2.5 W220 | VP 215048
Maschinenbau Haldenwang GmbH & Co. KG.
The axle damping test bench C_MSD is characterised by a fast and precise mechanical testing of the axle damping. Through the frequency-controlled plate activation via electric motors, the maximum vibration amplitude is calculated and then the axle damping is evaluated according to the Lehr damping principle. The fully automatic test sequence, including the calculation of axle and vehicle weight, saves time and allows a reliable assessment of the axle damping.
