Partial Discharge Monitors
See Also: Partial Discharge, Partial Discharge Detection, PD, PD Test, Partial Discharge Test
-
Product
Compact Air Quality Monitoring System(SO2, NOx, CO, O3, PM10, PM2.5, VOC)
AQMS-1000M
-
The Compact system is the alternative solution against standard AQMS, it comes with integrated shelter consisting IPC, sampler, AC and all necessary accessories.
-
Product
RF Sensor for Spectrum Monitoring
N6841A
-
Reduce operating costs with affordable spectrum monitoring and TDOA geolocation measurementsDeploy fully capable RF monitoring stations faster with simple hardware and measurement-specific software24/7 real-time remote spectrum monitoring with Signal Surveyor 4D softwareCapture intermittent signals with spectrum analysis softwareFaster search and signal isolation with broad attenuation and wide dynamic rangeLocate narrow or wideband signals with geolocation software
-
Product
Battery Discharge and Capacity Testers
-
HD Power Test Equipment Co.ltd
HDFD Battery Discharge Tester can be used as the discharge load in the battery off-line state to realize the constant discharge at the set value by regulating continuously the discharge current. When discharging, the tester will automatically stop discharging when the voltage on the battery group terminal or the cell falls to the set lower limit value, or when the set discharging time is out, or when it reaches the set discharging capacity. Battery Discharge Tester can records all valuable and continuous real-time data during the discharge process.This tester system is simple, safe and accurate for monitoring voltage of cells adopting wireless connection.
-
Product
Multi-Parameter Monitor / Controller
900 Series
-
Myron L® Company’s new 900 Series Multi-Parameter Monitor / Controllers combine Accuracy, Reliability, Simplicity, and Flexibility. The user intuitive GUI (Graphical User Interface) allows easy and complete programmability of the instrument all from the LCD touch screen. These highly accurate instruments have the ability for simultaneous monitoring and controlling of multiple inputs/outputs.
-
Product
Real-Time Monitor Recorders
RTM – Real-Time Quality Monitoring
-
for ST 2110 Networks with 10G IP Interfaces
-
Product
Radiation Portal Monitors
-
SaphyGATE G is an easy-to-use Radiation Portal Monitor optimized for truck, train and cargo radiation control. It's based on large surface, high volume plastic detectors providing the highest sensitivity.
-
Product
Stand-Alone Type Chemical Concentration Monitor
CS-100 Series
-
The CS-100 Series offers a complete lineup of high precision chemical solution concentration monitors for various solutions in cleaning and etching processes during semiconductor manufacturing. In addition to the high-speed response and compact design, measurement of each component concentration is conducted in real-time and the timing of chemical solution changes and automatic supply is warned with an alarm. The ability to perform short measurement cycles allows for accurate monitoring of concentration changes.
-
Product
Environmental Monitoring Systems
Sensaphone Family
-
Comprehensive line of remote monitoring products that safeguard valuable assets by tracking critical environmental data such as temperature, humidity and power failures. Sensaphone products provide alerts and proactive monitoring data to homeowners and facility managers in many areas including telecommunications, oil and gas, water and wastewater, HVACR, agriculture, healthcare, data centers and greenhouses.
-
-
Product
Dielectric Cure Monitor
LT-451
-
The LT-451 Dielectric Cure Monitor is a versatile instrument designed for research and development, quality assurance/quality control, and manufacturing applications involving thermoset materials such as resins, composites, and paints and coatings.
-
Product
Branch Circuit Monitor
-
Multiple branches of load can be monitored togetherCan group the device as 3 phase load and single phase loadFaster communication through RS485 port (Modbus protocol)Simultaneous sampling of Volts and AmpsAccuracy Class 1.0 as per IEC 62053-21 & Class 0.5 as per IEC 62053-22 StandardsDisplays more than 25 parameters
-
Product
Cleanroom Monitoring System
CRMS
-
The Kanomax Cleanroom Monitoring System offers turnkey solutions for monitoring needs required by various industries such as pharmaceutical, medical device, aerospace, semiconductor, and automotive.
-
Product
Washwater Monitoring System
EG-100
-
Washwater Monitoring System for NOx and SOx Scrubber.Monitoring pH/Temperature, Turbidity, and PAH.EG-100 has flow type sensors.
-
Product
Inline Particle Monitor
iCountPD
-
The Parker iCountPD is a highly compact, permanently mounted laser detection particle size monitor that enables continuous monitoring of contamination levels in hydraulic and fluid circuits.Capable of communicating results in ISO4406 / AS4059 or NAS1638
-
Product
High Precision TMAH Concentration Monitor
HE-960H-TM-S
-
Accurately measures the concentration of TMAH (Tetra Methyl Ammonium Hydroxide), which is the main component of the photoresist developer solutions in semiconductor manufacturing. Repeatability: within +/- 0.003%. Measurement range : 0 - 3 %. Have the chemical resistant carbon sensor.
-
Product
Clamp type AC Current Sensor／for Power Monitor
ZCT-40P
-
MULTI MEASURING INSTRUMENTS Co., Ltd.
*AC 0.1A～500A*Current measurements of feeder
-
Product
Fixed Aperture RF Current Monitoring Probe
TBCP1-200
-
The TBCP1-200 is a fixed aperture RF current monitoring probe.The probe has a 3dB bandwidth of approximately 200 MHz. The aperture of the RF current monitoring probe is 25 mm. Its transfer impedance is > 14 dB Ohm in the range from 40 kHz to 200 MHz.
-
Product
Optical Channel Monitor
-
Optoplex Optical channel monitor (OCM) uses proprietary thin-film interference filter technology combined with a micro-actuator and high-speed electronics. Optical channel monitor is used to measure critical information data on optical transmission signals in DWDM networks for monitoring signal dynamics, determining system functionality, identifying performance change, and providing feedback for controling network elements so as to optimize operational performance. In particular, Optoplex Optical channel monitor can automatically scan the C-, L- or C+L-band wavelength range and precisely measure channel wavelength, power, and optical signal-to-noise ratio (OSNR). See the following schematic diagram for OCM working principle.
-
Product
Network Virtual Test, Service Activation & Performance Monitor
Fusion
-
Fusion is the premier product in the VIAVI NITRO platform, which addresses the challenges of test and measurement for new virtual and hybrid networks. As part of the NITRO VNet solution set which is focused on virtual service activation and performance management, Fusion arms network operators and enterprises with a valuable set of standards-based test tools that deliver accurate test results on which managers and engineers can depend.
-
Product
Organic Pollutant Monitor
OPSA-150
-
The OPSA-150 is a organic pollutant monitor that uses HORIBA's proprietary Rotary Cell Length Modulation, a measuring technique incorporating 25 years of expertise. The unit can be used as an organic pollutant monitor at drainage systems for determining compliance with COD monitoring regulations, for monitoring quality of water measuring levels of organic matter at water supply intakes, and as an organic monitor on process lines (phenol meter).*Pole mount, outdoor cover, and analysis panel are available as options.
-
Product
Hydrogen Fluoride Gas Monitor
GASERA ONE HF
-
Hydrogen fluoride, chemical formula HF, is a colorless, highly irritating already at very low ppm levels, corrosive gas and can exist as a fuming liquid. Reaction with water is rapid, producing heat and hydrofluoric acid. Hydrogen fluoride (HF) is used in manufacturing of refrigerants, herbicides, pharmaceuticals, high-octane gasoline, aluminum, plastics, electrical components, and fluorescent light bulbs, among others. Hydrogen fluoride (HF) is very soluble in water and is readily absorbed in the upper respiratory tract.
-
Product
Radiation And Process Monitoring Systems
ProTK
-
Monitoring of the main steam line for leakages in a PWR nuclear power plant with a wide-range gamma ionization chamber.
-
Product
15.6" Full HD Standalone HD Base-T Multi-Touch Industrial Monitor
SPC-815(M) V2
Industrial Monitor
15.6" Full HD TFT LED LCD display16:9 widescreen with P-CAP multi-touch controlSupport HD Base-T long distance video streamingFront-facing LED indicators show operating statusSilicone-free enclosure with all-round IP65-rated protection
-
Product
Monitoring
-
Configure sophisticated uptime monitoring checks without sacrificing simplicity.
-
Product
Logger and Handheld Instruments for Temperature Measurement and Monitoring
-
Temperature measurement and monitoring is vital for the quality of temperature-sensitive products wherever they are studied, produced, stored or transported.
-
Product
Fume Hood Monitor
FHM10
-
Fume hoods are a primary source or protection in laboratories. Face velocity measurements are often used to gauge the performance of a fume hood’s ability to contain and exhaust hazardous chemicals. By accurately measuring face velocity and alarming on unsafe conditions, TSI’s FHM10 Fume Hood Monitors provide a high level of fume hood safety. And, the FHM10 helps users comply with standards and regulations set forth by OSHA, NFPA, ANSI Z9.5, and SEFA, calling for monitors to be installed on fume hoods.
-
Product
PDS Bucket Dredger Monitoring Software
-
Your product description goes here.Teledyne RESON supplies integrated Bucket Dredge Monitoring System. The system includes sensors as inclinometers, ruggedized PC systems, positioning systems and our TELEDYNE PDS software. We can also supply motion sensors, tide gauges, draft sensors and spud pole position sensors.TELEDYNE PDS provides the functionality especially designed for the dredge operator to carry out their job more efficiently.
-
Product
SAFE-T-GROUND - Ground Continuity Monitor / Control
TR-7
-
Model TR-7 Safe-T-Ground provides continuous monitoring of a truck's ground connection throughout loading operations. Static electricity is often brought in by tank trucks entering the loading area. The Safe-T-Ground Model TR-7 instantly stops loading operations if a tank truck loses its ground.
-
Product
PDS Cable Trencher Monitoring Software
-
- Displays trencher depth relative to the seafloor- Real time monitoring of the operation- USBL configuration- Multibeam measurements included in the project.- Easy calibration of the sensors for the trencher
-
Product
Portable Switchgear Partial Discharge
PD-SG1
-
The PD-SG1 is a dual transducer Switchgear PD detection instrument. The unit detects TEV signals generated by internal discharge, as well as acoustic discharge generated by surface tracking or corona.
