Product

6U Vertical Card

410

-

VECTOR Electronics and Technology, Inc.

410 - VECTOR Electronics and Technology, Inc.

Chassis for vertical card installation

Product

Advanced Mezzanine Card (AMC) Module

AMC SyncClock32

-

Brandywine Communications

AMC SyncClock32 - Brandywine Communications

The AMC-SyncClock32 from Brandywine Communications is an Advanced Mezzanine Card (AMC) module. Precision time is provided to the host computer with zero latency. The onboard microprocessor automatically synchronizes the clock to reference signal inputs. The reference signal inputs handled by the AMC in its standard configuration are IRIG’s A, B/IEEE1344, and NASA 36. Alternatively, the clock in the AMC can be set using commands from host computer and free run using its on-board oscillator as the time base.

Product

Low Profile Isolated Digital Input/Output Card

LPCI-IIRO-8

-

Acces I/O Products, Inc.

LPCI-IIRO-8 - Acces I/O Products, Inc.

The LPCI-IIRO-8 is a half-size Low-Profile PCI bus compatible card that provides isolated digital input and output interface for PCI-Bus computers. The card has eight optically-isolated digital inputs for AC or DC control signals and eight electromechanical relay outputs. LPCI-IIRO-8 occupies four consecutive 8-bit registers in I/O space.

Product

Four Channel Low-Noise DC Bias Card

PI-41702

-

Pulse Instruments

PI-41702 - Pulse Instruments

The PI-41702 is a four channel bipolar DC Bias supply that can provide an output current up to 100 mA per channel. The output voltage ranges from –8 V to +8 V, and this card has special filter circuitry to reduce the output noise for those applications that require a low noise bias output. Additionally there is a ‘D’ type connector that allows the introduction of laboratory type supplies to reduce the noise further. To change from using the internal power supplies to external power supplies requires repositioning jumpers. The PI-41702 also has voltage and current sense for remote measurement of the voltage and current levels.

Product

Embedded PCs

EPC-B Series

-

Advantech Co. Ltd.

EPC-B Series - Advantech Co. Ltd.

EPC-B Series are scalable embedded PCs designed for thin and standard mITX boards, including AIMB-214/203/273/274/275/281/226/215/231/285/225.

Product

Intelligent Interface Card

IIB-1553-CPCI

-

Western Avionics Ltd.

IIB-1553-CPCI - Western Avionics Ltd.

The IIB-1553-CPCI is an intelligent interface card providing full MIL-STD-1553 test, simulation and bus analysis capability for the CompactPCI bus, with 1553A, 1553B, McAir and STANAG 3838 capability on a single card.The IIB-1553-CPCI supports concurrent Bus Controller (BC) and up to 31 Remote Terminals (RT) with Bus Monitor (BM). An additional stand-alone Chronological Bus Monitor (CBM) facility is also provided, with comprehensive multi-level triggering capability. Full error injection capability is provided in BC and RT modes,with full error detection in BC, RT, BM and CBM modes. The unit provides a dual redundant 1553 interface.2 Mbytes of dual ported RAM are supplied as standard. The board is supplied with C drivers in source code and Windows menu driven software.

Product

PCI Generic Carrier Cardfor PMC (PCIbus Mezzanine Card) Modules

ACP-1

-

AIM GmbH

ACP-1 - AIM GmbH

PCI generic carrier card for PMC (PCIbus mezzanine card) with 1 PMC slot. Modular solution combines any AIM PMC module for AFDX®/ARINC664P7, ARINC429, MIL-STD-1553 or any standard 3rd party PMC module.

Product

PMC Card

P-DIS

-

Abaco Systems Inc

P-DIS - Abaco Systems Inc

The P-DIS PMC card is different from most currently available data acquisition boards. It provides multiple I/O types on a single module and the functionality to work with high-speed digital I/O signaling. With very accurate time stamping of input data and synchronization to an external IRIG-B source, the P-DIS provides the capability to precisely synchronize all output ports.

Product

Universal PCI, RS-422 Or RS-485 Serial Interface Cards

LPCI-COM422-8 and LPCI-COM485-8

-

Acces I/O Products, Inc.

LPCI-COM422-8 and LPCI-COM485-8 - Acces I/O Products, Inc.

These are eight-port, asynchronous, serial communication cards designed for use on the PCI bus. They support RS-422 or RS-485 communications. These cards offer the best combination of high-density and high-speed communications in a low profile form factor. The cards meet the MD2 Low Profile PCI Bus Specification and can be used in applications where space is at a premium, such as thin-client servers and high-density rack-mount servers. The LPCI line has been designed for use in retail, hospitality, and point of sale systems as well as the gaming and defense industries.

Product

PCI Express Card

EXC-4000PCIe/xx

-

Excalibur Systems, Inc.

EXC-4000PCIe/xx - Excalibur Systems, Inc.

The EXC-4000PCIe/xx card for the PCI Express bus supports up to four dual redundant 1553 channels using the M4K1553Px(S) module and is compatible with all common variations of MIL-STD-1553 (A, B).

Product

PCI Express Card Slot Interposer

PCIE850

-

Silicon Control Inc.

PCIE850 - Silicon Control Inc.

The PCIE850 provides a complete test and debug solution for PCI Express Bus. Interposers and probes connect to the PCIE850 providing access to PCI Card, AMX, XMC and VPX systems.

Product

AC + DC TRUE RMS Digital Multimeter With PC Interface

KM 829

-

Kusam Electrical Industries Limited

KM 829 - Kusam Electrical Industries Limited

• Beep-Jack Audible & Visible Input Warning• Auto-Ranging• Relative Zero Mode• PC Interface Capability• AutoCheck V-Ω ; Auto-Ranging• Crest (Instantaneous Peak Hold)• T1-T2 differential Temperature readings.• Data Hold

Product

Digital Acquisition Card

PI-41000

-

Pulse Instruments

PI-41000 - Pulse Instruments

The PI-41000-4G is a CompactPCI® bus based instrument card that allows the user to capture up to 32-bits of digital data into an on-board memory at clock rates up to 120 MHz. The inputs are software configurable to provide one 32-bit wide channel, one 16-bit wide channel with double depth or two 16-bit channels. When configured with a single 16-bit input, the card will capture at up to 120 MHz. When configured with two 16-bit inputs or as a single 32-bit input, the card will capture at up to 80 MHz. Each digital data channel requires three timing signals, frame, line and pixel to accommodate the data capture. When operating in a two channel mode, clocks from channel A can be used to provide timing to channel B. For wider words or multiple channels, more boards can be used in parallel.

Product

Real-Time Vision I/O Card With Multifunction

AX92350

-

Axiomtek Co., Ltd.

AX92350 - Axiomtek Co., Ltd.

The AX92350 is a PCI Express x1 vision card with vision-specific I/Os and real-time controls. A machine vision system requires accurate interaction between lighting, camera, actuator and sensor devices. The AX92350 vision I/O card integrates LED lighting controller, camera trigger, encoder input, and digital I/O to connect and control all the vision devices. The encoder input function is well-suited for conveyor applications. There are 4-CH trigger input, 4-CH or 8-CH trigger output, 4-CH LED lighting control, 1-CH quadrature encoder, 8-CH isolated DI and DO, and 1-CH auto measurement function for rugged machine vision and video surveillance applications.

Product

IC-RBP-XMCa, Active network redundancy XMC Switch Mezzanine Card

IC-RBP-XMCa

-

ELMA Electronic, Inc.

IC-RBP-XMCa - ELMA Electronic, Inc.

IC-RBP-XMCa, Active network redundancy XMC Switch Mezzanine Card.

Product

Smart Card Module Test Cells

-

SPEA S.p.A.

SPEA S.p.A.

Current and voltage measures are executed on defined pins, in stable conditions.Measurements:- Open/short- Input leakage current- IDD Supply instant/average current test (static/dynamic mode)- Input capacitance @13 MHz and inductance- Retro modulation index (RMI)Test of passive devices:- Capacitors- Resistors- Resonators

Product

IEEE488 (GPIC, HPIB) PCI Interface Card - Fits 3.3V or 5.0V Slots, 1KByte Transfer FIFO

GPIB-PCI-XL

-

TEAM SOLUTIONS, INC.

GPIB-PCI-XL - TEAM SOLUTIONS, INC.

The GPIB-PCI-XL is a PCI GPIB controller card that converts any PC with a PCI bus slot into a GPIB controller.

Product

1-Channel Voltage Measurement Card

LQU3

-

Computer Gesteuerte Systeme GmbH

LQU3 - Computer Gesteuerte Systeme GmbH

The LQU3 is a 1-channel voltage measurement card that features uni- and bipolar measurement modes. It offers 3 decades with 2 different amplifications. Therefore measurement ranges from +/- 1.6 V to +/- 320 V with a resolution of 16 bits and an accuracy of up to 0.02% are available.

Product

ActiveX Controls for ADLINK DAQ/DAQe/PXI-2000 Series Cards (Vista Ready)

D2K-OCX

-

ADLINK Technology Inc.

D2K-OCX - ADLINK Technology Inc.

D2K-OCX ActiveX controls communicate with ADLINK data acquisition cards to perform digital, analog, and timer/counter operations. These ActiveX controls well-designed to hide all details of hardware manipulation so the data acquisition operations can be achieved by only few lines of codes. Furthermore, any hardware configuration can be done with the easy-to-use property pages, and the acquired data is returned in a event-driven manner.

Product

Non-Multiplexed High Speed Continuous Function Card Overview

-

Neff Instrument Corporation

Neff Instrument Corporation

This type of system can be designed with benefits of both the multiplexed amplifier-per-channel and transient recorder systems. Benefits of the non-multiplexed amplifer-per-channel system include: High Sampling Rates: With an ADC per channel, the sampling rate is not encumbered with considerations such as multiplexing and post-amplifier settling time.Superior Filtering: With an ADC per channel, digital filtering can be used to augment analog filtering to achieve better anti-aliasing performance with much lower effective sampling rates.Superior Phase Matching: Digital filtering provides much steeper, more predictable rolloff rates and phase characteristics than analog filtering with greater stability with time and temperature changes at lower cost.