ICT Systems
See Also: ICT
-
Product
PD Measuring System
TEM
-
Partial discharge test system for laboratory or on-site measurement according to VDE 0434, IEC 60270 and EN50178 consisting of:*Partial discharge meter TMG*High-voltage coupling capacitors for decoupling of the PD pulses*Partial discharge calibrator TPK for determining the correction factor in the PD test circuit
-
Product
Digital Ultrasonic Maintenance System
VPE-2000
-
The Superior AccuTrak VPE-2000 is the first digitally controlled ultrasonic detector. Like two instruments in one it uses two independent sensors supported by separate electronic circuits configured specifically to their own sensor. This assures optimum sound clarity and frequency response. When switching between the airborne and contact sensors all settings are retained in memory! Digital LED meters let you establish baselines, perform trending, and accurately repeat these tests better than older more expensive analog instruments.
-
Product
Vibrator QC System
Accelerometer Array
-
*24-channel input interface for DAQLink-III acquisition system (23 for accelerometers and one for True Reference)*Computes accelerometer weighted sum using input array*Controlled state of current supplies for external accelerometers*LED status indication of every accelerometer input*Differential outputs to the acquisition system*Input channel impedance of 1 Mohm*Bandwidth: 0.1 - 5000 Hz*Crosstalk: -100 dB*Phase tolerance of channels: ±0.2 deg*10 mA current supply for every accelerometer channel*Max input signal: ±10 V p-p (True Reference), ±2.8 V p-p (Accelerometer input)*Power supply: 9 - 18 V
-
Product
High-speed USB DAQ System
Model DI-4208
-
USB Data Acquisition (DAQ) System. Eight armored analog differential inputs*. Programmable range per channel: ±2, 5, 10, 20, 50 100 V full scale. Up to 120 V rms without damage. 50 dB common mode rejection. Supports ChannelStretch™ multi-unit synchronization*. Adaptable low-pass filter per channel. Corner frequency set as a function of sampling rate. 16-bit analog-to-digital resolution. 160 kHz analog sample throughput rate. Seven digital ports*. Programmable per port as input or switch. Support for rate measurements to 50 kHz. Support for 16-bit counter.
-
Product
Phase Array Antenna System
-
Electronically steers radio waves without physical movement by using an array of antennas.
-
Product
Terminal Blocks with System
-
The Phoenix Contact terminal blocks enable a high degree of flexibility in terminal strip design. Choose between various connection technologies and combine the terminal blocks by installing bridges in the double function shaft. The terminal block system features standardized bridging, marking, and test accessories.
-
Product
SPM Control System
Nanonis
-
SPECS Surface Nano Analysis GmbH
Unbound to any specific microscope, the Nanonis SPM Control System is designed for the uncompromising demands of scientific excellence in a wide variety of SPM applications. Its modular concept implemented in a fully digital fashion is carefully thought through, with a strong emphasis on usability, stability and flexibility.
-
Product
In-Sight Vision System
D900
-
The In-Sight D900 is a smart camera powered by In-Sight ViDi software designed specifically to run deep learning applications. This embedded solution helps factory automation customers easily solve challenging industrial OCR, assembly verification, and random defect detection applications anywhere on the line that have gone uninspected because they are often too difficult to program with traditional, rule-based machine vision tools.
-
Product
Wheel Mounted Telemetry Systems
-
Advanced Telemetrics International
ATi’s Wheel Mounted Telemetry System is designed for the measurement of critical parameters from a rotating wheel. In today’s highly competitive automobile marketplace, the safety and comfort of passengers is more important than ever and has higher consideration when consumers are choosing a new vehicle.
-
Product
Distillation Gas Chromatograph System
-
The Shimadzu simulated distillation system, consisting of a Nexis GC-2030 high-performance capillary gas chromatograph and LabSolutions simulated distillation GC analysis software, meets all applicable ASTM, ISO, EN, and JIS standards. Permitting accurate and highly reproducible analysis of high-boiling components in crude oil samples, it is the optimal system for product quality control and process management in oil refinery plants.
-
Product
Metrology Systems
-
VIEW offers a full line of optical metrology systems for wafer, photomask, slider, MEMS, semiconductor package, HDD suspension, probe card, and micro-component process measurements.
-
Product
Power Device Testing System
-
Devices that control electric power, and are used in automobiles and a wide range of electrical products.
-
Product
Thermal Inducing System
-
Wewon Environmental Chambers Co, Ltd.
Design and development is the stage with the most type of thermal inducing system, It mainly includes oscilloscope, signal source, spectrum analyzer (signal analyzer), vector network analyzer and other general thermal management solutions, As well as channel simulator, terminal simulator, base station simulator and other dedicated thermal inducing system.https://www.wewontech.com/thermal-inducing-system/
-
Product
Neutron Scattering and Beamline Systems
-
For optical, neutron and particle beam experiments, Cryogenic offers a range of split pair magnets. These allow strong magnetic fields to be produced in a small volume with maximum access to the working space. Split pair coils can be mounted to provide either a vertical field with horizontal access or a horizontal field offering horizontal or vertical access.
-
Product
Ocean State Monitoring System
WaMoS® II
-
is a radar-based, wave and surface current monitoring system that delivers real-time measurements while a vessel is underway, providing germane data to the local operational area. High definition images of wave fields combined with numerical data and intuitive graphical reporting keep the operator well-informed in assessing environmental risk and identifying safe operational windows.
-
Product
Conveyor Decontamination System
Z-2000
-
Food-grade controller and lamp housings designed to meet IP67 and NEMA 4X standards.
-
Product
Custom Engineered Motion Systems
-
Customizing our products and creating new motion designs for a specific application are at the heart of our business. With more than 50 years of experience, we’re the leading manufacturer of custom motion systems and equipment across a broad range of applications and industries. Whenever you integrate a customized Aerotech product or subsystem into your larger system, you can be confident that motion and precision will never be limiting factors in your success.
-
Product
Raman Spectrometer System
IndiRAM CTR Mini Series
Spectrometer
IndiRAMTMCTR-mini Series Raman Spectrometer system is one of the best solution for carrying out reaction-monitoring or insitu analysis of the samples as it is a compact system capable of moving oform one place to another but at the same time maintaining high resolution and SNR
-
Product
FMET Systems
-
The Failure Mode and Effect Testing system allows the shorting of any I/O pin to any other I/O pin, including one of 4 common "Rails". Users can establish rules to prevent unwanted shorting conditions.
-
Product
Chloride Test System
C-CL-2000
-
The C-CL-2000 produces results on-site, within minutes that are accurate and comparable to expensive laboratory tests. It measures the electrochemical reaction of a weighted sample placed in an extraction liquid. It automatically shows a temperature compensated reading of percent of chlorides on its digital display. A wide range - from 0.002 to 2% chloride by weight - is covered.
-
Product
Handheld Raman System
IDRaman mini 2.0
-
The IDRaman mini is the smallest, most powerful handheld Raman system available today. The IDRaman mini fits in the palm of your hand, yet is ruggedly dependable for fast, accurate Raman analyses ranging from chemical and explosive agent detection in the field to quality assurance and quality control sampling routines in the factory. The system includes a preloaded, editable library of about 30 Raman spectra and large libraries of up to 9,000 spectra are available for purchase.
-
Product
Multisite Testing – Rail System
-
Mechanical system allowing the flexibility of multi-site testing with adjustable site to site spacing The Celadon Rail System allows multi-site testing capability with flexible die to die spacing using existing Celadon VersaTiles™ to minimize cost of test with new DUT structures. The modular design allows for additional site assemblies and rail assemblies to be added after the original system purchase. With the Celadon Light-Tight Enclosure and Rail System Tool, high accuracy alignment and testing can be performed at extreme temperatures without effecting the thermal equilibrium of the system.
-
Product
Optical CMM Systems
-
Our OmniLux metrology system is highly versatile and provides unparalleled levels of 3D CMM capture for component measurement in seconds. This high precision non contact, metrology system is extremely versatile because it measures components of any geometry and of any material. Geometries possible include: spheres, asphere, cylinder, internal bore, cone/taper, step height or freeform in any material such as polished or rough metals or ceramics and polymers. The Omnilux is fast and accurate because, unlike direct contact sensors, the use of optical sensors means that the whole surface can be analysed while the object is suspended in space, ensuring that no damage comes to delicate surfaces. Our easy-to-use software interface, developed from years of experience enables the operator to effortlessly control the system. Rich data analysis, automation and export of results for the immediate generation of reports as well as a compact footprint means OmniLux is the leading solution for production or R&D environments where reducing cycle times is critical to sustainable success.
-
Product
Vibrator Control System
FORCE-III
-
The Force 3 Vibrator Control System is the newest generation of vibrator control system. It is designed to control individual vibes, or synchronize entire fleets of trucks. Using GPS, or VHF/UHF radio, for its time base the Force 3 both starts the Vibrator and controls its sweep with unparalleled precision and accuracy.The Force 3 is equipped with the latest ADC chips for better sweep resolution, increased computing power for faster response, GPS for precise source location, 8 Gbytes of internal memory for integrated VSS and PSS data storage, and integrated Wi-Fi for easy data offloading.
-
Product
MMIs for Test and System Integration
-
Laying out a custom PCB is too time consuming and costly for most rush projects. Pulse Research Lab has developed Mini Modular Instruments ™ to provide cost effective solutions to the most common engineering challenges.
-
Product
Application Specific LC Systems
Co-Sense for Impurities
-
The FDA draft guidance, "Genotoxic and Carcinogenic Impurities in Drug Substances and Products: Recommended Approaches" prescribes permitted limits for genotoxic impurities in drug substances. These impurities demand more sensitive trace-level analysis than normal impurities. Generally, mass spectrometry methods, such as GC/MS or LC/MS, are used for the high-sensitivity analysis of impurities. However, there is increasing demand for the establishment of a high-sensitivity quantitation method using an absorbance or other conventional detector that is easy to operate and can easily apply existing LC analysis conditions.
-
Product
Battery Monitoring Systems
-
Franklin Electric - Grid Solutions
Combines wireless communication with patented, field-proven battery conductance analysis technology. It lowers total cost of ownership while providing the most thorough and easy to access stationary battery health diagnostics.
-
Product
MagTest System
-
A System to generate magnetic fields and to perform tests regarding the susceptibility against magnetic fields.
-
Product
Gross Alpha/Beta Measurement Systems
-
Gross alpha/beta measurement is one of the simplest radioanalytical procedures which are applied widely as a screening technique in the field of radioecology, environmental monitoring and industrial applications. This procedure has been developed to determine whether radionuclide specific analysis is required to further characterize the water. Regular measurements of gross alpha and gross beta activity in water may be invaluable for early detection of radioactive contamination and indicate the need for supplemental data on concentrations of more hazardous radionuclides.
-
Product
MEMS Test System Development
-
olidus Technologies’ can design and build a test system customized for your exact needs, using our own or off the shelf components:Custom MEMS Test Systems. We can integrate and assemble test equipment and handling systems to fit your requirements. Custom MEMS Test Software. We can write custom software for device-specific calibration and testing, interfacing various instruments and handling systems, or create a customized GUI. We can also adapt our standard STI Test Software to work on your hardware system.
