Sensor Amplifiers
-
Product
Handset Power Amplifiers
-
Broadcom Handset Power Amplifiers support different operating modes (CDMA, UMTS, LTE, and GSM/EDGE) and multiple frequency bands offering premium performance in a very small form factor.
-
Product
Non-contact Displacement Sensors
-
This is a flexible sensor that can be installed anywhere and is equipped with high environmental resistance enabling use in harsh environments.
-
Product
CO₂ Sensor
STC31 (Qwiic)
-
Do you need to be able to sense CO2 concentrations of up to 100%? If so, the STC31 is the sensor for you! The Sensirion STC31 thermal conductivity sensor has two CO2 measurement ranges: 0 to 25 vol%; and 0 to 100 vol%. The measurement repeatability is 0.2 vol%, with a stability of 0.025 vol% / °C. The measurement accuracy depends on the measurement range: 0.5 vol% + 3% measured value; 1 vol% + 3% measured value.
-
Product
In-line Sensor & Auto Range Switching Concentration Monitor
HF-960EM
-
Measures a wide range of HF concentration from low concentration to undiluted liquid. The HF-960EM achieves high precision measurement by the auto-correction range switching function. Also has the capibility of cleanliness with all PFA sensors. Measurement range: 0 - 50%.
-
Product
Basic Quad J-Type Analog Thermocouple Amplifier
SEN-30103-J1
-
Analog thermocouple amplifier board based on the AD849x from Analog Devices (successor of the AD597). This quad-channel thermocouple board converts the very low voltage signal from a thermocouple to a highly-linear, 0.005V/C output with either 0V or 1.245V offset (both configurations stocked) while removing unwanted noise from the signal. Many supply and output configurations are available with this board, though the PCB was designed with Arduino in mind. Specifically, the output header will plug directly into a standard Arduino Uno or Mega, with a pin-for-pin match for power supply, ground and analog outputs. With a 5V Arduino, temperatures from 0C to 1,000C are possible with the 0V offset board and -249C to 750C with the 1.245V offset board. If using a 3.3V microcontroller (Due, etc), the board must be supplied with no more than 3.3V to avoid damaging the microcontroller. Temperature measurement range is dependent on the supply voltage. It is possible to supply the board with higher voltages to allow temperature measurement over the entire operating range of the K-Type and J-Type thermocouples, allowing use with more capable data acquisition equipment.
-
Product
Vision Sensors
-
Providing you the best range of Vision Sensor with effective & timely delivery.
-
Product
Versatile Sensor Network
-
Information System Technologies Inc.
ISTI offers a versatile, scalable and easy to use distributed sensor network solution for high fidelity data acquisition and development platform, allowing users/developers to test their signal processing and data fusion algorithms. The system supports multiple sensing types including acoustic, seismic and IR/scanning laser. Among the key capabilities of ISTI’s versatile sensor network are: (a) sensor-level hardware/software to provide configurable sampling and synchronization, on-board processing and storage for low to intermediate-level signal processing and data acquisition; (b) network-level solutions that account for network connectivity and sensor-network health monitoring and support various routing strategies; and (c) system-level console that allows users to select and upload application tasks. Users can choose several modes of operation to examine various factors such as reliability, bandwidth, and data timeliness.
-
Product
Cable Reel Sensors
-
AMETEK Sensors, Test & Calibration
Cable Reels can be used as a linear position sensor in any industrial application to monitor a linear or reciprocating machine motion. The system consists of a heavy duty spring motor assembly attached to a precision machined cable drum. As the cable is pulled off of the drum, the drum rotates a rotary position sensor.
-
Product
Microwave Power Amplifier 1/4 Watt, 2 GHz to 50 GHz
GT-1050B
-
The Spanawave/Giga-tronics GT-1050B Microwave Power Amplifier offers linear high-power amplification across multioctive bandwidths. Ideal for testing in EMC, wireless communications applications, and Defense EW systems.
-
Product
Dielectric/Conductivity Sensor
Quarto-VariconTM
-
The Quarto-Varicon sensor is a thin, flexible dielectric sensor designed for cost-sensitive use with presses, molds, bulk materials or laminates. Patterned on a polyimide substrate, the Quarto-Varicon sensor can be supplied without leads, or with custom-length Teflon-insulated leads attached.
-
-
Product
Optical Sensors
-
Analog Devices optical sensors are optical sensing front ends that include integrated ultra-low noise amplification and high performance photodiodes. These solutions are used to achieve the highest performance for instrumentation, industrial, or clinical applications; or to optimize a solution to achieve the lowest power dissipation at a given performance level for battery powered and portable applications.
-
Product
Hand Dynamometer Logger Sensor
NUL-237
-
This sensor comes with a hand held unit with a built in strain gauge. The sensor measures the pressing force on the hand held unit.
-
Product
C-Band DWDM Line Amplifier EDFA (WLA-C)
HWA4200 (With SNMP)
-
Hangzhou Huatai Optic Tech. Co., Ltd.
Huatai HWA4200 series, is designed for C-Band 44 waves or 88 waves DWDM system design Line Amplifier gain flatness. Products using the most excellent optical performance, the most advanced electronic control technology and comprehensive software features, has a wide operating wavelength range, Low noise, excellent gain flatness characteristics and transient characteristics.
-
Product
2D CMOS Image Sensor
Lince1M3
-
Lince1M3 is a CMOS digital image sensor optimized for applications (medical, ITS, industrial machine vision) requiring high-speed and high-resolution. The sensor incorporates a sophisticated readout channel with a high-accuracy 12-bit ADC to deliver the best quality images under any illumination condition.
-
Product
Through Hole Type AC Current Sensor
CTA-120A
-
MULTI MEASURING INSTRUMENTS Co., Ltd.
*For AC current and power measurements.*High accuracy and compact size.*Wide measuring range:AC 1A～120A.
-
Product
Saab Oxygen Sensor
KS60113 - Saab
-
Konstar Electric Industrial Co., Ltd
An oxygen sensor, also known as a lambda sensor, continually detects the oxygen content in the exhaust gases of an engine. The oxygen sensor output signal informs the vehicle's ECU (Electronic Control Unit) whether the AFR (Air-Fuel Ratio) is lean or rich. Based on this, the ECU adjusts the amount of fuel injected into the engine to achieve an optimal AFR.
-
Product
MAX31856 Thermocouple Sensor Arduino Shield
SEN-30007-K
-
Quad channel thermocouple Arduino shield based on the MAX31856 universal digital thermocouple interface IC. This is an exciting update of the MAX31855, with improvements in resolution (19 vs 14 bits), on-board temperature reference (6 vs 4 bits), and compensation (fully compensated vs nonlinear correction required). The MAX31856 is interfaced via 4-wire SPI with options for interrupt triggering. An LDO and a high-speed level shifter are included on ALL device pins to allow interfacing with to any Arduino - both 3.3V and 5.0V variants - without sacrificing device performance in any operating condition.
-
Product
Digital Temperature Sensors
-
ams’ portfolio of digital temperature sensors are the best combination of size, accuracy and current consumption for your design. They meet the highest quality standards to provide you with exceptional reliability over the lifetime of your product.
-
Product
Ultra High-speed・High-precision Laser Displacement Sensor
HL-C2
-
Panasonic Industrial Devices Sales Company of America
Combining Panasonic's accumulated know-how in measurement technology with the latest digital technology, Panasonic has created the versatile Laser Displacement Sensor HL-C2. The HL-C2 Sensor functions stably and consistently, even for extremely difficult applications such as measuring variations in HDD surfaces or sensing very shiny objects. By using Panasonic's unique new optical system, high density light-receiving cells and a cutting-edge sampling technology, a wider variety of objects can now be measured with greater precision, stability, and speed than ever before.
-
Product
Compact Size Picking Sensor
NA1-PK3
-
Panasonic Industrial Devices Sales Company of America
With an ultra-compact size of 24mm × 70mm × 8mm (W x H x D), the Panasonic NA1-PK3 Series General Purpose Area Sensors can be installed in bins designed to house small parts. Panasonic's unique beam scanning system reduces wiring and installation time while incorporating a mutual interference prevention function that provides correct operation even in multi-stage parts boxes.
-
Product
Seismic Sensor
SmartPhone D
-
Teledyne Marine Real Time Systems
The highly rugged encapsulated SmartPhone D was designed for use with the SmartSource controller, or SmartPhone D system, for real-time monitoring of near-field signatures.
-
Product
Vayyar sensors
-
Vayyar sensors look into objects using technology that breaks through known barriers and brings highly sophisticated imaging to your fingertips.
-
Product
Current Logger Sensor
NUL-202
-
This sensor can be used to measure the current in parallel or series branches of low voltage AC and DC circuits and also to investigate the dependence of the current flow through components on the voltage across them.
-
Product
Five Channel Amplifier
-
Teledyne RF & Micrrowave designed the Five Channel Amplifier specifically for a custom space application. Each independent channel used dedicated RF Input/Output and DC bias connections. Each channel's RF performance was tailored differently to meet the application requirements. All components were manufactured and screened per MIL-PRF-38534, Class K. Additionally, to meet mission requirements The top assembly was also tested for RF and DC parameters during MIL-STD-202 thermal cycling and random vibration environments. This effort required disciplined development, manufacturing and program management efforts to meet challenging mechanical and RF engineering requirements.
-
Product
Inductive Distance Sensors
AlphaProx
-
Distance measurements on metal objects with micrometer precision.
-
Product
High Pressure Sensors
-
Honeywell Industrial Automation
Honeywell Sensotec is among a handful of companies offering pressure sensors that can measure pressure up to 200,000 psi with superior accuracy and reliability. Foil based strain gauge technology enables our pressure sensors to withstand pressure that would destroy silicon based or micromachined pressure sensors.
-
Product
Panel-mounted Power Amplifier(Hardware In The Loop Testing)
PA60Bi
-
PA60Bi is the panel-mounted power amplifier, which can produce 3-phase current, with maximum RMS phase current of 60A and maximum output power of 800VA, and 4-phase voltage, with maximum RMS phase voltage of 120V and maximum output power of 60VA.
-
Product
Reference plus Comparator or Amplifier
-
Analog Devices reference plus comparator or amplifier products combine the excellent initial accuracy and low overtemperature drift performance of single function voltage references with comparators, buffer amplifiers, and current sense amplifiers. These products offer compact solutions for a broad range of applications such as battery monitoring, threshold detectors, window comparators, auto power-off circuits, and low dropout (LDO) regulators.
-
Product
MOSFETs For High Frequency Amplifier
-
The MOSFETs shown below are best suited for amplification of high-frequency signals.
