Product

Extensometers for Indirect Tensile Testing of Asphalt

Model 3911

-

Jinan Testing Equipment IE Corporation

Model 3911 - Jinan Testing Equipment IE Corporation

For indirect tensile testing, such as for resilient modulus, these extensometers measure the lateral deformation of specimens. They are self-supporting on the sample and clip on in seconds. The traditional way this deformation has been measured was prone to errors caused by slight rocking of the sample as it is loaded. The self-supporting design of the Model 3911 eliminates this problem. This unit will handle the dynamic pulse requirements of resilient modulus testing.The speed of mounting makes test set-up much faster than with the older method. The pivot mounting used ensures that the specimen contact pads meet the often uneven asphalt surface as well as possible. The measuring range options available allow a wide range of testing, yet can easily measure the sometimes very small displacements required.The Model 3911 extensometers are strain gaged devices, making them compatible with any electronics designed for strain gaged transducers. Most often they are connected to a test machine controller. The signal conditioning electronics for the extensometer is typically included with the test machine controller or may often be added. In this case the extensometer is shipped with the proper connector and wiring to plug directly into the electronics. For systems lacking the required electronics, Epsilon can provide a variety of solutions, allowing the extensometer output to be connected to data acquisition boards, chart recorders or other equipment.

Product

Annunciator

Series 90B

-

Ametek Power Instruments

Series 90B - Ametek Power Instruments

Dual independent communication ports (RS-232/485 and Ethernet) are available to transmit alarms to other devices. The Series 90B can receive alarms using communication ports, eliminating the need to connect digital inputs and associated wiring. The Series 90B supports Modbus, DNP and ASCII protocols.

Product

Cable Fault Meter

-

PCE Instruments

PCE Instruments

A cable fault meter can locate open power cables, either live or dead (without current), with voltages up to 300 V. A cable fault meter can locate cables, circuits, short circuits and ground wires. To perform these functions, it is not always necessary to disconnect electrically sensitive devices or to disconnect the power from the cable which is being tested. Many cable fault meter devices can also locate ferrous and non-ferrous metals, wood and plastic with high degrees of accuracy.

Product

Steady State Chamber

-

Burnsco Environmental Test Chambers

Burnsco Environmental Test Chambers

Swivel castors with brakesWelded series 304 stainless steel interior and exterior.Interior light and viewing windowNon-settling, high temperature, fiberglass insulation.Fast response, nichrome wire heating elements.

Product

Wiring Tester

WIZE

-

SPHEREA Test & Services

WIZE - SPHEREA Test & Services

The testers can be used both in production and maintenance, as WIZE® is suitable for simple wiring tests and complex interconnect tests for full systems. WIZE®’s specifications make it compatible with the standard requirements used for testing in the aeronautics, space, rail and defence sectors or any other industry using wiring.

Product

Servo Tester

105

-

Astro Flight Inc.

105 - Astro Flight Inc.

Simulates a receiver so you can test your motors and servos without having to use a transmitter and receiver. It can send RC-PWM signal of 1ms to 2 ms in 20ms period. It connects to an ESC via three wires. The servo tester is powered by the BEC in your speed control or by a std 4 cell 5 volt receiver battery

Product

VVDI Programmer

-

TOMSAD

TOMSAD

MC9S08 series secured and unsecured , MC68 HC series (9) 12 secured and unsecured, MC9S12 series secured and unsecuredV850 series, H8X series, R8C series, R5F series, PCF79XX, EEPROM SPI, I2C, & mu WIRE, PIC 12F, 16F, 18F, Infineon TRICORE, Infineon XC2xxxx, Infineon XC164CS, ST10F series, ST7 series, STM8 series, ATMEL- Atmega 8, 48, 16, 32, 64, 128, 256, MPC560 series, SPC560 series, Fujitsu MB91F

Product

Wall-Mounted Electronic Energy Meter

MWH-7W

-

Adtek

MWH-7W - Adtek

The MWH-7W series is an electronic energy meter with excellent performance, the main function is high-precision energy metering, the panel has LCD display, the energy value is clear and easy to read. The power meter provides functions such as pulse output and RS485 communication interface, which is convenient for the user to check or structure into a centralized meter reading system.Panel and wiring cover with lead seal, in accordance with CNS 14607 specification design.

Product

Ultra-slim Light Curtain [Type2 PLc SIL1]

SF2C

-

Panasonic Industrial Devices Sales Company of America

SF2C - Panasonic Industrial Devices Sales Company of America

The Ultra-Slim SF2C Light Curtains have a thickness of only 13.2mm, come in an ultra-light polycarbonate enclosure and features easy installation and reduced wiring. They are available as a hand protection type with a beam pitch of 20mm, allowing users to detect objects as small as 25mm in diameter. SF2C Light Curtains are delivered with a 3-meter cable and mounting brackets (MS-SFC-1).

Product

110-125V AC Receptacle Tester

1933

-

Peaceful Thriving Enterprise Co Ltd

1933 - Peaceful Thriving Enterprise Co Ltd

Test for 110-125V AC circuits.Detect faulty wiring in 3 wire receptacle.

Product

Multi Function Testers

-

Kyoritsu Electrical Instruments Works, Ltd.

Kyoritsu Electrical Instruments Works, Ltd.

Live circuit warning LED:Immediate illumination of a warning lamp if the circuit under test is live Auto Discharge:Allows fast and safe discharge of electrical energy stored in capacitive circuits following testing Integral overload protection on internal continuity and insulation test circuitry Autoranging 500V DC test voltage for insulation tests 200mA short circuit current on continuity ranges Loop and RCD Testing Wiring connection check LED''s:Immediate indication if wiring of circuit under test is correct Overheat Protection:Rapid detection of overheating of internal circuitry,display of warning signal to user and automatic halting of measurement Supply Voltage Indication:Can display supply voltage value in loop impedance mode Low Current Loop Impedance Test:Short duration low test current will prevent tripping of many passive RCDs

Product

Shore A Type Hardness Tester Rubber Hardness Tester

HS-A

-

Shenzhen Chuangxin Instruments Co., Ltd.

HS-A - Shenzhen Chuangxin Instruments Co., Ltd.

HS-A is a digital Shore A type hardness tester. It is suitable for plastic (such as film, medical appliance, etc.), synthetic rubber(such as seals, tires, rubber roller, rubber hose/belt, wire and cable, shock absorber, etc.) and other related chemical products.

Product

LXI Matrix Switching Unit

ProDAQ 6140

-

Bustec Ltd.

ProDAQ 6140 - Bustec Ltd.

The ProDAQ 6140 provides a relay matrix which can be fitted between the sensors and actuators on a device under test and the data acquisition and control system. It allows to separately connect/disconnect the signals from either side and to connect them to an internal bus. In this way signals can be routed via the bus to new destinations or the bus can be used to monitor or supply test signals. This allows calibrating and debugging the system without disconnecting and separating channels throughout the system wiring.

Product

Wireless Precision RTD Based Temperature Data Logger with LCD

RFRTDTemp2000A

-

MadgeTech, Inc

RFRTDTemp2000A - MadgeTech, Inc

The RFRTDTemp2000A is an RTD-based, wireless temperature data logger with display. This data logger is ideal for applications that require high accuracy temperature monitoring such as within laboratories, pharmaceutical and biotech industries. The RFRTDTemp2000A accepts 2, 3 or 4 wire 100Ω platinum RTD’s and features a device accuracy of +/-0.5°C.

Product

Acute High Voltage Differential Probe, 50x/500x, 25MHz, 3500V

ADP5025

-

TEAM SOLUTIONS, INC.

ADP5025 - TEAM SOLUTIONS, INC.

*USB Powered (or Power Bank)*Bandwidth up to 25 MHz*Overrange Indicator*Audible Overrange Alarm*Bandwidth Limit : 5 MHz / Full*Can be used by any DSO which has the USB port(s).*EC Declaration: EN 61010-031:2002 +A1:2008*Double-layer wire for power insulation

Product

Plugbord

4112-4

-

VECTOR Electronics and Technology, Inc.

4112-4 - VECTOR Electronics and Technology, Inc.

44 Gold plated edge contacts (22 each side) on 0.156"(3.96mm) centers.​ 3-hole solder pads (0.28” x 0.080”) for interconnecting multiple component leads. Zig-Zag Bus Pattern on wiring side.Zig-Zag Bus Pattern provides access to voltage or ground at alternating hole positions. Continuous ground plane on component side with 0.085” etched clearance area around each hole Row and column legends provided

Product

Ethernet Speed Certifier & Network Tester

-

Platinum Tools

Platinum Tools

Offers a complete solution to test and speed certify the data-carrying capabilities of Ethernet network cables up to 1 Gb/s by testing for noise in the network, detecting faults in the cable wiring, and ensuring that cables are able to support the speed capabilities of active equipment.

Product

DB25 DIN-Rail Wiring Board

ADAM-3925

-

Advantech Co. Ltd.

ADAM-3925 - Advantech Co. Ltd.

Low cost universal DIN-rail mounting screw terminal module for PC-LabCard products with DB25 connectorScrew-clamp terminal blocks allow easy and reliable connectionsCase dimensions (W x L x H): 77.5 x 56.3 x 51 mm (3.1" x 2.2" x 2.0")To Be Used With PCI-1757UP, PCL-833

Product

Cable Tracing

-

Platinum Tools

Platinum Tools

High-power tone generator enables signal detection over 20 miles away and makes tracing through walls and enclosures easier with multiple tones and power levels suited for network, signal wire, coax, and telephone cable applications.

Product

High Voltage Cable/Harness Test System

CKT1175-50

-

CK Technologies, Inc.

CKT1175-50 - CK Technologies, Inc.

The CKT1175-50 is a high-voltage wiring analysis system that features a switching matrix that can be distributed around the workshop or in and around the assembly to be tested. This system is expandable in 100 or 150 test point increments to 96,000 test points, and is available with a variety of adapter cable interface connectors, with the standard being the CKT MAC interface system