Wireless Data Loggers
Transmit logged data using RF.
See Also: Loggers, Pressure Loggers, Current Loggers, Dataloggers, Humidity Loggers, Temperature Humidity Loggers, Temperature Loggers, Voltage Loggers, Wireless Loggers, Data Loggers
-
Product
Sensors - Stand-Alone Loggers
-
Makes it possible to measure and record the transport conditions of goods and to trace shocks as well as temperature variations.
-
Product
Network & Data Solutions
-
IDM Technology is the core technology solution set that provides users in severe environments with a means of routing and processing data over internet protocol (IP) based or point-to-point networks using existing, and primarily voice-grade radios.
-
Product
Measurement Data Management
-
Top-selling Supported software for visualization of quality. Measurement Data Network SystemMeasurLink
-
Product
Data Line Analyzer
ELA 10
-
20 Hz to 20 kHz selective/wideband Level Meter & Generator, with Spectrum Analyser, and phone symulator dialer.
-
Product
Wireless Network Penetration Testing
-
LGMS wireless network penetration testing uses automated and manual penetration techniques to locate and map authorized and unauthorized wireless access points, review corporate access point configuration and then discover weaknesses that could allow an attacker to penetrate those networks. Potential internal and external threats are documented, and a recommended action plan is developed to address any security risks.
-
Product
Data Acquisition & Control Systems
-
Ensuring you make the most of your testing equipment, SuperFlow offers a variety of dynamometer data acquisition and dynamometer control packages for your Engine, Chassis or Transmission dynamometer application. Contact SuperFlow to discuss which instrumentation system and related accessories are right for you, and turn your testing challenges into success.
-
Product
Wireless Connectivity 4 in 1 Digital Multi Detector with moisture measurement
MS-W68(11B)
-
External wireless connectivity 4 in 1 Digital Multi Detector can detect live wires and metal pipe / conduit in walls and wooden stud in drywalls, with audible and numerical display on LCD.
-
Product
Flow Logger Sensor
NUL-224
-
This sensor allows for a stream of water to flow through its inlet and outlet pipes, thus revolving a rotation wheel within it. The wheel is not connected mechanically to anything else, but rather floats on a bearing for minimum friction and the enhancement of its minute accuracy. The measuring is done by monitoring changes in the sensor's surrounding magnetic field.
-
Product
Nitrate Logger Sensor
NUL-241
-
The NeuLog nitrate sensor can be used to measure the concentration of nitrate ions (NO3-) in aqueous samples.Nitrates are used in fertilizers and can contaminate water. Also, untreated human sewage can be a source of nitrate contamination.Nitrate measurements can also be very relevant to study the nitrogen cycle in general and to relate this cycle to plants and algae.
-
Product
STDF Test Data Analysis Tool
DataView
-
DataView is a low‐cost test data analysis tool that is used by test and product engineers to perform characterization of integrated circuit devices. DataView reads in industry standard STDF or ATDF files and can produce reports, histograms, and wafer maps in multiple formats including Excel. DataView is ideal for the test or product engineer who needs a fast and simple tool to analyze characterization data.
-
Product
1-port CAN Bus Data Logger
CAN-Logger100
-
The CAN-Logger100 is a high-performance smart CAN bus data logger with one CAN port that can help collect data and process on a CAN bus network easier and quicker. The powerful CPU of the CAN-Logger devices provide the accurately time-stamp for each CAN message and support storage media like SD card or SDHC type flash to save CAN messages, which helps users easily analyze and diagnose the CAN Bus network. Providing great portability, the CAN-Logger100 is powered by USB interface or M12 connectors of CAN bus interface. The CAN-Logger100 device uses the standard USB HID driver of the Windows system.
-
Product
Low Temperature Remote Probe Logger
TREL-8
-
TREL-8 is easily configured for recording conditions including delayed start, sampling interval, number of readings and configuration of conditions to activate the ALERT indicator. Readings are downloaded using LogTag® Analyzer which provides facilities for charting, zooming, listing data statistics and allows exporting the data to other applications such as Excel.
-
Product
PXIe SSD Storage Unit
DM-4M.2-3U
-
The Big River™ DM-4M.2-3U PXI Express storage unit provides up to 3.8TB* of M.2 SSD storage capacity. With a PCIe x8 Gen3 host interface, the DM-4M.2 delivers high-speed data rates for sequential writes of 3.25GB/s** and sequential reads of 3.41GB/s** to PXI Express based systems. The single slot design of the DM-4M.2 increases the availability of valuable chassis space, allows for maximum storage flexibility. The DM-4M.2 complies with PCIe Gen3 protocol standards. The product is commonly used in the industrial control, test and measurement fields. The DM-4M.2 operates under Windows, Linux, Unix, Solaris and VxWorks.
-
Product
Power Analyzers - Meters - Loggers
-
Full line of power and power quality analyzers, loggers and meters including for extending measurement ranges. The wide range of applications include electrical monitoring, harmonic detection & analysis, utility testing, energy management, power factor analysis and correction, power demand and consumption, kW measurement, industrial power systems, and commercial maintenance.
-
-
Product
Fanless Data Extractor With Intel® Celeron® Processor N3160, 4 USB, 2 GbE LANs, VGA And PS/2 Inputs & Outputs
IPS810-853-FL
-
*Built-in frame grabber and utilizes OCR to collect and process legacy content of equipment*Non-intrusive feature to reduce equipment downtime and update costs*Unifies legacy equipment protocols into a standard via VGA interface*AX-RCS software supported, no-additional program installation required to speed up deployment*Ideal solution to enhance IoT functionality for existing legacy machines*-20 °C to +60°C operating temperature range
-
Product
PCI Data Acquisition Boards
AD8S-100DMA Series - Single low-spur 8-bit, 100 Ms/s
-
Model AD8S-100DMA is similar to the AD8-100DMA, has a single low-noise eight-bit 100MSPS A/D converter and can acquire up to 100 MS/s on a single channel into the host system's RAM. Drivers for 64 bit Linux and Solaris operating systems included.
-
Product
Data Acquisition Systems
-
Encore Electronics manufactures a wide range of analog signal conditioning equipment, including strain gage and pressure amplifiers, frequency-to-voltage converters, thermocouple isolation amplifiers and anti-aliasing filters.
-
Product
PC/104-Based Data Acquisition (DAQ) And Control Products
-
A small form factor embedded computer board, typically intended for use in small, space-constrained industrial control or vehicles systems. The standard size of these modules is just 3.550 × 3.775 inches (90 × 96 mm). The name PC/104 comes from the original IBM computer known as the "PC", and the number of pins used to connect the cards together (104). PC/104 boards are typically stacked on top of each other using stackable bus connectors and four mounting holes at the corner of each module. This provides a much more rugged, embedded computer that can be used in harsh environments such as those found in military or industrial applications.
-
Product
Multifunctional Data Acquisition Systems
MS1201
-
This system used for multi-purpose applications such as data acquisition and Automatic Test Equipment. ATE Computer has ISA Bus based eleven slots with inbuilt power supply. Micro Processor board or USB Controller is used to drive the back plane.
-
Product
Data Logging and Analysis With Tecap
-
Tecap provides such a tool for simple online overview. This tool is useful to analyse the stability of the developed test program. It is easily to recognize if the program shows the expected repetitive accuracy.
-
Product
Wireless Connectivity 4 in 1 Multifunction Metal Detector
MS-B158(4)4
-
Bluetooth with Memory Integrated Wireless Connectivity 4 in 1 Multifunction Metal Detector
-
Product
NITOS Wireless Sensor Platform
-
The NITOS prototype wireless sensor mote, is comprised of open-source and configurable modules. NITOS mote features the ATmega32u4 microcontroller running at 8MHz and operating at 3.3V. The aforementioned microcontroller is fully compatible with the Arduino platform that enables ease of software development and provides compatibility with several commercial sensing modules. Moreover, the platform is equipped with an Xbee radio interface that enables communication with the respective gateway. The Xbee module is a tiny device ideal for setting up mesh networks and has a defined rate of 250 kbps. This module uses the IEEE 802.15.4 stack which is the basis for theZigbee protocol. Apart from the Xbee module, NITOS mote can also feature a WiFi wireless interface in order to communicate with WiFi gateways. The developed mote currently features specific sensing modules, an air temperature and humidity sensor, a light intensity sensor and a human presencesensor. Various types of sensing modules and actuators can be further integrated exploiting existing Arduino software that implements several existing communications protocols. The firmware can be easily uploaded through the on-board USB connection. Figure 1 illustrates the developed NITOS mote and the respective gateway node.
-
Product
Wireless Gateways
-
Networked Communication Solutions, LLC
Allows your NCS wireless sensors to communicate with the NCS Online Wireless Sensor Monitoring and Notification System.
-
Product
Pulse Instruments Data Acquisition and Test Software
PI-DATS
-
PI-DATS is Pulse Instruments Data Acquisition and Test Software, our user-friendly system software that allows complete control over Pulse Instruments test systems and test equipment. PI-DATS can dramatically increase your testing productivity by decreasing the amount of time it takes to set up and change test plans.
-
-
Product
Rapid PSE And Chained Data Test Of 4-Pair And 2-Pair PSE's
PSL-3424 Quick Test for 802.at and 802.3bt PSE's
-
Accessible from PSA Interactive or PowerShell PSA. Scans 2 to 8 PSE ports per test cycle. Automatically determines and adapts to PSE maximum assigned class. Tests PSE’s that grant full power via PD Classification or through PoE LLDP. Validates PoE Detection Acceptance and Rejection Range. Measures PSE Port Voltage at both minimum (DC MPS) and maximum (Pclass) load conditions. Reports PSE type (AT vs BT), maximum assigned class capability, and Pclass power capacity. Assesses Disconnect Power Removal response. Assesses Overload Power Removal response. Assesses LLDP Power Protocol and Allocations (PSL-3424L).
-
Product
IQ Data Bandwidth Up To 1.5 GHz
S93050B
-
Make multiple measurements of active device distortion analysis with a single connection to a PNA family network analyzer utilizing the industry-standard PathWave 89600 VSA (VSA) software for 5G transmitter test. The VSA IQ data link feature in S93050B allows you to send IQ data from the PNA to the VSA software and analyze symbol EVM, AM-AM, and AM-PM.
-
Product
Data Recording System
Director DII - DFR DDR
-
Using the Microsoft Windows 10® operating system, DII features complete Transient and Long-Term Phasor Data Recording, Analysis, and Transmission. E-MAX DII has a maximum capacity of 128 Analog and 256 Digital directly connected channels.
-
Product
Data Acquisition Card
TPCE
-
The Elsys TPCE data acquisition (DAQ) cards are high-precision and high-resolution digitizers with sophisticated features such as advanced trigger mode, continuous data acquisition mode, differential inputs, digital input lines (Markers) and ICP coupling for powering piezo sensors.
