Product

AC Power Supply

FC5003

-

Behlman Electronics Inc.

FC5003 - Behlman Electronics Inc.

Behlman’s FC5003 is a ruggedly built, COTS frequency converter designed to convert 120/208 VAC, 3-phase, 60 Hz, ground power to 115/200 VAC, 3-phase, 400 Hz, aircraft power. The FC5003 is in a rugged 6U (10.5”H) 19 inch rack mount chassis with an input line cord with plug and an output receptacle.

Product

Fine Pitch Test Probes

-

Equiptest Engineering Pte Ltd

Equiptest Engineering Pte Ltd

Micro probes allow very fine pitch testing ranging from 0.13mm to 0.35mm pitchLow Resistance, Low inductance, High FrequencyWide selection of plating options to optimize contact challenges and maximize probe lifeTri-temp applications – 55°C to 155°C

Product

AC Reference Generators

SR22

-

Computer Conversions Corporation

SR22 - Computer Conversions Corporation

The SR Series are miniature, low cost AC reference generators designed to supply 26 or 115 volt excitation to synchros or resolvers in military and industrial control applications. They accept +/-15V DC and provide up to 5VA of transformer isolated output power. These converters are packaged in PC card mounting modules 2.6”x3.1”x1”H

Product

T, RH, Pressure and Air Speed Transmitters

HD2001… Series

-

Senseca

HD2001… Series - Senseca

Relative Humidity, temperature, barometric pressure, air speed trasmitters with display

Product

19" Drawer with Writing Surface, Unshielded, 10.5"H x 20"D

DR-101920-S

-

ELMA Electronic, Inc.

DR-101920-S - ELMA Electronic, Inc.

Unshielded drawers with writing surface are constructed of 20 ga. CRS and are furnished with ball bearing chassis slides to provide smooth operation. Available for 19" and 24" rackmount in 20", 24" and 30" depths, with or without a keylock

Product

Optical Fiber Type Hot Phosphoric Acid Concentration Monitor

CS-620F

-

HORIBA, Ltd.

CS-620F - HORIBA, Ltd.

In 3D NAND manufacturing process, dozens of layers of SiO2 and SiN are deposited, and the SiN layer is selectively removed using hot phos.In this process, the desired etching rate can be achieved by controlling the concentration and temperature of the chemical solution.Previous products have difficulty to measure high temperature chemicals, but the CS-620F is able to measure at high temperatures up to 170 C degrees.

Product

Bias Tee's

-

JYEBAO Co., Ltd.

JYEBAO Co., Ltd.

A bias "T" consists of a feed inductor to deliver DC to a connector on the device side and a blocking capacitor to keep DC from passing through to the receiver.

Product

Smoke Detection Sensor - CE Approved

ENVIROMUX-SDS-CE

-

Network Technologies Inc

ENVIROMUX-SDS-CE - Network Technologies Inc

For warning of smoke. Photoelectric smoke detector. Smoke sensitivity: 0.08-0.14 dB/m. Built-in 135° F (57° C) thermal heat sensor. Includes mounting hardware. Connect to RJ45 or digital input sensor ports. Supports CAT5/5e/6 UTP or STP cables. Screw terminal. To connect to the RJ45 inputs use CAT5/5e/6 cable terminated at one end with RJ45 connector. Connect the un-terminated end to the sensor screw terminal. Operating temperature: 14 to 122°F (-10 to 50°C). Maximum cable length: 1,000 ft (305 m). Powered by ENVIROMUX-2D/5D/16D. Regulatory approvals: CE, RoHS.

Product

Low Noise Amplifiers

-

Teledyne RF & Microwave

Teledyne RF & Microwave

Our range of ITAR Free, Low Noise Amplifiers (LNAs) cover a wide range of applications but are primarily suited to communication systems including both Data-Link and Satellite Communications (Satcom) systems. Our new K-Band LNA operates over a 19.2 - 21.2 GHz with 1.3 dB Noise Figure at 25°C. It is configured with a waveguide input and 2.92 output connector all in a hermetic package.

Product

AdvintRIO™ Reconfigurable I/O

PIRANHA

-

ADVINT, LLC

PIRANHA - ADVINT, LLC

The Piranha platform employs a NI single board RIO (sbRIO), NI C Series I/O modules, and custom circuitry. Piranha systems are not dependent on a separate host computer. They offer both Ethernet, and Wi-Fi connectivity to a powerful real-time controller and high performance field-programmable gate array (FPGA) and up to two (2) C Series I/O modules. It provides stand-alone embedded execution for deterministic LabVIEW Real-Time applications. These controllers are designed for ruggedness, reliability, and low power consumption. The heart of Piranha system is the reconfigurable I/O (RIO) FPGA core. The RIO core has an individual connection to each I/O module and is programmed using easy to use elemental I/O functions to read or write signal information from each module. Multiple units can also be daisy changed together for larger applications.

Product

DC/DC Converter 2 W

REM2-3.312D

-

ELMA Electronic, Inc.

REM2-3.312D - ELMA Electronic, Inc.

DC/DC converter 2 W from Recom | input ranges 3 - 3.6 VDC | outputs +/-12 V | operates in ambient temperature from -40 to +95 °C

Product

Test Contactor/Probe Head

cBoa

-

Cohu, Inc.

cBoa - Cohu, Inc.

cBoa™ test contactors and probe heads are the solutions for contacting high-frequency devices for package test or final test at wafer. The robust design and materials of the cBoa probe withstand the rigors of high-volume test by providing longer life and higher yield. The homogeneous DUT side plunger provides longer run times between cleaning and increased probe life.The cBoa features a stainless-steel spring for tri-temp testing and performs in operating temperatures of -55°C to +155°C and bandwidth of up to 35 GHz @ -1 dB.

Product

Isolation Amplifiers

-

Analog Devices Inc.

Analog Devices Inc.

Isolation Amplifiers provide power supply designers with a higher performing, single chip alternative to isolation techniques based on optocouplers and shunt regulators. Analog Devices ADuM3190 and ADuM4190 isolated error amplifiers have a 400 kHz bandwidth, with 0.5% typical initial accuracy at 25°C and 1% total accuracy over the extended temperature range of –40˚C to +125˚C. This provides manufacturers of ac-to-dc and dc-to-dc power supplies with a significant upgrade in speed and operating temperature range, as well as a 5× improvement in transient response.

Product

UV Fluorescence Sulfur Dioxide Analyzer​

Model T100

-

Teledyne Monitor Labs

Model T100 - Teledyne Monitor Labs

The Model T100 uses the proven UV fluorescence principle, coupled with a state of the art user interface to provide easy, accurate, and dependable measurements of low level SO2.Exceptional stability is achieved with the use of an optical shutter to compensate for PMT drift and a reference detector to correct for changes in UV lamp intensity. A hydrocarbon ‘kicker’ and advanced optical design combine to prevent inaccuracies due to interferents.All T Series instruments offer an advanced color display, capacitive touch screen, intuitive user interface, flexible I/O, and built-in data acquisition capability. All instrument set up, control and access to stored data and diagnostic information is available through the front panel using NumaView™ Software, or via RS232, Ethernet, or USB com ports, either locally or by remote connection using the included NumaView™ Remote PC Software. NumaView™ Remote PC Software allows for a remote connection with virtual interface and data downloading capability to analyzers operating NumaView™ Software.The Model T100 comes with NumaView ™ Software. NumaView™ Remote PC Software allows for a remote connection with virtual interface and data downloading capability to analyzers operating NumaView ™ Software. ​

Product

Intelligent Interface Card

IIB-1553-MMA

-

Western Avionics Ltd.

IIB-1553-MMA - Western Avionics Ltd.

The IIB-1553-MMA is an intelligent interface card providing full MIL-STD-1553 test, simulation and bus analysis capability for the M-Module standard, with 1553A, 1553B, McAir and STANAG 3838 variants in one card. The IIB-1553-MMA supports concurrent Bus Controller (BC) and up to 31 Remote Terminals (RT) with Bus Monitor (BM). An additional stand-alone Chronological Bus Monitor (CBM) facility is also provided, withcomprehensive multi-level triggering capability. Full error injection capability is provided in BC and RT modes, with full error detection in BC, RT, BM and CBM modes. The unit provides a dual redundant 1553 interface. 2 Mbytes of dual ported RAM are provided. The board is supplied with C drivers in source code and Windows menu driven software as standard.

Product

Hygrometer

-

DeltaTRAK

DeltaTRAK

Internal temperature and humidity sensorsExternal temperature probeFreeze alert°C/°F selectableJumbo display for temperature and humidityMin/Max memory - lowest and highest readings stored for instant recallLow Battery Indication

Product

Sound Level Calibrator

521

-

ACO Pacific, Inc.

521 - ACO Pacific, Inc.

Accepted internationally 1 kHz represents the "0 dB" reference point of A, B, C Weighting and other filters utilized in acoustic measurement. The Pistonphone - a mechanical sound source - offers a slightly higher degree of accuracy at a substantial increase in cost. In addition, the 200 or 250 Hz operating frequency is mechanically limited and not suited for measurements of filtered inputs. The 0.2 dB accuracy is quickly lost in the 0.7 to 1.5 dB tolerances acceptable for weighting filters at frequencies around 250 Hz.

Product

24" Rackmount Drawer, Unshielded, 5.25"H x 24"D

DR-052424-S

-

ELMA Electronic, Inc.

DR-052424-S - ELMA Electronic, Inc.

Unshielded drawers with writing surface are constructed of 20 ga. CRS and are furnished with ball bearing chassis slides to provide smooth operation. Available for 19" and 24" rackmount in 20", 24" and 30" depths, with or without a keylock

Product

CTEL 6U 4 slot with ATX, P1P2P4s, P3P5l, RoHS

104CTEL604-4146

-

ELMA Electronic, Inc.

104CTEL604-4146 - ELMA Electronic, Inc.

CompactPCI CTEL 6U 4 slot with system slot left, H110 bus, ATX connector, fully compliant to the PICMG basic specification 2.0 R3.0, Hot Swap specification 2.1 R1, andv PICMG H.110 Computer Telephony specification 2.5 R1.0.

Product

Large CMMs

-

Carl Zeiss AG

Carl Zeiss AG

In the aerospace industry, in vehicle and mechanical engineering as well as in many other fields, coordinate measuring machines with a large measuring range are required so that there is no need to compromise when it comes to precision. This is why ZEISS offers a wide range of tabletop, bridge-type and gantry coordinate measuring machines in various sizes. Large coordinate measuring offered by ZEISS include ZEISS ACCURA and the entire ZEISS MMZ product family (MMZ T, MMZ M, MMZ G).

Product

Nitrogen Compound Instruments

-

Teledyne Advanced Pollution Instrumentation

Teledyne Advanced Pollution Instrumentation

Teledyne API produces a wide range of instruments for the measurement of Nitrogen compounds, including those that measure 'True NO2'. All T Series instruments offer two front-panel USB ports, an advanced touch screen full color display, customizable user interface with predictive maintenance alerts, one-touch real-time graphing, and multiple language support. All of our instruments are designed meet the rigorous demands of ambient air quality, stack, or industrial process gas monitoring

Product

Wireless Device Testing Software

-

Rohde & Schwarz GmbH & Co. KG

Rohde & Schwarz GmbH & Co. KG

Get the most out of your mobile networks and devices. Our comprehensive portfolio of wireless testing equipment is designed to address even the most complex measurement requirements.The multistandard, modular and highly flexible, one-box wireless communication test solutions from Rohde & Schwarz support all main cellular communications, wireless connectivity, GNSS and broadband standards.Featuring high-speed, high-precision and exceptional flexibility, our leading-edge solutions can easily be extended to cover the latest standard enhancements. Benefit from our decades-long excellence in the T&M industry – Rohde & Schwarz is the right partner to fulfil your test requirements.

Product

CT Series Infrared Thermometer

-

Optris GmbH

Optris GmbH

The pyrometers of the optris CT series are equipped with one of the world’s smallest infrared sensing head with a high optical resolution of up to 75:1. The separate control box offers a high variability due to selectable analog outputs as well as several digital interfaces. The CT sensors have unique advantages for the installation in applications with high surrounding temperatures, such as within the metal, ceramics or glass industry. The robust and ambitious design allows the sensing heads to be used for temperatures up to 250°C without additional cooling. This advantage helps to reduce the costs for mechanical installations. The variety of different available spectral ranges makes the CT the ideal sensor for manifold application fields.

Product

MT Range Broadband Power Amplifiers 80 MHZ - 1000 MHZ

MT Series

-

PRANA

MT Series - PRANA

Class A solid stateBroadband (instantaneous single band): 80 MHz 1000 MHzTypical output power : 100 W CWLinear output power (1 dB compression) guaranted with harmonics <-20dBc:P1dB > 100 W and H < -20 dBc up to 450 MHz andP1dB > 65 W and H < -20 dBc from 450 MHz to 1000 MHzAir cooling: self contained fansCan operate in full mismatch conditions without damageUpgradable to MT 200 possibleReliable, efficient and robust19" Rack3 years standard warranty